More Like this

1. The bismuth tetramer Bi ₄ : the ν ₃ key to experimental observation

   https://doi.org/10.1039/C8CP03529F  

   Lahm, Mitchell E.; Hoobler, Preston R.; Turney, Justin M.; Peterson, Kirk A.; Schaefer, Henry F. (January 2018, Physical Chemistry Chemical Physics)

   The spectroscopic identification of Bi 4 has been very elusive. Two constitutional Bi 4 isomers of T d and C 2v symmetry are investigated and each is found to be a local energetic minimum. The optimized geometries and vibrational frequencies of these two isomers are obtained at the CCSD(T)/cc-pVQZ-PP level of theory, utilizing the Stoll, Metz, and Dolg 60-electron effective core potential. The fundamental frequencies of the T d isomer are obtained at the same level of theory. The focal point analysis method, from a maximum basis set of cc-pV5Z-PP, and proceeding to a maximum correlation method of CCSDTQ, was employed to determine the dissociation energy of Bi 4 ( T d ) into two Bi 2 and the adiabatic energy difference between the C 2v and T d isomers of Bi 4 . These quantities are predicted to be +65 kcal mol −1 and +39 kcal mol −1 , respectively. Two electron vertical excitation energies between the T d and C 2v electronic configurations are computed to be 156 kcal mol −1 for the T d isomer and 9 kcal mol −1 for the C 2v isomer. The most probable approach to laboratory spectroscopic identification of Bi 4 is via an infrared spectrum. The predicted fundamentals (cm −1 ) with harmonic IR intensities in parentheses (km mol −1 ) are 94(0), 123(0.23), and 167(0) for the T d isomer. The moderate IR intensity for the only allowed fundamental may explain why Bi 4 has yet to be observed. Through natural bond orbital analysis, the C 2v isomer of Bi 4 was discovered to exhibit “long-bonding” between the furthest apart ‘wing’ atoms. This long-bonding is postulated to be facilitated by the σ-bonding orbital between the ‘spine’ atoms of the C 2v isomer. 

   more » « less
2. The CLAS12 Spectrometer at Jefferson Laboratory

   lV.D.Burkert, L.Elouadrhiri (February 2020, Nuclear instruments methods n physics research)

   Abstract The CEBAF Large Acceptance Spectrometer for operation at 12 GeV beam energy (CLAS12) in Hall B at Jefferson Laboratory is used to study electro-induced nuclear and hadronic reactions. This spectrometer provides efficient detection of charged and neutral particles over a large fraction of the full solid angle. CLAS12 has been part of the energy-doubling project of Jefferson Lab’s Continuous Electron Beam Accelerator Facility, funded by the United States Department of Energy. An international collaboration of 48 institutions contributed to the design and construction of detector hardware, developed the software packages for the simulation of complex event patterns, and commissioned the detector systems. CLAS12 is based on a dual-magnet system with a superconducting torus magnet that provides a largely azimuthal field distribution that covers the forward polar angle range up to 35 , and a solenoid magnet and detector covering the polar angles from 35° to 125° with full azimuthal coverage. Trajectory reconstruction in the forward direction using drift chambers and in the central direction using a vertex tracker results in momentum resolutions of 1% and 3%, respectively. Cherenkov counters, time-of-flight scintillators, and electromagnetic calorimeters provide good particle identification. Fast triggering and high data-acquisition rates allow operation at a luminosity of cm−2s−1. These capabilities are being used in a broad program to study the structure and interactions of nucleons, nuclei, and mesons, using polarized and unpolarized electron beams and targets for beam energies up to 11 GeV. This paper gives a general description of the design, construction, and performance of CLAS12. 

   more » « less
3. Development of the CMS detector for the CERN LHC Run 3

   https://doi.org/10.1088/1748-0221/19/05/P05064  

   Hayrapetyan, A; Tumasyan, A; Adam, W; Andrejkovic, JW; Arnold, B; Bergauer, H; Bergauer, T; Chatterjee, S; Damanakis, K; Dragicevic, M; et al (May 2024, Journal of Instrumentation)

   Abstract Since the initial data taking of the CERN LHC, the CMS experiment has undergone substantial upgrades and improvements. This paper discusses the CMS detector as it is configured for the third data-taking period of the CERN LHC, Run 3, which started in 2022. The entire silicon pixel tracking detector was replaced. A new powering system for the superconducting solenoid was installed. The electronics of the hadron calorimeter was upgraded. All the muon electronic systems were upgraded, and new muon detector stations were added, including a gas electron multiplier detector. The precision proton spectrometer was upgraded. The dedicated luminosity detectors and the beam loss monitor were refurbished. Substantial improvements to the trigger, data acquisition, software, and computing systems were also implemented, including a new hybrid CPU/GPU farm for the high-level trigger. 

   more » « less
4. Precision Measurement of the Beam-Normal Single-Spin Asymmetry in Forward-Angle Elastic Electron-Proton Scattering

   https://doi.org/10.1103/PhysRevLett.125.112502  

   Androic, D.; Armstrong, D.S.; Asaturyan, A; Bartlett, K.; Beaufait, J.; Beminiwattha, R.S.; Benesch, J.; Benmokhtar, F.; Birchall, J.; Carlini, R.D.; et al (September 2020, Physical review letters)

   A beam-normal single-spin asymmetry generated in the scattering of transversely polarized electrons from unpolarized nucleons is an observable related to the imaginary part of the two-photon exchange process. We report a 2% precision measurement of the beam-normal single-spin asymmetry in elastic electron-proton scattering with a mean scattering angle of θlab=7.9° and a mean energy of 1.149 GeV. The asymmetry result is Bn=−5.194±0.067(stat)±0.082 (syst) ppm. This is the most precise measurement of this quantity available to date and therefore provides a stringent test of two-photon exchange models at far-forward scattering angles (θlab→0) where they should be most reliable. 

   more » « less
5. A new method for measuring the neutron lifetime using an in situ neutron detector

   https://doi.org/10.1063/1.4983578  

   Morris, C_L; Adamek, E_R; Broussard, L_J; Callahan, N_B; Clayton, S_M; Cude-Woods, C.; Currie, S_A; Ding, X.; Fox, W.; Hickerson, K_P; et al (May 2017, Review of Scientific Instruments)

   In this paper, we describe a new method for measuring surviving neutrons in neutron lifetime measurements using bottled ultracold neutrons (UCN), which provides better characterization of systematic uncertainties and enables higher precision than previous measurement techniques. An active detector that can be lowered into the trap has been used to measure the neutron distribution as a function of height and measure the influence of marginally trapped UCN on the neutron lifetime measurement. In addition, measurements have demonstrated phase-space evolution and its effect on the lifetime measurement. 

   more » « less