Abstract As a major nominally anhydrous mineral (NAM) in the Earth’s upper mantle, orthopyroxene could host up to several hundred parts per million H2O in its crystal structure and transport the H2O to the deep Earth. To study the effect of structural H2O on the elasticity of orthopyroxene, we have measured the single-crystal elasticity of Mg1.991Al0.065Si1.951O6 with 842–900 ppm H2O and 1.64 ± 0.20 wt% Al2O3 at ambient conditions using Brillouin spectroscopy. The best-fit single-crystal elastic moduli (Cijs), bulk (KS0), and shear (G0) modulus of the hydrous Al-bearing orthopyroxene were determined as: C11 = 235(2) GPa, C22 = 173(2) GPa, C33 = 222(2) GPa, C44 = 86(1) GPa, C55 = 82(1) GPa, C66 = 82(1) GPa, C12 = 75(3) GPa, C13 = 67(2) GPa, and C23 = 49(2) GPa, KS0 = 111(2) GPa, and G0 = 78(1) GPa. Systematic analysis based on the results presented in this and previous studies suggests that the incorporation of 842–900 ppm H2O would increase C13 by 12.0(7)% and decrease C23 by 8.6(8)%. The effects on C11, C22, C33, C44, C66, KS0, and VP are subtle if not negligible when considering the uncertainties. The C55, C12, G0, and VS are not affected by the presence of structural H2O. Although laboratory experiments show that Fe,Al-bearing orthopyroxenes can host up to 0.8 wt% H2O in its structure, future high-pressure-temperature elasticity measurements on orthopyroxene with higher H2O content are needed to help better quantify this effect.
more »
« less
Compressional Behavior of Hydrous Orthoenstatite: Insight into the Nature of LVZ under Continental Plate
A suite of hydrous orthoenstatite crystals were synthesized at 5–7 GPa and 1100–1300 °C, corresponding to the mid upper mantle conditions in continental regions. The synthetic crystals presented a clear, inclusion-free, and euhedral form with a size range from 100 to a few hundred microns. The Al- and water content of crystals were less than 2 wt. % and ranging from ~500 ppm to 1000 ppm, respectively, characterized by Raman and IR spectroscopy, electron microscopy, and SIMS. The analysis shows that the capability of water incorporation for this suite of hydrous orthoenstatite is correlated to the Al-content in the crystal structure. To understand how the detailed crystal structure reflects the influence of water and Al, single crystal X ray diffraction analysis was performed for this suite of hydrous orthoenstatite. By comparing the results obtained at ambient conditions, we find that for low-level of Al-content, <2 wt. %, the Al3+ cation tends to occupy one of tetrahedral sites (TB) only. Analysis of the X ray diffraction results under high pressure indicates that the elasticity of orthoenstatites is insensitive to the presence of low-level water and Al. We use this finding to evaluate the velocity profile at the mid upper mantle of continental regions to compare with seismic observation. The comparison indicates that the cause of the low velocity zone in continental regions originates from the geotherm profile rather than the effect of water on the elasticity of mantle phases.
more »
« less
- Award ID(s):
- 1722969
- PAR ID:
- 10168755
- Date Published:
- Journal Name:
- Minerals
- Volume:
- 10
- Issue:
- 1
- ISSN:
- 2075-163X
- Page Range / eLocation ID:
- 71
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Metasomatized mantle xenoliths containing hydrous minerals, such as amphiboles, serpentine, and phlogopite, likely represent the potential mineralogical compositions of the metasomatized upper mantle, where low seismic velocities are commonly observed. This study presents the first experimentally determined single‐crystal elasticity model of an Fe‐free near Ca, Mg‐endmember amphibole tremolite at high pressure and/or temperature conditions (maximum pressure 7.3(1) GPa, maximum temperature 700 K) using Brillouin spectroscopy. We found that sound velocities of amphiboles strongly depend on the Fe content. We then calculated the sound velocities of 441 hydrous‐mineral‐bearing mantle xenoliths collected around the globe, and quantitatively evaluated the roles that amphiboles, phlogopite and serpentine played in producing the low velocity anomalies in the metasomatized upper mantle.more » « less
-
Abstract The influence of Al substitution on the elastic properties of stishovite and its transition to post-stishovite is of great importance for interpreting the seismic wave velocities of subducted mid-ocean ridge basalt (MORB) within the mantle transition zone and the lower mantle. However, atomistic mechanisms of Al substitution effects on the transition and its associated elasticity remain debated. Here synchrotron single-crystal X-ray diffraction measurements have been performed at room temperature on Al1.3-SiO2 (1.3 mol% Al in the chemical formula of Si0.965(3)Al0.041(1)O2H0.017(4)) and Al2.1-SiO2 (2.1 mol% Al in Si0.948(2)Al0.064(1)O2H 0.018(3)) crystals in diamond anvil cells with Boehler-Almax designed anvils up to 38.0 GPa and 28.5 GPa, respectively. Refinements of the diffraction patterns show that a transformation from stishovite (space group P42/mnm; No. 136) to CaCl2-typed post-stishovite (space group Pnnm; No. 58) is accompanied by splitting of O coordinates. The Al substitution in stishovite results in a faster decrease in the O coordinate, softer apical (Si,Al)-O bonds, and a softer and less distorted (Si,Al)O6 octahedron under compression. This leads to reduced adiabatic bulk modulus (KS), shear modulus (G), shear wave velocity (VS), and compressional wave velocity (VP) in the stishovite phase, explaining seismic wave perturbations in the mantle transition zone. Together with Raman data, Landau theory modeling shows that Al substitution increases the order parameter and excess free energy, stabilizing the post-stishovite phase at lower pressures. Correlation between elasticity and octahedral distortion index (D) reveals that at certain D, the Al substitution reduces KS, G, VS, and VP of the stishovite phase while increasing G, VS, and VP of the post-stishovite phase. Importantly, the maximum shear reduction is slightly enhanced at D = 0.00620(9) at the transition point. Our results help explain the seismically observed small-scale VS anomalies beneath subduction regions in the shallow lower mantle where Al,H-bearing stishovite undergoes the post-stishovite transition.more » « less
-
Abstract A comprehensive analysis of experimental data and theoretical simulations on the partial molar volume of water in silicate melt indicates that finite strain theory successfully describes the compression of the H2O component dissolved in silicate melt at high pressures and temperatures. However, because of the high compressibility of the water component, a fourth order equation of state fit is required to accurately simulate experimental results on water's volume in silicate melts at a deep upper mantle, transition zone, and lower mantle pressures. Data from previous shock compression experiments on hydrous minerals in which melting occurs along the Hugoniot are used to provide an experimental constraint on the partial molar volume of water in silicate melt at deep mantle temperatures and pressures. The equation of state of the water component indicates that, depending on elastic averaging technique, the amount of water that could be present in neutrally or negatively buoyant mafic/ultramafic melts above the 410 km seismic discontinuity is upper‐bounded at 5.6 wt%: smaller than previously inferred, and consistent with melt being confined to a narrow depth range above the 410 km discontinuity. If melt is predominantly distributed along grain boundaries in low aspect ratio films, extents of melting as low as 2% could produce observed seismic velocity reductions. The ability of the lowermost mantle to contain negatively buoyant hydrous liquids hinges on the trade‐off between iron content and hydration: at these depths, substantially higher degrees of hydration could be present within partial melts.more » « less
-
Abstract High pressure and temperature experiments were carried out on the oxide mixtures corresponding to the bridgmanite stoichiometry under the hydrous shallow lower mantle conditions (24–25 GPa and 1673–1873 K with 5–10 wt. % of water in the starting material). Oxide mixtures investigated correspond to MgSiO3, (Mg, Fe)SiO3, (Mg, Al, Si)O3, and (Mg, Fe, Al, Si)O3. Melting was observed in all runs. Partitioning of various elements, including Mg, Fe, Si, and H is investigated. Melting under hydrous lower mantle conditions leads to increased (Mg + Fe)O/SiO2in the melt compared to the residual solids. The residual solids often contain a large amount of stishovite, and the melt contains higher (Mg,Fe)O/SiO2ratio than the initial material. (Mg + Fe)O‐rich hydrous melt could explain the low‐velocity anomalies observed in the shallow lower mantle and a large amount of stishovite in the residual solid may be responsible for the scattering of seismic waves in the mid‐lower mantle and may explain the “stishovite paradox. Since stishovite‐rich materials are formed only when silica‐rich source rock (MORB) is melted (not a typical peridotitic rock [bulk silicate Earth]), seismic scattering in the lower mantle provides a clue on the circulation of subducted MORB materials. To estimate hydrogen content, we use a new method of estimating the water content of unquenchable melts, and also propose a new interpretation of the significance of superhydrous phase B inclusions in bridgmanite. The results provide revised values of water partitioning between solid minerals and hydrous melts that are substantially higher than previous estimates.more » « less
An official website of the United States government

