As several new spectrum bands are opening up for shared use, a new paradigm of Diverse Band-aware Dynamic Spectrum Access (d-DSA) has emerged. d-DSA equips a secondary device with software defined radios (SDRs) and utilize whitespaces (or idle channels) in multiple bands, including but not limited to TV, LTE, Citizen Broadband Radio Service (CBRS), unlicensed ISM. In this paper, we propose a decentralized, online multi-agent reinforcement learning based cross-layer BAnd selection and Routing Design (BARD) for such d-DSA networks. BARD not only harnesses whitespaces in multiple spectrum bands, but also accounts for unique electro-magnetic characteristics of those bands to maximize the desired quality of service (QoS) requirements of heterogeneous message packets; while also ensuring no harmful interference to the primary users in the utilized band. Our extensive experiments demonstrate that BARD outperforms the baseline dDSAaR algorithm in terms of message delivery ratio, however, at a relatively higher network latency, for varying number of primary and secondary users. Furthermore, BARD greatly outperforms its single-band DSA variants in terms of both the metrics in all considered scenarios.
more »
« less
Greedy Channel Selection for Dynamic Spectrum Access Radios
Dynamic Spectrum Access (DSA) radios typically select their radio channels according to their data networking goals, a defined DSA spectrum operating policy, and the state of the RF spectrum. RF spectrum sensing can be used to collect information about the state of the RF spectrum and prioritize which channels should be assigned for DSA radio waveform transmission and reception. This paper describes a Greedy Channel Ranking Algorithm (GCRA) used to calculate and rank RF interference metrics for observed DSA radio channels. The channel rankings can then be used to select and/or avoid channels in order to attain a desired DSA radio performance level. Experimental measurements are collected using our custom software-defined radio (SDR) system to quantify the performance of using GCRA for a DSA radio application. Analysis of these results show that both pre and post-detection average interference power metrics are the most accurate metrics for selecting groups of radio channels to solve constrained channel assignment problems in occupied gray space spectrum.
more »
« less
- NSF-PAR ID:
- 10196057
- Date Published:
- Journal Name:
- 2020 IEEE International Symposium on Circuits and Systems
- Page Range / eLocation ID:
- 1 to 4
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
The main resource for providing wireless services is radio frequency (RF) spectrum. In order to explore new uses of spectrum shared among radio systems and services, field data needs to be collected. In this paper we design a testbed that can generate different 5G New Radio (NR) downlink transmission frames using the MATLAB 5G Toolbox, software-defined radio (SDR) hardware and GNU Radio Companion. This system will be used as a part of a testbed to study the RF interference caused by 5G transmissions to remote sensing receivers and evaluate different mechanisms for co-channel coexistence.more » « less
-
more » « less
Abstract Wireless virtualization is emerging as a new paradigm to improve wireless spectrum utilization by subleasing radio frequency (RF) channels through slicing. This paper investigates wireless virtualization where wireless resources for virtual wireless networks adapted based on availability of leasable RF slices as well as the demands from the users of virtual wireless networks. The user utilities are subject to quality‐of‐experience requirements such as coverage, rate, mobility, and delay requirements. With the help of software defined network controller, wireless infrastructure providers (WIPs) slice their RF bands to sublease those slices to mobile virtual network operators (MVNOs). In wireless virtualization, MVNOs work as independent service provides, and thus, the end users negotiate directly to MVNOs regardless of WIPs used behind the scene (this concept is analogous to the Uber being a taxi company without owning any vehicles). The performance of the proposed approach is evaluated with the help of numerical results obtained from simulations by using different metrics such as percentage of RF band of WIP, outage probability, and data rate.
-
Testing and Evaluation of Radio Frequency Immunity of Unmanned Aerial Vehicles For Bridge InspectionRecent technological advances have led to an increase in the adoption of Unmanned Aerial Vehicles (UAVs) in a variety of use-case scenarios. In particular, Departments of Transportation in several states in the United States have been exploring the use of UAVs for bridge and infrastructure inspections to improve safety and reduce the costs of the inspection process. UAVs are remotely piloted from a cockpit or a ground station via radio channels. The UAV's state information and payload information are also transmitted to the cockpit/ground station via radio frequency (RF) signals. The RF channels that are commonly used by most UAVs are 72-73, 902-928 and 2400-2483.5 MHz bands, which is also shared by several other communication protocols such as, WiFi and ZigBee networks, and therefore, the interference effects with the other services on the UAV's operation performance cannot be overlooked, particularly to maintain the minimum distance from the close by surfaces while flying alongside and underneath the bridges to achieve the best results. The loss of signal or even signal strength during such close flights can cause damage to the UAV. Especially while inspecting the bridges located in the urban areas that involve a lot of RF communication around due to presence of sever RC devices providing different services. Conventional Electromagnetic Compatibility (EMC) adherence requirements imposed on electronic systems are not adequate for UAVs due to their airborne nature and the presence of the other RF sources in the environment. Thus, in this work, we investigate the compliance of EMC requirements by designing and conducting field experiments to expose the UAVs to electromagnetic interference and distortions that are likely to be encountered during the UAV operation. The results of this work will enable us to assess the level of RF immunity of the general-purpose UAVs to aid in the selection of a suitable UAV platform for bridge inspection and develop safety procedures for minimizing the impact of RF interference.more » « less
-
more » « less
Microwave communications have witnessed an incipient proliferation of multi-antenna and opportunistic technologies in the wake of an ever-growing demand for spectrum resources, while facing increasingly difficult network management over widespread channel interference and heterogeneous wireless broadcasting. Radio frequency (RF) blind source separation (BSS) is a powerful technique for demixing mixtures of unknown signals with minimal assumptions, but relies on frequency dependent RF electronics and prior knowledge of the target frequency band. We propose photonic BSS with unparalleled frequency agility supported by the tremendous bandwidths of photonic channels and devices. Specifically, our approach adopts an RF photonic front-end to process RF signals at various frequency bands within the same array of integrated microring resonators, and implements a novel two-step photonic BSS pipeline to reconstruct source identities from the reduced dimensional statistics of front-end output. We verify the feasibility and robustness of our approach by performing the first proof-of-concept photonic BSS experiments on mixed-over-the-air RF signals across multiple frequency bands. The proposed technique lays the groundwork for further research in interference cancellation, radio communications, and photonic information processing.
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Conference Paper:
- https://doi.org/10.1109/ISCAS45731.2020.9180882
