An official website of the United States government
Two-dimensional (2D) materials assembled into van der Waals (vdW) heterostructures contain unlimited combinations of mechanical, optical, and electrical properties that can be harnessed for potential device applications. Critically, these structures require control over interfacial adhesion for enabling their construction and have enough integrity to survive industrial fabrication processes upon their integration. Here, we promptly determine the adhesion quality of various exfoliated 2D materials on conventional SiO 2 /Si substrates using ultrasonic delamination threshold testing. This test allows us to quickly infer relative substrate adhesion based on the percent area of 2D flakes that survive a fixed time in an ultrasonic bath, allowing for control over process parameters that yield high or poor adhesion. We leverage this control of adhesion to optimize the vdW heterostructure assembly process, where we show that samples with high or low substrate adhesion relative to each other can be used selectively to construct high-throughput vdW stacks. Instead of tuning the adhesion of polymer stamps to 2D materials with constant 2D-substrate adhesion, we tune the 2D-substrate adhesion with constant stamp adhesion to 2D materials. The polymer stamps may be reused without any polymer melting steps, thus avoiding high temperatures (<120 °C) and allowing for high-throughput production. We show that this procedure can be used to create high-quality 2D twisted bilayer graphene on SiO 2 /Si, characterized with atomic force microscopy and Raman spectroscopic mapping, as well as low-angle twisted bilayer WSe 2 on h-BN/SiO 2 /Si, where we show direct real-space visualization of moiré reconstruction with tilt-angle dependent scanning electron microscopy.
more »
« less
Direct measurements of interfacial adhesion in 2D materials and van der Waals heterostructures in ambient air
Abstract Interfacial adhesion energy is a fundamental property of two-dimensional (2D) layered materials and van der Waals heterostructures due to their intrinsic ultrahigh surface to volume ratio, making adhesion forces very strong in many processes related to fabrication, integration and performance of devices incorporating 2D crystals. However, direct quantitative characterization of adhesion behavior of fresh and aged homo/heterointerfaces at nanoscale has remained elusive. Here, we use an atomic force microscopy technique to report precise adhesion measurements in ambient air through well-defined interactions of tip-attached 2D crystal nanomesas with 2D crystal and SiOxsubstrates. We quantify how different levels of short-range dispersive and long-range electrostatic interactions respond to airborne contaminants and humidity upon thermal annealing. We show that a simple but very effective precooling treatment can protect 2D crystal substrates against the airborne contaminants and thus boost the adhesion level at the interface of similar and dissimilar van der Waals heterostructures. Our combined experimental and computational analysis also reveals a distinctive interfacial behavior in transition metal dichalcogenides and graphite/SiOxheterostructures beyond the widely accepted van der Waals interaction.
more »
« less
- Award ID(s):
- 1636132
- PAR ID:
- 10200627
- Publisher / Repository:
- Nature Publishing Group
- Date Published:
- Journal Name:
- Nature Communications
- Volume:
- 11
- Issue:
- 1
- ISSN:
- 2041-1723
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
We measure and model monolayers of concentrated diffusing colloidal probes interacting with polymerized liquid crystal (PLC) planar surfaces. At topological defects in local nematic director profiles at PLC surfaces, we observe time-averaged two-dimensional particle density profiles of diffusing colloidal probes that closely correlate with spatial variations in PLC optical properties. An inverse Monte Carlo analysis of particle concentration profiles yields two-dimensional PLC interfacial energy landscapes on the kT -scale, which is the inherent scale of many interfacial phenomena ( e.g. , self-assembly, adsorption, diffusion). Energy landscapes are modelled as the superposition of macromolecular repulsion and van der Waals attraction based on an anisotropic dielectric function obtained from the liquid crystal birefringence. Modelled van der Waals landscapes capture most net energy landscape variations and correlate well with experimental PLC director profiles around defects. Some energy landscape variations near PLC defects indicate either additional local repulsive interactions or possibly the need for more rigorous van der Waals models with complete spectral data. These findings demonstrate direct, sensitive measurements of kT -scale van der Waals energy landscapes at PLC interfacial defects and suggest the ability to design interfacial anisotropic materials and van der Waals energy landscapes for colloidal assembly.more » « less
-
Combining experimental and computational studies of nanocomposite interfaces is highly needed to gain insight into their performance. However, there are very few literature reports, combining well-controlled atomic force microscopy experiments with molecular dynamic simulations, which explore the role of polymer chemistry and assembly on interface adhesion and shear strength. In this work, we investigate graphene oxide (GO)-polymer interfaces prevalent in nanocomposites based on a nacre-like architectures. We examine the interfacial strength resulting from van der Waals and hydrogen bonding interactions by comparing the out-of-plane separation and in-plane shear deformations of GO-polyethylene glycol (PEG) and GO-polyvinyl alcohol (PVA). The investigation reveals an overall better mechanical performance for the anhydrous GO-PVA system in both out-of-plane and in-plane deformation modes, highlighting the benefits of the donor-acceptor hydrogen bond formation present in GO-PVA. Such bond formation results in interchain hydrogen bond networks leading to stronger interfaces. By contrast, PEG, a hydrogen bond acceptor only, relies primarily on van der Waals inter-chain interactions, typically resulting in weaker interactions. The study also predicts that water addition increases the adhesion of GOPEG but decreases the adhesion of GO-PVA, and slightly increases the shear strength in both systems. Furthermore, by comparing simulations and experiments, we show that the CHARMM force field has enough accuracy to capture the effect of polymer content, water distribution, and to provide quantitative guidance for achieving optimum interfacial properties. Therefore, the study demonstrates an effective methodology, in the Materials Genome spirit, toward the design of 2D materials-polymer nanocomposites system for applications demanding mechanical robustness.more » « less
-
Abstract 2D van der Waals (vdW) magnets open landmark horizons in the development of innovative spintronic device architectures. However, their fabrication with large scale poses challenges due to high synthesis temperatures (>500 °C) and difficulties in integrating them with standard complementary metal‐oxide semiconductor (CMOS) technology on amorphous substrates such as silicon oxide (SiO2) and silicon nitride (SiNx). Here, a seeded growth technique for crystallizing CrTe2films on amorphous SiNx/Si and SiO2/Si substrates with a low thermal budget is presented. This fabrication process optimizes large‐scale, granular atomic layers on amorphous substrates, yielding a substantial coercivity of 11.5 kilo‐oersted, attributed to weak intergranular exchange coupling. Field‐driven Néel‐type stripe domain dynamics explain the amplified coercivity. Moreover, the granular CrTe2devices on Si wafers display significantly enhanced magnetoresistance, more than doubling that of single‐crystalline counterparts. Current‐assisted magnetization switching, enabled by a substantial spin–orbit torque with a large spin Hall angle (85) and spin Hall conductivity (1.02 × 107ℏ/2e Ω⁻¹ m⁻¹), is also demonstrated. These observations underscore the proficiency in manipulating crystallinity within integrated 2D magnetic films on Si wafers, paving the way for large‐scale batch manufacturing of practical magnetoelectronic and spintronic devices, heralding a new era of technological innovation.more » « less
-
Abstract Magnetic van der Waals heterostructures provide a unique platform to study magnetism and spintronics device concepts in the 2D limit. Here, studies of exchange bias from the van der Waals antiferromagnet CrSBr acting on the van der Waals ferromagnet Fe3GeTe2(FGT) are reported. The orientation of the exchange bias is along the in‐plane easy axis of CrSBr, perpendicular to the out‐of‐plane anisotropy of the FGT, inducing a strongly tilted magnetic configuration in the FGT. Furthermore, the in‐plane exchange bias provides sufficient symmetry breaking to allow deterministic spin–orbit torque switching of the FGT in CrSBr/FGT/Pt samples at zero applied magnetic field. A minimum thickness of the CrSBr of >10 nm is needed to provide a non‐zero exchange bias at 30 K.more » « less
