An official website of the United States government
Abstract The highly stratified, oligotrophic regions of the oceans are predominantly nitrogen limited in the surface ocean and light limited at the deep chlorophyll maximum (DCM). Hence, determining light and nitrogen co-limitation patterns for diverse phytoplankton taxa is crucial to understanding marine primary production throughout the euphotic zone. During two cruises in the deep-water Gulf of Mexico, we measured primary productivity (H13CO3−), nitrate uptake (15NO3−) and ammonium uptake (15NH4+) throughout the water column. Primary productivity declined with depth from the mixed layer to the DCM, averaging 27.1 mmol C m−2 d−1. The fraction of growth supported by NO3− was consistently low, with upper euphotic zone values ranging from 0.01 to 0.14 and lower euphotic zone values ranging from 0.03 to 0.44. Nitrate uptake showed strong diel patterns (maximum during the day), whereas ammonium uptake exhibited no diel variability. To parameterize taxon-specific phytoplankton nutrient and light utilization, we used a data assimilation approach (Bayesian Markov Chain Monte Carlo) including primary productivity, nutrient uptake and taxon-specific growth rate measurements. Parameters derived from this analysis define distinct niches for five phytoplankton taxa (Prochlorococcus, Synechococcus, diatoms, dinoflagellates and prymnesiophytes) and may be useful for constraining biogeochemical models of oligotrophic open-ocean systems.
more »
« less
Independent iron and light limitation in a low-light-adapted Prochlorococcus from the deep chlorophyll maximum
Abstract Throughout the open ocean, a minimum in dissolved iron concentration (dFe) overlaps with the deep chlorophyll maximum (DCM), which marks the lower limit of the euphotic zone. Maximizing light capture in these dim waters is expected to require upregulation of Fe-bearing photosystems, further depleting dFe and possibly leading to co-limitation by both iron and light. However, this effect has not been quantified for important phytoplankton groups like Prochlorococcus , which contributes most of the productivity in the oligotrophic DCM. Here, we present culture experiments with Prochlorococcus strain MIT1214, a member of the Low Light 1 ecotype isolated from the DCM in the North Pacific subtropical gyre. Under a matrix of iron and irradiance matching those found at the DCM, the ratio of Fe to carbon in Prochlorococcus MIT1214 cells ranged from 10–40 × 10 −6 mol Fe:mol C and increased with light intensity and growth rate. These results challenge theoretical models predicting highest Fe:C at lowest light intensity, and are best explained by a large photosynthetic Fe demand that is not downregulated at higher light. To sustain primary production in the DCM with the rigid Fe requirements of low-light-adapted Prochlorococcus , dFe must be recycled rapidly and at high efficiency.
more »
« less
- PAR ID:
- 10212748
- Date Published:
- Journal Name:
- The ISME Journal
- Volume:
- 15
- Issue:
- 1
- ISSN:
- 1751-7362
- Page Range / eLocation ID:
- 359 to 362
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
null (Ed.)We present a new approach for quantifying the bioavailability of dissolved iron (dFe) to oceanic phytoplankton. Bioavailability is defined using an uptake rate constant (kin-app) computed by combining data on: i) Fe content of individual in situ phytoplankton cells; ii) concurrently-determined seawater dFe concentrations; and iii) growth rates estimated from the PISCES model. We examined 930 phytoplankton cells, collected between 2002-2016 from 45 surface stations during 11 research cruises. This approach is only valid for cells that have upregulated their high-affinity Fe uptake system, so data was screened, yielding 560 single cell kin-app values from 31 low-Fe stations. We normalized kin-app to cell surface area (S.A.) to account for cell-size differences. The resulting bioavailability proxy (kin-app/S.A.) varies among cells, but all values are within bioavailability limits predicted from defined Fe complexes. In situ dFe bioavailability is higher than model Fe-siderophore complexes and often approaches that of highly-available inorganic Fe´. Station averaged kin-app/S.A. are also variable but show no systematic changes across location, temperature, dFe, and phytoplankton taxa. Given the relative consistency of kin-app/S.A. among stations (ca. 5-fold variation), we computed a grand-averaged dFe availability, which upon normalization to cell carbon (C) yields kin-app/C of 42,200 ± 11,000 L mol C-1 d-1. We utilize kin-app/C to calculate dFe uptake rates and residence times in low Fe oceanic regions. Finally, we demonstrate the applicability of kin-app/C for constraining Fe uptake rates in earth system models, such as those predicting climate mediated changes in net primary production in the Fe-limited Equatorial Pacific.more » « less
-
Campbell, Lisa (Ed.)Abstract Biomass and composition of the phytoplankton community were investigated in the deep-water Gulf of Mexico (GoM) at the edges of Loop Current anticyclonic eddies during May 2017 and May 2018. Using flow cytometry, high-performance liquid chromatography pigments and microscopy, we found euphotic zone integrated chlorophyll a of ~10 mg m−2 and autotrophic carbon ranging from 463 to 1268 mg m−2, dominated by picoplankton (<2 μm cells). Phytoplankton assemblages were similar to the mean composition at the Bermuda Atlantic Time-series Study site, but differed from the Hawaii Ocean Times-series site. GoM phytoplankton biomass was ~2-fold higher at the deep chlorophyll maximum (DCM) relative to the mixed layer (ML). Prochlorococcus and prymnesiophytes were the dominant taxa throughout the euphotic zone; however, other eukaryotic taxa had significant biomass in the DCM. Shallower DCMs were correlated with more prymnesiophytes and prasinophytes (Type 3) and reduced Prochlorococcus. These trends in ML and DCM taxonomic composition likely reflect relative nutrient supply—with ML populations relying on remineralized ammonium as a nitrogen source, and the taxonomically diverse DCM populations using more nitrate. These spatially separated phytoplankton communities represent different pathways for primary production, with a dominance of picoplankton in the ML and more nano- and microplankton at the DCM.more » « less
-
Dissolved iron (dFe) is an essential micronutrient for phytoplankton, with vanishingly low oceanic dissolved concentrations (pico- to nanomoles per kg) known to limit growth—and thus influence primary productivity and carbon cycling—over much of the surface ocean. However, because of the considerable challenges associated with contamination-free sample collection and accurate analysis of such low dFe concentrations, the first reliable dFe measurements came only in the 1980s. Further, by 2003, despite several decades of research, there were only ~25 full-depth oceanic dFe profiles worldwide, with dust considered to be the main oceanic dFe source. Since 2008, facilitated by the extensive field campaign and rigorous intercalibration of the international GEOTRACES program, there has been an “explosion” in the availability of oceanic dFe data, with hundreds of profiles now available. Concurrently, there has been a paradigm shift to a view of the marine Fe cycle where multiple sources contribute, and some forms of dFe can be transported great distances through the intermediate and deep ocean. Here, we showcase the GEOTRACES dFe datasets across the different ocean basins, synthesize our current multi-source view of the oceanic Fe cycle, spotlight sediments as an important dFe source, and look to future directions for constraining oceanic dFe boundary exchange.more » « less
-
Abstract Dissolved iron (dFe) plays an important role in regulating marine productivity. In high nutrient, low chlorophyll regions (>33% of the global ocean), iron is the primary growth limiting nutrient, and elsewhere iron can regulate nitrogen fixation by diazotrophs. The link between iron availability and carbon export is strongly dependent on the phytoplankton iron quotas or cellular Fe:C ratios. This ratio varies by more than an order of magnitude in the open ocean and is positively correlated with ambient dFe concentrations in field observations. Representing Fe:C ratios within models is necessary to investigate how ocean carbon cycling will interact with perturbations to iron cycling in a changing climate. The Community Earth System Model ocean component was modified to simulate dynamic, group‐specific, phytoplankton Fe:C that varies as a function of ambient iron concentration. The simulated Fe:C ratios improve the representation of the spatial trends in the observed Fe:C ratios. The acclimation of phytoplankton Fe:C ratios dampens the biogeochemical response to varying atmospheric deposition of soluble iron, compared to a fixed Fe:C ratio. However, varying atmospheric soluble iron supply has first order impacts on global carbon and nitrogen fluxes and on nutrient limitation spatial patterns. Our results suggest that pyrogenic Fe is a significant dFe source that rivals mineral dust inputs in some regions. Changes in dust flux and iron combustion sources (anthropogenic and wildfires) will modify atmospheric Fe inputs in the future. Accounting for dynamic phytoplankton iron quotas is critical for understanding ocean biogeochemistry and projecting its response to variations in atmospheric deposition.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript
- Journal Article:
- https://doi.org/10.1038/s41396-020-00776-y
