An official website of the United States government
Previous studies have demonstrated that structures such as a canopy or finlets placed within a boundary layer over an aerodynamic surface can attenuate pressure fluctuations on the surface without compromising aerodynamic performance. This paper describes research into the fundamental mechanisms of this pressure shielding. Experiments and analysis are performed on elemental canopy configurations (parallel arrays of streamwise rods) that eliminate the confounding effects of a leading-edge support structure. Experiments show that such a canopy produces attenuation in two distinct frequency ranges. At low frequencies (convective scales much greater than the canopy height) attenuation spectra scale on the canopy height Strouhal number, but at high frequencies (canopy scales of the order of the height) a dissipation type frequency scaling appears more appropriate. RANS calculations are performed simulating the canopy geometry directly and as a porous layer. Pressure fluctuation spectra predicted from the RANS results by separately accounting for inner and outer layer contributions are able to accurately recreate the wall pressure spectra both with and without the canopy and thus the major features of the attenuation spectra.
more »
« less
Understanding Pressure Shielding by Canopies
Previous studies have demonstrated that structures such as a canopy or finlets placed within a boundary layer over an aerodynamic surface can attenuate pressure fluctuations on the surface without compromising aerodynamic performance. This paper describes research into the fundamental mechanisms of this pressure shielding. Experiments and analysis are performed on elemental canopy configurations which are arrays of streamwise rods placed parallel to the wall in order to eliminate the confounding effects of a leading edge support structure. Experiments show that such a canopy produces attenuation in three distinct frequency ranges. At low frequencies, where convective scales are much greater than the canopy height, attenuation spectra scale on the canopy height Strouhal number, but at high frequencies, a dissipation type frequency scaling appears more appropriate. There is mid-freqeuncy region which shows reduction in attenuation and is observed for all canopy structures tested. Attenuation in this region appears to scale with Strouhal number based on canopy spacing.
more »
« less
- PAR ID:
- 10252732
- Date Published:
- Journal Name:
- AIAA SciTech 2021
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
null (Ed.)Wake-induced aerodynamics of yawed circular cylinders with smooth and grooved surfaces in a tandem arrangement was studied. This pair of cylinders represent sections of stay-cables with smooth surfaces and high-voltage power conductors with grooved surfaces that are vulnerable to flow-induced structural failure. The study provides some insight for a better understanding of wake-induced loads and galloping problem of bundled cables. All experiments in this study were conducted using a pair of stationary section models of circular cylinders in a wind tunnel subjected to uniform and smooth flow. The aerodynamic force coefficients and vortex-shedding frequency of the downstream model were extracted from the surface pressure distribution. For measurement, polished aluminum tubes were used as smooth cables; and hollow tubes with a helically grooved surface were used as power conductors. The aerodynamic properties of the downstream model were captured at wind speeds of about 6-23 m/s (Reynolds number of 5×10^4 to 2.67×10^5 for smooth cable and 2×10^4 to 1.01×10^5 for grooved cable) and yaw angles ranging from 0º to 45º while the upstream model was fixed at various spacing between the two model cylinders. The results showed that the Strouhal number of yawed cable is less than the non-yawed case at a given Reynolds number, and its value is smaller than the Strouhal number of a single cable. Additionally, compared to the single smooth cable, it was observed that there was a reduction of drag coefficient of the downstream model, but no change in a drag coefficient of the downstream grooved case in the range of Reynolds number in this study.more » « less
-
null (Ed.)An analytical approach has been developed to model the rapid term contribution to the unsteady surface pressure fluctuations in wall jet turbulent boundary layer flows. The formulation is based on solving Poisson’s equation for the turbulent wall pressure by integrating the source terms (Kraichnan, 1956). The inputs for the model are obtained from 2D time-resolved Particle Image Velocimetry measurements performed in a wall jet flow. The wall normal turbulence wavenumber two-point cross-spectra is determined using an extension of the von Kármán homogeneous turbulence spectrum. The model is applied to compare and understand the baseline flow in the wall jet and to study the attenuation in surface pressure fluctuations by unidirectional canopies (Gonzales et al, 2019). Different lengthscale formulations are tested and we observe that the wall jet flow boundary layer contributes to the surface pressure fluctuations from two distinct regions. The high frequency spectrum is captured well. However, the low frequency range of the spectrum is not entirely captured. This is because we have used PIV data only up to a height of 2.3𝜹, whereas the largest turbulent lengthscales in the wall jet are on the order of 𝒚𝟏/𝟐≈𝟔𝜹. Using the flow data obtained from PIV and Pitot probe measurements, the model predicts a reduction in the surface pressure due to canopy at low frequencies.more » « less
-
Abstract Pyroclastic surges are lethal hazards from volcanoes that exhibit enormous destructiveness through dynamic pressures of 10 0 –10 2 kPa inside flows capable of obliterating reinforced buildings. However, to date, there are no measurements inside these currents to quantify the dynamics of this important hazard process. Here we show, through large-scale experiments and the first field measurement of pressure inside pyroclastic surges, that dynamic pressure energy is mostly carried by large-scale coherent turbulent structures and gravity waves. These perpetuate as low-frequency high-pressure pulses downcurrent, form maxima in the flow energy spectra and drive a turbulent energy cascade. The pressure maxima exceed mean values, which are traditionally estimated for hazard assessments, manifold. The frequency of the most energetic coherent turbulent structures is bounded by a critical Strouhal number of ~0.3, allowing quantitative predictions. This explains the destructiveness of real-world flows through the development of c. 1–20 successive high-pressure pulses per minute. This discovery, which is also applicable to powder snow avalanches, necessitates a re-evaluation of hazard models that aim to forecast and mitigate volcanic hazard impacts globally.more » « less
-
A new Anechoic Wall Jet Wind Tunnel was built at Virginia Tech. A detailed design based on the old wall jet tunnel was done to improve the quality of the resultant flow. Aerodynamic and acoustic calibrations were performed in order to understand properties and characteristics of the flow generated by this new facility which can be used for various aeroacoustic studies. Far-field acoustics were measured using half-inch B&K microphones in a streamwise array to characterize and reduce the background noise. Sound pressure levels were lower by 10 dB for frequencies up to 700Hz in comparison to the old facility. The turbulent surface pressure fluctuations of the wall-jet flow were studied using Sennheiser microphones placed along streamwise and spanwise locations to record surface pressure fluctuations. Comparison of the autocorrelation plotted for microphones along the same span indicate uniform flow features. A decay in the turbulence levels is observed along the downstream direction as expected. Aerodynamic calibrations included mean velocity measurements along different spanwise locations, wall-jet boundary layer profiles and streamwise cross-sections. Spanwise and cross-sectional velocity profiles show good uniformity of the flow. Detailed boundary layer analyses were performed with the parameters obtained from the experiments.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Conference Paper:
- https://doi.org/10.2514/6.2021-0817
