skip to main content

Attention:

The NSF Public Access Repository (NSF-PAR) system and access will be unavailable from 11:00 PM ET on Thursday, October 10 until 2:00 AM ET on Friday, October 11 due to maintenance. We apologize for the inconvenience.

Explore Research Products in the NSF-PAR

  • NSF Public Access
  • Search Results
  • Melamine-based functionalized graphene oxide and zirconium phosphate for high performance removal of mercury and lead ions from water
Title: Melamine-based functionalized graphene oxide and zirconium phosphate for high performance removal of mercury and lead ions from water
Heavy metal ions are highly toxic and widely spread as environmental pollutants. This work reports the development of two novel chelating adsorbents, based on the chemical modifications of graphene oxide and zirconium phosphate by functionalization with melamine-based chelating ligands for the effective and selective extraction of Hg( ii ) and Pb( ii ) from contaminated water sources. The first adsorbent melamine, thiourea-partially reduced graphene oxide (MT-PRGO) combines the heavier donor atom sulfur with the amine and triazine nitrogen's functional groups attached to the partially reduced GO nanosheets to effectively capture Hg( ii ) ions from water. The MT-PRGO adsorbent shows high efficiency for the extraction of Hg( ii ) with a capacity of 651 mg g −1 and very fast kinetics resulting in a 100% removal of Hg( ii ) from 500 ppb and 50 ppm concentrations in 15 second and 30 min, respectively. The second adsorbent, melamine zirconium phosphate (M-ZrP), is designed to combine the amine and triazine nitrogen's functional groups of melamine with the hydroxyl active sites of zirconium phosphate to effectively capture Pb( ii ) ions from water. The M-ZrP adsorbent shows exceptionally high adsorption affinity for Pb( ii ) with a capacity of 681 mg g −1 and 1000 mg g −1 using an adsorbent dose of 1 g L −1 and 2 g L −1 , respectively. The high adsorption capacity is also coupled with fast kinetics where the equilibrium time required for the 100% removal of Pb( ii ) from 1 ppm, 100 ppm and 1000 ppm concentrations is 40 seconds, 5 min and 30 min, respectively using an adsorbent dose of 1 g L −1 . In a mixture of six heavy metal ions at a concentration of 10 ppm, the removal efficiency is 100% for Pb( ii ), 99% for Hg( ii ), Cd( ii ) and Zn( ii ), 94% for Cu( ii ), and 90% for Ni( ii ) while at a higher concentration of 250 ppm the removal efficiency for Pb( ii ) is 95% compared to 23% for Hg( ii ) and less than 10% for the other ions. Because of the fast adsorption kinetics, high removal capacity, excellent regeneration, stability and reusability, the MT-PRGO and M-ZrP are proposed as top performing remediation adsorbents for the solid phase extraction of Hg( ii ) and Pb( ii ), respectively from contaminated water.  more » « less
Award ID(s):
1900094
NSF-PAR ID:
10275602
Author(s) / Creator(s):
; ; ; ;
Date Published:
Journal Name:
RSC Advances
Volume:
10
Issue:
62
ISSN:
2046-2069
Page Range / eLocation ID:
37883 to 37897
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. ; ; ; ; ( , RSC Advances)
    null (Ed.)
    A highly porous adsorbent based on a metal–organic framework was successfully designed and applied as an innovative adsorbent in the solid phase for the heavy metal removal. MIL-125 was densely decorated by 2-imino-4-thiobiuret functional groups, which generated a green, rapid, and efficacious adsorbent for the uptake of Hg( ii ) and Pb( ii ) from aqueous solutions. ITB-MIL-125 showed a high adsorption affinity toward mercury( ii ) ions of 946.0 mg g −1 due to covalent bond formation with accessible sulfur-based functionality. Different factors were studied, such as the initial concentration, pH, contact time, and competitive ions, under same circumstances at the room temperature. Moreover, the experimental adsorption data were in excellent agreement with the Langmuir adsorption isotherm and pseudo-second order kinetics. At a high concentration of 100 ppm mixture of six metals, ITB-MIL-125 exhibited a high adsorption capacity, reaching more than 82% of Hg( ii ) compared to 62%, 30%, 2%, 1.9%, and 1.6% for Pb( ii ), Cu( ii ), Cd( ii ), Ni( ii ), and Zn( ii ), respectively. 
    more » « less
  2. ; ; ; ; ; ; ( , Environmental Science: Water Research & Technology)
    null (Ed.)
    Rice husks are an agricultural residue of great annual production and have a high cellulose content. In this study, we have prepared highly charged carboxyl cellulose nanofibers (CNFs) from rice husks using the TEMPO-oxidation method and the extracted CNFs were evaluated as an adsorbent for the removal of lead( ii ) and lanthanum( iii ) (Pb( ii ) and La( iii )) ions from contaminated water. Three different forms of nanocellulose adsorbents were prepared: suspension, freeze-dried, and nanocomposite containing magnetic nanoparticles, where their adsorption performance was tested against the removal of the two chosen heavy metal ions. The maximum adsorption capacity of rice husk based CNFs was found to be the highest in the nanocellulose suspension, i.e. , 193.2 mg g −1 for Pb( ii ) and 100.7 mg g −1 for La( iii ). The separation of the used adsorbent in the suspension was further facilitated by the gelation of the CNFs and metal cations, where the resulting floc could be removed by gravity-driven filtration. The absorption mechanism of the investigated CNF system is mainly due to electrostatic interactions between negatively charged carboxylate groups and multivalent metal ions. It was found that 90% lanthanum content in the form of lanthanum oxychloride (determined by X-ray powder diffraction) could be obtained by incinerating the CNF/LaCl 3 gel. This study demonstrates a viable and sustainable solution to upcycle agricultural residues into remediation nanomaterials for the removal and recovery of toxic heavy metal ions from contaminated water. 
    more » « less
  3. ; ; ( , Desalination and water treatment)
    Modern industrial waste waters often contain high concentrations of phosphate, and many methods have been explored to aid in its removal. This study investigates the use of magnetic nanoparticles as an adsorbent for phosphate removal. Aluminum-doped magnetic nanoparticles were synthesized using a co-precipitation method. Structure and composition analysis of the prepared magnetic nanoparticles indicated an inverse spinal structure with a composition of FeAl0.75Fe1.25O4. These nanoparticles were tested for their phosphate removal properties, including adsorption capacity, selectivity, and kinetic models. They showed great affinity to phosphate with a maximum adsorption capacity of 102 mg/g. Additionally, the adsorption was selective, and the presence of other common anions and organic matters did not interfere with the phosphate adsorption efficacy. The kinetic analysis of phosphate adsorption suggested a pseudo-second-order adsorption behavior, and the adsorption isotherm studies indicated a Langmuir type adsorption. The phosphate removal capabilities of the nanoparticles were also tested in poultry rinsing water, tap water, and municipal wastewaters, all with high phosphate removal efficiency. The overall results from these experiments showed promising results for the phosphate removal efficacy of these nanoparticles. 
    more » « less
  4. ; ; ; ; ; ; ; ( , Polymer Engineering & Science)
    Abstract

    Copper ions in wastewater present substantial environmental hazards, toxic to aquatic species and prone to bioaccumulation. Addressing this, we present a novel cross‐linked polythiourethane (C‐PTU) as a promising chelating adsorbent for the effective removal of copper ions from wastewater. A new monomer, 5‐(2,2,2‐trifluoroacetamide) benzene‐1,3‐bis(carbonyl) isothiocyanate (TFA‐ITC), was synthesized and further condensed with a 1,4‐butane diol to produce a trifluoroacetamide functionalized polythiourethane (TFA‐PTU) and subsequently generating amine functionalized polythiourethane (A‐PTU). The cross‐linking reaction was carried out through amino groups present on the polymer backbone with terephthaloyl chloride, resulting in the formation of C‐PTU. The monomer and polymers underwent characterization using Fourier transform infrared,1H, and13C nuclear magnetic resonance spectroscopy, with X‐ray diffraction analyzing the resin's chain alignment. Thermogravimetric and differential scanning calorimetry assessed C‐PTU's thermal properties. The adsorption process for Cu(II) ions was studied using atomic absorption spectroscopy, optimizing conditions for maximal uptake. Results revealed that C‐PTU exhibited a significant adsorption capacity for Cu(II) ions, reaching 67% after a 2 h contact time, with optimal adsorption occurring at pH 6. The Langmuir adsorption isotherm described the sorption mechanism, indicating favorable monolayer cation adsorption via coordination with donor sites on C‐PTU. This research presents a viable solution for copper ion contamination in wastewater, illustrating C‐PTU as an efficient, environmentally friendly adsorbent, marking progress toward cleaner water resources.

     
    more » « less
  5. ; ; ; ; ; ; ; ; ; ; et al ( , Advanced Functional Materials)
    Abstract

    The new material polypyrrole/MoS42−(MoS4‐Ppy), prepared by ion‐exchange of NO3‐ of NO3‐Ppy with MoS42−, displays high acid stability and excellent uptake for heavy metal ions such as Hg2+, Ag+, Cu2+, and Pb2+. The different maximum adsorption capacities (qm) for Cu2+, Pb2+, Hg2+, and Ag+depend on the various binding modes arising from the different thiophilicity of these metal ions. The removals of Ag+and Pb2+reach >99.6% within 5 min, and for highly toxic Hg2+, >98% removal achieves at 1 min. At strong acid limit, the exceptionalqm(Ag+) of 725 mg g−1places the MoS4‐Ppy at the top of materials for such removal. Uptake kinetics of Ag+, Hg2+, and Pb2+is extremely fast: >99.9% removal rates at wide pH range (0.5–6) within 1–5 min. Also, at strongly acidic conditions (pH ≈ 1), for highly toxic Hg2+, <2 ppb concentration can be achieved, accepted as safe limit. The MoS4‐Ppy demonstrates an outstanding ability to separate low‐concentrated Ag+from high concentrated Cu2+especially under strong acidic conditions (pH ≈ 1), showing a large separation factor SFAg/Cu(KdAg/KdCu) of 105(>100). MoS4‐Ppy is a superior and novel sorbent material for water remediation applications as well as precious metals recovery.

     
    more » « less
  • Citation Formats
  • MLA
  • APA
  • Chicago
  • BibTeX
  • Save / Share this Record
  • Send to Email