skip to main content

Attention:

The NSF Public Access Repository (NSF-PAR) system and access will be unavailable from 11:00 PM ET on Thursday, May 23 until 2:00 AM ET on Friday, May 24 due to maintenance. We apologize for the inconvenience.


Title: Ti-6Al-4V powder characteristics in laser powder bed fusion: The effect on tensile and fatigue behavior
Award ID(s):
1919818
NSF-PAR ID:
10313689
Author(s) / Creator(s):
; ; ; ;
Date Published:
Journal Name:
Additive Manufacturing
Volume:
51
Issue:
C
ISSN:
2214-8604
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. null (Ed.)
  2. This study investigates the use of hydride-dehydride non-spherical Ti-6Al-4V powders in laser powder bed fusion process and the effects of post-heat-treatments on additively manufactured parts. As-built parts show anisotropic microstructure with α′ martensite and some β phases. Post heat-treated parts exhibit α + β phases, with characteristics dependent on the heat treatment. Heat treatment below β-transus leads to homogenized grain structures with improved corrosion resistance. Electrochemical analysis reveals a very stable corrosion rate due to faster formation of a protective passive layer aided by the fine-structured β phase. X-ray photoelectron spectroscopy examines corrosion behavior and film growth mechanism in saline water. 
    more » « less
  3. null (Ed.)
    Binder Jetting has gained particular interest amongst Additive Manufacturing (AM) techniques because of its wide range of applications, broader feasible material systems, and absence of rapid melting-solidification issues present in other AM processes. Understanding and optimizing printing parameters during the powder spreading process is essential to improve the quality of the final part. In this study, a Discrete Element Method (DEM) simulation is employed to evaluate the powder packing density, flowability, and porosity during powder spreading process utilizing three different powder groups. Two groups are formed with monoidal size distributions (75–84 μm and 100–109 μm), and the third one consisting of a bimodal distribution (50 μm + 100 μm).

    A thorough investigation into the effects of powder size distribution during the powder spreading step in a binder jetting process is conducted using ceramic foundry sand. It was observed that coarser particles result in higher flowability (62% decrease in repose angle) than finer ones due to the cohesion effect present in the latter. A bimodal size distribution yields the highest packing density (8% increase) and lowest porosity (∼12% reduction) in the powder bed, as the finer particles fill in the voids created between the coarser ones. Findings from this study are directly applicable to binder-jetting AM process, and also offer new insights for AM powder manufacturers.

     
    more » « less