Ice at depth in ice-stream shear margins is thought to commonly be temperate, with interstitial meltwater that softens ice. Models that include this softening extrapolate results of a single experimental study in which ice effective viscosity decreased by a factor of ∼3 over water contents of ∼0.01–0.8%. Modeling indicates this softening by water localizes strain in shear margins and through shear heating increases meltwater at the bed, enhancing basal slip. To extend data to higher water contents, we shear lab-made ice in confined compression with a large ring-shear device. Ice rings with initial mean grain sizes of 2–4 mm are kept at the pressure-melting temperature and sheared at controlled rates with peak stresses of ∼0.06–0.20 MPa, spanning most of the estimated shear-stress range in West Antarctic shear margins. Final mean grain sizes are 8–13 mm. Water content is measured by inducing a freezing front at the ice-ring edges, tracking its movement inward with thermistors, and fitting the data with solutions of the relevant Stefan problem. Results indicate two creep regimes, below and above a water content of ∼0.6%. Comparison of effective viscosity values in secondary creep with those of tertiary creep from the earlier experimental study indicate that for water contents of 0.2–0.6%, viscosity in secondary creep is about twice as sensitive to water content than for ice sheared to tertiary creep. Above water contents of 0.6%, viscosity values in secondary creep are within 25% of those of tertiary creep, suggesting a stress-limiting mechanism at water contents greater than 0.6% that is insensitive to ice fabric development in tertiary creep. At water contents of ∼0.6–1.7%, effective viscosity is independent of water content, and ice is nearly linear-viscous. Minimization of intercrystalline stress heterogeneity by grain-scale melting and refreezing at rates that approach an upper bound as grain-boundary water films thicken might account for the two regimes.
more »
« less
Crystal plasticity modeling of ultrasonic softening effect considering anisotropy in the softening of slip systems
- Award ID(s):
- 2019238
- PAR ID:
- 10350211
- Date Published:
- Journal Name:
- International Journal of Plasticity
- Volume:
- 156
- Issue:
- C
- ISSN:
- 0749-6419
- Page Range / eLocation ID:
- 103343
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
The diverse chemical and physical reactions encountered during cooking connect us to science every day. Here, we theoretically and experimentally investigate the swelling and softening of pasta due to liquid imbibition as well as the elastic deformation and adhesion of pasta due to capillary force. As water diffuses into the pasta during cooking, it softens gradually from the outside inward as starch swells and relaxes. The softening follows three sequential regimes: regime I, the hard-glassy region, shows a slow decrease in modulus with cooking time; regime II, the glassy to rubbery transition region, or leathery region, is characterized by a very fast, several orders of magnitude drop in elastic modulus and regime III, the rubbery region, has an asymptotic modulus about four orders of magnitude lower than the raw pasta. We present experiments and theory to capture these regimes and relate them to the heterogeneous microstructure changes associated with swelling. Interestingly, we observe a modulus drop of two orders of magnitude within the range of “al dente” cooking duration, and we find the modulus to be extremely sensitive to the amount of salt added to the boiling water. While most chefs can gauge the pasta by tasting its texture, our proposed experiment, which only requires a measurement with a ruler, can precisely provide an optimal cooking time finely tuned for various kinds of pasta shapes.more » « less
An official website of the United States government

