More Like this

1. Photometric Monitoring of Electronic Cigarette Puff Topography

   https://doi.org/10.3390/s23198220  

   Kolaczyk, Keith; Jiang, Hao (October 2023, Sensors)

   To study and monitor the adverse health consequences of using electronic cigarettes, a user’s puff topography, which are quantification parameters of the user’s vaping habits, plays a central role. In this work, we introduce a topography sensor to measure the mass of total particulate matter generated in every puff and to estimate the nicotine yield. The sensor is compact and low-cost, and is integrated into the electronic cigarette device to promptly and conveniently monitor the user’s daily puff topography. The topography sensor is comprised of a photometric sensor and a pressure sensor. The photometric sensor measures the mass concentration of the aerosol, based on scattering of near-infrared light from airborne particles, while the pressure sensor measures the flow rate. The topography sensor was tested under various conditions including a wide range of atomizer power, puff duration, and inhalation pressure. The sensor’s accuracy was validated by comparing the sensor’s readings with reference measurements, and the results matched closely with the trends reported by existing studies on electronic cigarettes. An example application for tracking a user’s puff topography was also demonstrated. Our topography sensor holds great promise in mitigating the health risks of vaping, and in promoting quality control of electronic cigarette products. 

   more » « less
2. Intrauterine exposure to nicotine through maternal vaping disrupts embryonic lung and skeletal development via the Kcnj2 potassium channel

   https://doi.org/10.1016/j.ydbio.2023.06.002  

   Ozekin, Yunus H.; Saal, Maxwell L.; Pineda, Ricardo H.; Moehn, Kayla; Ordonez-Erives, Madison A.; Delgado Figueroa, Maria F.; Frazier, Caleb; Korth, Kamryn M.; Königshoff, Melanie; Bates, Emily A.; et al (September 2023, Developmental Biology)

   Smoking cigarettes during pregnancy is associated with adverse effects on infants including low birth weight, defective lung development, and skeletal abnormalities. Pregnant women are increasingly turning to vaping [use of electronic (e)-cigarettes] as a perceived safer alternative to cigarettes. However, nicotine disrupts fetal development, suggesting that like cigarette smoking, nicotine vaping may be detrimental to the fetus. To test the impact of maternal vaping on fetal lung and skeletal development in mice, pregnant dams were exposed to e-cigarette vapor throughout gestation. At embryonic day (E)18.5, vape exposed litter sizes were reduced and some embryos exhibited growth restriction compared to air exposed controls. Fetal lungs were collected for histology and whole transcriptome sequencing. Maternally nicotine vaped embryos exhibited histological and transcriptional changes consistent with impaired distal lung development. Embryonic lung gene expression changes mimicked transcriptional changes observed in adult mouse lungs exposed to cigarette smoke, suggesting that the developmental defects may be due to direct nicotine exposure. Fetal skeletons were analyzed for craniofacial and long bone lengths. Nicotine directly binds and inhibits the Kcnj2 potassium channel which is important for bone development. The length of the maxilla, palatal shelves, humerus, and femur were reduced in vaped embryos, which was further exacerbated by loss of one copy of the Kcnj2 gene. Nicotine vapor exposed Kcnj2KO/+ embryos also had significantly lower birth weights than unexposed animals of either genotype. Kcnj2 mutants had severely defective lungs with and without vape exposure, suggesting that potassium channels may be broadly involved in mediating the detrimental developmental effects of nicotine vaping. These data indicate that intrauterine nicotine exposure disrupts fetal lung and skeletal development likely through inhibition of Kcnj2. 

   more » « less
3. Smart Electronic Cigarettes with Built-in Aerosol Sensors

   https://doi.org/10.1109/SENSORS52175.2022.9967159  

   Jiang, Hao (October 2022, 2022 IEEE Sensors)

   This work introduces an emerging application of aerosol sensors integrated inside electronic cigarettes. Using the aerosol sensors, particle size distribution, aerosol temperature, and target chemicals of the generated aerosols are measured before the aerosol is inhaled by a user. When a hazardous aerosol is detected, the user will be warned immediately to stop vaping. With extensive sensor data collected from every puff, an electronic cigarette becomes a smart mobile device, capable of tracking and improving a user's vaping habits. Experimental results on a prototype are presented and have shown great promises towards minimizing the health risks of vaping. 

   more » « less
4. Characterizing the Transient Emission of Particles and Gases from a Single Puff of Electronic Cigarette Smoke

   https://doi.org/10.1021/acs.chemrestox.4c00420  

   Kapiamba, Kashala Fabrice; Achterberg, Steven; Lin, Ta-Chun; Whitefield, Philip D; Huang, Yue-Wern; Wang, Yang (February 2025, Chemical Research in Toxicology)

   This study employed high-time-resolution systems to examine the transient properties of aerosols and gases emitted from electronic cigarette (EC) puffs. Using a fast aerosol sizer, we measured particle size distributions (PSDs) across various EC brands (JUUL, VUSE, VOOPOO), revealing sizes ranging from 5 to 1000 nm at concentrations of 107 to 1010 cm–3. Most aerosols were found to be in the ultrafine range (below 100 nm), with JUUL-, VUSE-, and VOOPOO-producing aerosols with geometric mean sizes of 19.9, 47.3, and 29.4 nm, respectively. Applying the International Commission on Radiological Protection (ICRP) deposition model and assuming no further evolution of aerosols in the respiratory system, we estimated particle deposition in different respiratory regions: 45–60% in the alveolar region, 10–25% in the tracheobronchial region, and 20–35% in the extrathoracic region. The highest single-puff deposition was observed with the VOOPOO device at 60 W, depositing 180.1 ± 7.6 μg in the alveolar region. The gas emissions (CO2, NOx, CO, and total hydrocarbons) were measured at different power settings of the VOOPOO EC. Single-puff NOx and CO levels exceeded the permissible exposure limits of the Occupational Safety and Health Administration, indicating potential acute exposure risks. Higher power settings were correlated with increased gas mixing ratios, suggesting more e-liquid vaporization and possible chemical transformations at higher temperatures. These findings demonstrated significant health risks associated with ultrafine particles from high-power ECs and emphasize the need for advanced measurements to accurately assess their physicochemical properties and potential health implications. 

   more » « less
5. E-cigarette aerosol exposure of pulmonary surfactant impairs its surface tension reducing function

   https://doi.org/10.1371/journal.pone.0272475  

   Graham, Emma; McCaig, Lynda; Shui-Kei Lau, Gloria; Tejura, Akash; Cao, Anne; Zuo, Yi Y.; Veldhuizen, Ruud (November 2022, PLOS ONE)

   Jeyaseelan, Samithamby (Ed.)

   Introduction E-cigarette (EC) and vaping use continue to remain popular amongst teenage and young adult populations, despite several reports of vaping associated lung injury. One of the first compounds that EC aerosols comes into contact within the lungs during a deep inhalation is pulmonary surfactant. Impairment of surfactant’s critical surface tension reducing activity can contribute to lung dysfunction. Currently, information on how EC aerosols impacts pulmonary surfactant remains limited. We hypothesized that exposure to EC aerosol impairs the surface tension reducing ability of surfactant. Methods Bovine Lipid Extract Surfactant (BLES) was used as a model surfactant in a direct exposure syringe system. BLES (2ml) was placed in a syringe (30ml) attached to an EC. The generated aerosol was drawn into the syringe and then expelled, repeated 30 times. Biophysical analysis after exposure was completed using a constrained drop surfactometer (CDS). Results Minimum surface tensions increased significantly after exposure to the EC aerosol across 20 compression/expansion cycles. Mixing of non-aerosolized e-liquid did not result in significant changes. Variation in device used, addition of nicotine, or temperature of the aerosol had no additional effect. Two e-liquid flavours, menthol and red wedding, had further detrimental effects, resulting in significantly higher surface tension than the vehicle exposed BLES. Menthol exposed BLES has the highest minimum surface tensions across all 20 compression/expansion cycles. Alteration of surfactant properties through interaction with the produced aerosol was observed with a basic e-liquid vehicle, however additional compounds produced by added flavourings appeared to be able to increase inhibition. Conclusion EC aerosols alter surfactant function through increases in minimum surface tension. This impairment may contribute to lung dysfunction and susceptibility to further injury. 

   more » « less