An official website of the United States government
Felsic rocks are minor in abundance but occur ubiquitously in International Ocean Discovery Program Hole U1473A, Southwest Indian Ridge. The trace element abundances of high-Ti brown amphibole, plagioclase, and zircon in veins, as well as the presence of myrmekitic texture in the studied felsic rocks support crystallization origin from highly-evolved melts, probably controlled by fractional crystallization. Based on geochemical criteria and texture of the mineral assemblage in felsic rocks and their relationship with host gabbros, they can be divided into three types: (1) Felsic rock with sharp boundaries is formed when felsic melt intrudes into fractures of host gabbros, resulting in minimal interaction between the melt and the wall minerals. (2) Replacive felsic rock, which is characterized by a pseudomorphic replacement of minerals in the host gabbro. This vein type is caused by the replacement of the host mineralogy by minerals in equilibrium with the felsic melts. (3) Felsic rock with diffused boundaries is formed either by infiltration of felsic melt into the solidifying gabbro body or crystallization of interstitial melts. Infiltration modes of felsic melts are likely controlled by the temperature condition of the cooling host gabbros.
more »
« less
Silica‐Rich Vein Formation in an Evolving Stress Field, Atlantis Bank Oceanic Core Complex
Abstract Drilling 809‐m Hole U1473A in the gabbro batholith at the Atlantis Bank Oceanic Core Complex (OCC) found two felsic vein generations: late magmatic fractionates, rich in deuteric water, hosted by oxide gabbros, and anatectic veins associated with dike intrusion and introduction of seawater‐derived volatiles. Microtextures show a change from compressional to tensional stress during vein formation. Temperatures and oxidation state were obtained from amphibole‐plagioclase and oxide pairs in the adjacent gabbros. Type I veins generally have reverse shear‐sense, with restricted ΔFMQ, high Mt/Ilm ratios, and low‐amphibole Cl/F indicating deuteric fluids. They formed during percolation and fractionation of Fe‐Ti‐rich melts into the primary olivine gabbro. Type II veins are usually hosted by olivine gabbro, occur at dike contacts and the margins of normal‐sense shear zones. They are undeformed or weakly deformed, with highly variable ΔFMQ, low Mt/Ilm ratios, and high‐amphibole Cl/F, indicating seawater‐derived fluids. The detachment fault on which the gabbro massif was emplaced rooted near the base of the dike‐gabbro transition beneath the rift valley. The ingress of seawater volatiles began at >800°C and penetrated at least ~590 m into the lower crust during extensional faulting in the rift valley and adjacent rift mountains. The sequence of the felsic vein formation likely reflects asymmetric diapiric flow, with a reversal of the stress regime, and a transition from juvenile to seawater‐derived volatiles. This, in turn, is consistent with fault capture leading to the large asymmetries in spreading rates during OCC formations and heat flow beneath the rift mountains.
more »
« less
- Award ID(s):
- 1637130
- PAR ID:
- 10359846
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Geochemistry, Geophysics, Geosystems
- Volume:
- 21
- Issue:
- 7
- ISSN:
- 1525-2027
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
This paper presents the first detailed geologic map of in situ lower ocean crust; the product of six surveys of Atlantis Bank on the SW Indian Ridge. This combined with major and trace element compositions of primary magmatic phases in 99 seafloor gabbros shows there are both significant vertical and ridge-parallel variations in crustal composition and thickness, but a continuity of the basic stratigraphy parallel to spreading. This stratigraphy is not that of magmatic sedimentation in a large crustal magma chamber. Instead, it is the product of dynamic accretion where the lower crust formed by episodic intrusion, large-scale upward migration of interstitial melt due to crystal mush compaction, and continuous tectonic extension accompanied by hyper- and sub-solidus, crystal-plastic deformation. Five crossings of the gabbro-peridotite contact along the transform wall show that massive mantle peridotite is intruded by cumulate residues of moderately to highly evolved magmas, few of which could be even close to equilibrium with a primary mantle magma. This contact then does not represent the crust-mantle boundary as envisaged in the ophiolite analog for ocean crust. The residues of the magmas parental to the shallow crust must also lie beneath the center of the complex. This, and the nearly complete absence of dunites in peridotites from the transform wall, shows that melt transport through the shallow lithosphere was largely restricted to the central region of the paleo-ridge segment. There is almost no evidence for a melt lens or high-level storage of primitive melt in the upper 1500 m of Atlantis Bank. Thus, the composition of associated mid-ocean ridge basalt appears largely controlled by fractional crystallization of primitive cumulates at depth, near or at the base of the crust, modified somewhat by melt-rock reaction during transport through the overlying cumulate pile to the seafloor. Inliers of the dike-gabbro transition show that the uppermost gabbros crystallized at depth and were then emplaced upward, as they cooled, into the zone of diking. ODP and IODP drilling along the center of the gabbro massif also found few primitive gabbros that could have been in equilibrium with the original overlying lavas. Evidence of large-scale upward, permeable transport of interstitial melt through the gabbros is ubiquitous. Thus, post-cumulus processes, including extensive reaction, dissolution, and re-precipitation within the cumulate pile have obscured nearly all evidence of earlier primitive origins. We suggest that many of the gabbros may have started as primitive cumulates but were hybridized and transformed by later, migrating melts to evolved compositions, even as they ascended to higher levels, while new primitive cumulates were emplaced near the base of the crust. Mass balance for a likely parental melt intruded from the mantle to form the crust, however, requires that such primitive cumulates must exist at depth beneath Atlantis Bank at the center of the magmatic complex. The Atlantis Bank Gabbro Massif accreted by direct magma intrusion into the lower crust, followed by upward diapiric flow, first as a crystal mush, then by solid-state, crystal-plastic deformation, and finally by detachment faulting to the sea floor. The strongly asymmetric spreading to the south, parallel to the transform, was due to fault capture, with the bounding faults on the northern rift valley wall cut off by the detachment fault, which extended across the zone of intrusion causing rapid migration of the plate boundary to the north.more » « less
-
Abstract Amphibole is a common hydrous mineral in mantle rocks. To better understand processes leading to the formation of amphibole‐bearing peridotites and pyroxenites in the lithospheric mantle, we conducted experiments by juxtaposing a lherzolite against hydrous basaltic melts in Au‐Pd capsules. Two melts were examined, a basaltic andesite and a basalt, each containing 4 wt% of water. The experiments were run at 1200°C and 1 GPa for 3 or 12 h, and then cooled to 880°C and 0.8 GPa over 49 h. The reaction at 1200°C produced a melt‐bearing orthopyroxenite‐dunite sequence. Crystallization of the partially reacted melts during cooling lead to the formation of an amphibole‐bearing gabbronorite‐orthopyroxenite‐peridotite sequence. Orthopyroxene in the peridotite and orthopyroxenite has a poikilitic texture enclosing olivines and spinels. Amphibole in the peridotite occurs interstitial to olivine, orthopyroxene, clinopyroxene, and spinel. Comparisons of texture and mineral compositions in the experimental products with those from field observations allow a better understanding of hydrous melt‐rock reaction in the lithospheric mantle. Amphibole‐bearing pyroxenite veins (or dikes) can be formed in the lithospheric mantle or at the crust‐mantle boundary by interaction between hydrous melt and peridotite and subsequent crystallization. Hornblendite or amphibole gabbronorite can be formed in the veins when the flux of hydrous melt is high. Differences in reacting melt and peridotite compositions are responsible for the variation in amphibole composition in mantle xenoliths from different tectonic settings. The extent of melt‐rock reaction is a factor that control amphibole composition across the amphibole‐bearing vein and the host peridotite.more » « less
-
are earth elements (REE) are becoming increasingly important in modern society due to their numerous uses in manufacturing of components for green and high-tech energy industries. Studying the mechanisms of REE mineral formation in geologic systems is vital for understanding where and how these mineral deposits form. Previous studies of REE mineral deposits have shown that hydrothermal fluids can play a key role in the mobilization and enrichment of REE (Williams-Jones et al., 2000; Gysi et al., 2016; Vasyukova and Williams-Jones, 2018). Fluorite is ideal to study the behavior of REE because of their compatibility in its structure and it is a ubiquitous hydrothermal vein mineral found together with REE fluorocarbonates (i.e., bastnäsite and parisite). However, the controls on hydrothermal fluid-mineral REE partitioning in these deposits are not yet fully understood. In this study, we present petrographic observations of fluorite veins and fluid inclusions from the Gallinas Mountains REE-bearing fluorite veins/breccia deposit in New Mexico (McLemore, 2010; Williams-Jones et al. 2000). The Gallinas Mountains deposit notably contains hydrothermal fluorite and bastnäsite, and is associated with ~30 Ma alkaline igneous rocks intruded into Permian sedimentary rocks (McLemore, 2010). The goal of this study is to better understand the cause of REE variations in fluorite as a function of temperature and salinity of the fluids, and to determine how the REE concentrations change in barren and mineralized veins. Optical microscopy and cold-cathode cathodoluminescence (CL) is used to distinguish different fluorite generations and fluid inclusion types. Scanning electron microscopy (SEM) is used to identify REE minerals, zonation in fluorite, and acquire elemental compositions of different vein minerals.more » « less
-
Brittle faults are widespread but rarely exposed in Marie Byrd Land, a part of the West Antarctic rift system, owing to enhanced erosion of zones of cataclasis by the regional ice sheet. Tourmaline-mineralized faults discovered at three locations in the Ford Ranges constitute a new record of fluid-rock interactions in this region of extended crust. Tourmaline resists re-equilibration, even during metamorphism, thus strongly aligned tourmaline from high-angle faults at Mt. Douglass, Mt. Dolber, and Lewissohn Nunatak likely contain direct records of fault-hosted fluids and timing of fault movements. The faults form an array oriented NNW-SSE and WNW-ESE, which displays brittle kinematic criteria indicating normal-oblique and strike-oblique displacement. Mirrored fault surfaces suggest formation during seismic slip. Tourmaline is concentrated within a 2 to 4 mm zone bordering the fault planes. Petrography and EMPA analyses show unzoned tourmaline , with the dravite variety at Lewissohn Nunatak and schorl at the other two sites. Fluid inclusions in dravite are tubular (A-axis-parallel), 10 to 15 um, and up to 25 um, in length, containing gas and fluid phases. Fluid inclusions in schorl are C-axis-parallel and breached. Tourmaline ∂18O ratios (n=4) range from 9.2 to 10.4 ± 0.1 ‰ VSMOW (average 9.7‰, s.dev. = 0.7). Paired quartz yield ∂18O values of 11.1 to 10.3 ± 0.1 ‰, and ∆Qtz-Trm values between 1.3 and 2.0. Brittle microfractures in parallel arrays, evident in thin section, indicate tensile opening along ENE- WSW axes, in accordance with outcrop evidence. The strong preferred orientation and uniform mineral composition of tourmaline indicate syntectonic growth of tourmaline along fault planes. ∆Qtz-Trm values suggest equilibration between host-rock quartz and tourmaline was not achieved, likely due to rapid tourmaline precipitation. Relative isotopic homogeneity between sites suggests similar fluid conditions across the region, for crust underlying a minimum area of 2000 km2. Preliminary results of tourmaline 40Ar/39Ar dating indicate broadly Cretaceous timing for fault-related fluid flow. Ongoing work seeks to determine the temperature of mineralizing fluids and evaluate whether the brittle array localizes geothermal heat beneath the contemporary icesheet.more » « less
