An official website of the United States government
Abstract To investigate how bedrock transforms to soil, we mapped the topography of the interface demarcating onset of weathering under an east‐west trending shale watershed in the Valley and Ridge province in the USA Using wave equation travel‐time tomography from a seismic array of >4,000 geophones, we obtained a 3D P‐wave velocity (Vp) model that resolves structures ∼20 m below land surface (mbls). The depth of mobile soil and the onset of dissolution of chlorite roughly match Vp = 600 m/s and Vp = 2,700 m/s, respectively. Chlorite dissolution initiates porosity growth in the shale matrix. Depth to the 2,700 m/s contour is greater under the N‐ as compared to S‐facing hillslopes and under sub‐planar as compared to concave‐up land surfaces. Broadly, the geometries of the ‘soil’ and ‘chlorite’ Vp contours are consistent with the calculated potential for shear fracture opening under weak regional compression. However, this calculated fracture potential does not consistently explain observations related to N‐ versus S‐facing aspect nor fracture density observed by borehole televiewer. Apparently, regional compression is only a secondary influence on Vp: the primary driver of P‐wave slowing in the upper layers of this catchment is topographic control of reactive water flowpaths and their integrated effects on weathering. The Vp result is best explained as the long‐term integrated effect of groundwater flow‐induced geochemical weathering of shale in response to climate‐driven patterns of micro‐ and macro‐topography.
more »
« less
Seismic Imaging of a Shale Landscape Under Compression Shows Limited Influence of Topography‐Induced Fracturing
Abstract We used seismic refraction to image the P‐wave velocity structure of a shale watershed experiencing regional compression in the Valley and Ridge Province (USA). From estimates showing strong compressional stress, we expected the depth to unweathered bedrock to mirror the hill‐valley‐hill topography (“bowtie pattern”) by analogy to seismic velocity patterns in crystalline bedrock in the North American Piedmont that also experience compression. Previous researchers used failure potentials calculated for strong compression in the Piedmont to suggest fractures are open deeper under hills than valleys to explain the “bowtie” pattern. Seismic images of the shale watershed, however, show little evidence of such a “bowtie.” Instead, they are consistent with weak (not strong) compression. This contradiction could be explained by the greater importance of infiltration‐driven weathering than fracturing in determining seismic velocities in shale compared to crystalline bedrock, or to local perturbations of the regional stress field due to lithology or structures.
more »
« less
- PAR ID:
- 10360602
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Geophysical Research Letters
- Volume:
- 48
- Issue:
- 17
- ISSN:
- 0094-8276
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract In this study, we present direct field measurements of modern lateral and vertical bedrock erosion during a 2‐year study period, and optically stimulated luminescence (OSL) ages of fluvial material capping a flat bedrock surface at Kings Creek located in northeast Kansas, USA. These data provide insight into rates and mechanisms of bedrock erosion and valley‐widening in a heterogeneously layered limestone‐shale landscape. Lateral bedrock erosion outpaced vertical incision during our 2‐year study period. Modern erosion rates, measured at erosion pins in limestone and shale bedrock reveal that shale erosion rate is a function of wetting and drying cycles, while limestone erosion rate is controlled by discharge and fracture spacing. Variability in fracture spacing amongst field sites controls the size of limestone block collapse into the stream, which either allowed continued lateral erosion following rapid detachment and transport of limestone blocks, or inhibited lateral erosion due to limestone blocks that protected the valley wall from further erosion. The OSL ages of fluvial material sourced from the strath terrace were older than any material previously dated at our study site and indicate that Kings Creek was actively aggrading and incising throughout the late Pleistocene. Coupling field measurements and observations with ages of fluvial terraces can be useful to investigate the timing and processes linked to how bedrock rivers erode laterally over time to form wide bedrock valleys.more » « less
-
Abstract More above‐ground biomass (kg m−2) grows in the northern Appalachian Mountains (USA) in forests on shale than on sandstone at all landscape positions other than ridgetops. This has been tentatively attributed to physical (rather than chemical) attributes of the substrates, such as elevation, particle size, and water capacity. However, shales have generally similar phosphorus (P) concentrations to sandstones and, in the Valley and Ridge province, they erode more quickly. This led us to hypothesize that faster replenishment of the lithogenic nutrient P in shale soils through erosion + soil production could instead control the differences in biomass. To test this, soils and foliage from 10 sites on shales and sandstones in the northern Appalachians from roughly the same elevation and aspect were analysed. We discovered that, when controlling for location, concentrations of bioavailable P in soils and P in foliage were higher and P resorbed from senescing red oak leaves was lower on slower‐eroding sandstone than on faster‐eroding shale. Lower resorption generally can be attributed to lower P limitation for trees. Further investigation of weathering and erosion on one of the sandstone–shale pairs within a larger, paired watershed study revealed that the differences in P concentrations in biomass and foliage between lithologies likely developed because sandstones act as ‘collectors’ that trap nutrients from residual and exogenous sources, while shales erode quickly and thus promote production of soil from bedrock that releases P to ecosystems. We concluded that the combined effects of differential rates of dust collection and erosion results in roughly equal biomass growing on sandstone and shale ridgetops. This work emphasizes the balance between a landscape's capacity to collect dust versus produce soil in controlling bioavailability of nutrients.more » « less
-
Abstract Understanding how soil thickness and bedrock weathering vary across ridge and valley topography is needed to constrain the flowpaths of water and sediment production within a landscape. Here, we investigate saprolite and weathered bedrock properties across a ridge‐valley system in the Northern California Coast Ranges, USA, where topography varies with slope aspect such that north‐facing slopes have thicker soils and are more densely vegetated than south‐facing slopes. We use active source seismic refraction surveys to extend observations made in boreholes to the hillslope scale. Seismic velocity models across several ridges capture a high velocity gradient zone (from 1,000 to 2,500 m/s) located ∼4–13 m below ridgetops that coincides with transitions in material strength and chemical depletion observed in boreholes. Comparing this transition depth across multiple north‐ and south‐facing slopes, we find that the thickness of saprolite does not vary with slope aspects. Additionally, seismic survey lines perpendicular and parallel to bedding planes reveal weathering profiles that thicken upslope and taper downslope to channels. Using a rock physics model incorporating seismic velocity, we estimate the total porosity of the saprolite and find that inherited fractures contribute a substantial amount of pore space in the upper 6 m, and the lateral porosity structure varies strongly with hillslope position. The aspect‐independent weathering structure suggests that the contemporary critical zone structure at Rancho Venada is a legacy of past climate and vegetation conditions.more » « less
-
Abstract Shallow bedrock strength controls both landslide hazard and the rate and form of erosion, yet regional patterns in near‐surface mechanical properties are rarely known quantitatively due to the challenge in collectingin situmeasurements. Here we present seismic and geomechanical characterizations of the shallow subsurface across the central Himalayan Range in Nepal. By pairing widely distributed 1D shear wave velocity surveys and engineering outcrop descriptions per the Geological Strength Index classification system, we evaluate landscape‐scale patterns in near‐surface mechanical characteristics and their relation to environmental factors known to affect rock strength. We find that shallow bedrock strength is more dependent on the degree of chemical and physical weathering, rather than the mineral and textural differences between the metamorphic lithologies found in the central Himalaya. Furthermore, weathering varies systematically with topography. Bedrock ridge top sites are highly weathered and have S‐wave seismic velocities and shear strength characteristics that are more typical of soils, whereas sites near valley bottoms tend to be less weathered and characterized by high S‐wave velocities and shear strength estimates typical of rock. Weathering on hillslopes is significantly more variable, resulting in S‐wave velocities that range between the ridge and channel endmembers. We speculate that variability in the hillslope environment may be partly explained by the episodic nature of mass wasting, which clears away weathered material where landslide scars are recent. These results underscore the mechanical heterogeneity in the shallow subsurface and highlight the need to account for variable bedrock weathering when estimating strength parameters for regional landslide hazard analysis.more » « less
