skip to main content

Explore Research Products in the NSF-PAR

Title: Organic acid evaporation kinetics from aqueous aerosols: implications for aerosol buffering capacity in the atmosphere
The acidity of atmospheric aerosols controls their impacts on heterogeneous and multiphase reactions, cloud formation, and human health. Recently, it has been shown that multiphase buffering can shift aerosol pH substantially compared to bulk solutions. Here, we highlight a unique type of multiphase buffering for aerosols that occurs when organic acids partition from aqueous salt aerosols upon acidification with a strong acid. In this case, rather than lowering the pH of the aerosol, titration with strong acids lowers the organic fraction within the aerosol while maintaining constant pH. We investigate evaporation rates for the model system lactic acid as well as other atmospherically-relevant species such as acetic, butyric, and methacrylic acids. We demonstrate that the timescales for evaporation of organic acids from aerosols are on the order of minutes, comparable to acidification rates in the atmosphere. The organic acid evaporation we observe for lactic acid in salt aerosols is enhanced compared to bulk measurements within what is expected based on differences in surface to volume ratios, indicating surface effects are important. In addition, we show that a salting-out effect drives small organic molecules to the surface, where they quickly evaporate, reducing acidity and causing a “superbuffering” effect. Our results can explain why aerosols in the pH range from 2 to 4 are able to resist further acidification by strong acids in the atmosphere. Overall, this work highlights unique properties of concentrated aerosols and demonstrates how inorganic ions and organic compounds together control multiphase buffering in the atmosphere.  more » « less
Award ID(s):
1801971
NSF-PAR ID:
10397573
Author(s) / Creator(s):
; ;
Date Published:
Journal Name:
Environmental Science: Atmospheres
Volume:
3
Issue:
2
ISSN:
2634-3606
Page Range / eLocation ID:
316 to 327
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. ; ; ; ; ; ; ; ( , Chemical Science)
    null (Ed.)
    The partitioning of medium-chain fatty acid surfactants such as nonanoic acid (NA) between the bulk phase and the air/water interface is of interest to a number of fields including marine and atmospheric chemistry. However, questions remain about the behavior of these molecules, the contributions of various relevant chemical equilibria, and the impact of pH, salt and bulk surfactant concentrations. In this study, the surface adsorption of nonanoic acid and its conjugate base is quantitatively investigated at various pH values, surfactant concentrations and the presence of salts. Surface concentrations of protonated and deprotonated species are dictated by surface-bulk equilibria which can be calculated from thermodynamic considerations. Notably we conclude that the surface dissociation constant of soluble surfactants cannot be directly obtained from these experimental measurements, however, we show that molecular dynamics (MD) simulation methods, such as free energy perturbation (FEP), can be used to calculate the surface acid dissociation constant relative to that in the bulk. These simulations show that nonanoic acid is less acidic at the surface compared to in the bulk solution with a p K a shift of 1.1 ± 0.6, yielding a predicted surface p K a of 5.9 ± 0.6. A thermodynamic cycle for nonanoic acid and its conjugate base between the air/water interface and the bulk phase can therefore be established. Furthermore, the effect of salts, namely NaCl, on the surface activity of protonated and deprotonated forms of nonanoic acid is also examined. Interestingly, salts cause both a decrease in the bulk p K a of nonanoic acid and a stabilization of both the protonated and deprotonated forms at the surface. Overall, these results suggest that the deprotonated medium-chain fatty acids under ocean conditions can also be present within the sea surface microlayer (SSML) present at the ocean/atmosphere interface due to the stabilization effect of the salts in the ocean. This allows the transfer of these species into sea spray aerosols (SSAs). More generally, we present a framework with which the behavior of partially soluble species at the air/water interface can be predicted from surface adsorption models and the surface p K a can be predicted from MD simulations. 
    more » « less
  2. ; ; ; ; ; ; ; ; ; ; et al ( , Proceedings of the National Academy of Sciences)
    null (Ed.)
    Aerosols impact climate, human health, and the chemistry of the atmosphere, and aerosol pH plays a major role in the physicochemical properties of the aerosol. However, there remains uncertainty as to whether aerosols are acidic, neutral, or basic. In this research, we show that the pH of freshly emitted (nascent) sea spray aerosols is significantly lower than that of sea water (approximately four pH units, with pH being a log scale value) and that smaller aerosol particles below 1 μm in diameter have pH values that are even lower. These measurements of nascent sea spray aerosol pH, performed in a unique ocean−atmosphere facility, provide convincing data to show that acidification occurs “across the interface” within minutes, when aerosols formed from ocean surface waters become airborne. We also show there is a correlation between aerosol acidity and dissolved carbon dioxide but no correlation with marine biology within the seawater. We discuss the mechanisms and contributing factors to this acidity and its implications on atmospheric chemistry. 
    more » « less
  3. ; ; ; ; ; ; ; ; ; ; et al ( , 2022 AGU Fall Meeting)
    Isoprene has a strong effect on the oxidative capacity of the troposphere due to its abundance. Under low-NOx conditions, isoprene oxidizes to form isoprene-derived epoxydiols (IEPOX), contributing significantly to secondary organic aerosol (SOA) through heterogeneous reactions. In particular, organosulfates (OSs) can form from acid-driven reactive uptake of IEPOX onto preexisting particles followed by nucleophilic addition of inorganic sulfate, and they are an important component of SOA mass, primarily in submicron particles with long atmospheric lifetimes. Fundamental understanding of SOA and OS evolution in particles, including the formation of new compounds by oxidation as well as corresponding viscosity changes, is limited, particularly across relative humidity (RH) conditions above and below the deliquescence of typical sulfate aerosol particles. In a 2-m3 indoor chamber held at various RH values (30 – 80%), SOA was generated from reactive uptake of gas-phase IEPOX onto acidic ammonium sulfate aerosols (pH = 0.5 – 2.5) and then aged in an oxidation flow reactor (OFR) for 0 – 24 days of equivalent atmospheric ·OH exposure. We investigated the extent of inorganic sulfate conversion to organosulfate, formation of oligomers, single-particle physicochemical properties, such as viscosity and phase state, and oxidation kinetics. Chemical composition of particle-phase species, as well as aerosol morphological changes, are analyzed as a function of RH, oxidant exposure times, and particle acidity to better understand SOA and OS formation and destruction mechanisms in the ambient atmosphere. 
    more » « less
  4. ; ; ; ; ; ; ; ; ; ; et al ( , Atmospheric Chemistry and Physics)
    Abstract. Acidity, defined as pH, is a central component of aqueouschemistry. In the atmosphere, the acidity of condensed phases (aerosolparticles, cloud water, and fog droplets) governs the phase partitioning ofsemivolatile gases such as HNO3, NH3, HCl, and organic acids andbases as well as chemical reaction rates. It has implications for theatmospheric lifetime of pollutants, deposition, and human health. Despiteits fundamental role in atmospheric processes, only recently has this fieldseen a growth in the number of studies on particle acidity. Even with thisgrowth, many fine-particle pH estimates must be based on thermodynamic modelcalculations since no operational techniques exist for direct measurements.Current information indicates acidic fine particles are ubiquitous, butobservationally constrained pH estimates are limited in spatial and temporalcoverage. Clouds and fogs are also generally acidic, but to a lesser degreethan particles, and have a range of pH that is quite sensitive toanthropogenic emissions of sulfur and nitrogen oxides, as well as ambientammonia. Historical measurements indicate that cloud and fog droplet pH haschanged in recent decades in response to controls on anthropogenicemissions, while the limited trend data for aerosol particles indicateacidity may be relatively constant due to the semivolatile nature of thekey acids and bases and buffering in particles. This paper reviews andsynthesizes the current state of knowledge on the acidity of atmosphericcondensed phases, specifically particles and cloud droplets. It includesrecommendations for estimating acidity and pH, standard nomenclature, asynthesis of current pH estimates based on observations, and new modelcalculations on the local and global scale. 
    more » « less
  5. ; ; ; ; ; ; ( , ACS Earth and Space Chemistry)
    Blum, Joel (Ed.)
    Atmospheric oxidation of isoprene yields large quantities of highly water-soluble isoprene epoxydiols (IEPOX) that partition into fogs, clouds, and wet aerosols. In aqueous aerosols, the acid-catalyzed ring-opening of IEPOX followed by nucleophilic addition of inorganic sulfate or water forms organosulfates and 2-methyltetrols, respectively, contributing substantially to secondary organic aerosol (SOA). However, the fate of IEPOX in clouds, fogs, and evaporating hydrometeors is not well understood. Here we investigate the rates, product branching ratios, and stereochemistry of organosulfates from reactions of dilute IEPOX (5–10 mM) under a range of sulfate concentrations (0.3–50 mM) and pH values (1.83–3.38) in order to better understand the fate of IEPOX in clouds and fogs. From these aqueous dark reactions of β-IEPOX isomers (trans- and cis-2-methyl-2,3-epoxybutane-1,4-diols), which are the predominant IEPOX isomers, products were identified and quantified using hydrophilic interaction liquid chromatography coupled to an electrospray ionization high-resolution quadrupole time-of-flight mass spectrometer operated in negative ion mode (HILIC/(−)ESI-HR-QTOFMS). We found that the regiochemistry and stereochemistry were affected by pH, and the tertiary methyltetrol sulfate (C5H12O7S) was promoted by increasing solution acidity. Furthermore, the rate constants for the reaction of IEPOX under cloud-relevant conditions are up to 1 order of magnitude lower than reported in the literature for aerosol-relevant conditions due to a markedly different solution activities. Nevertheless, the contribution of cloud and fog water reactions to IEPOX SOA may be significant in cases of lower aqueous-phase pH (model estimate) or during droplet evaporation (not studied). 
    more » « less
  • Citation Formats
  • MLA
  • APA
  • Chicago
  • BibTeX
  • Save / Share this Record
  • Send to Email