Abstract Mount St. Helens (MSH) lies in the forearc of the Cascades where conditions should be too cold for volcanism. To better understand thermal conditions and magma pathways beneath MSH, data from a dense broadband array are used to produce high‐resolution tomographic images of the crust and upper mantle. Rayleigh‐wave phase‐velocity maps and three‐dimensional images of shear velocity (Vs), generated from ambient noise and earthquake surface waves, show that west of MSH the middle‐lower crust is anomalously fast (3.95 ± 0.1 km/s), overlying an anomalously slow uppermost mantle (4.0–4.2 km/s). This combination renders the forearc Moho weak to invisible, with crustal velocity variations being a primary cause; fast crust is necessary to explain the absent Moho. Comparison with predicted rock velocities indicates that the fast crust likely consists of gabbros and basalts of the Siletzia terrane, an accreted oceanic plateau. East of MSH where magmatism is abundant, middle‐lower crustVsis low (3.45–3.6 km/s), consistent with hot and potentially partly molten crust of more intermediate to felsic composition. This crust overlies mantle with more typical wave speeds, producing a strong Moho. The sharp boundary in crust and mantleVswithin a few kilometers of the MSH edifice correlates with a sharp boundary from low heat flow in the forearc to high arc heat flow and demonstrates that the crustal terrane boundary here couples with thermal structure to focus lateral melt transport from the lower crust westward to arc volcanoes.
more »
« less
Segmentation and Radial Anisotropy of the Deep Crustal Magmatic System Beneath the Cascades Arc
Abstract Volcanic arcs consist of many distinct vents that are ultimately fueled by the common melting processes in the subduction zone mantle wedge. Seismic imaging of crustal‐scale magmatic systems can provide insight into how melt is organized in the deep crust and eventually focused beneath distinct vents as it ascends and evolves. Here, we investigate the crustal‐scale structure beneath a section of the Cascades arc spanning four major stratovolcanoes: Mt. Hood, Mt. St. Helens (MSH), Mt. Adams (MA), and Mt. Rainier, based on ambient noise data from 234 seismographs. Simultaneous inversion of Rayleigh and Love wave dispersion constrains the isotropic shear velocity (Vs) and identifies radially anisotropic structures. IsotropicVsshows two sub‐parallel low‐Vszones (∼3.45–3.55 km/s) at ∼15–30 km depth with one connecting Mt. Rainier to MA, and another connecting MSH to Mt. Hood, which are interpreted as deep crustal magma reservoirs containing up to ∼2.5%–6% melt, assuming near‐equilibrium melt geometry. Negative radial anisotropy, from vertical fractures like dikes, is prevalent in this part of the Cascadia, but is interrupted by positive radial anisotropy, from subhorizontal features like sills, extending vertically beneath MA and Mt. Rainier at ∼10–30 km depth and weaker and west‐dipping positive anisotropy beneath MSH. The positive anisotropy regions are adjacent to rather than co‐located with the isotropic low‐Vsanomalies. Ascending melt that stalled and mostly crystallized in sills with possible compositional differences from the country rock may explain the near‐averageVsand positive radial anisotropy adjacent to the active deep crustal magma reservoirs.
more »
« less
- Award ID(s):
- 1948834
- PAR ID:
- 10400201
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Geochemistry, Geophysics, Geosystems
- Volume:
- 24
- Issue:
- 3
- ISSN:
- 1525-2027
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
The Santorini arc volcano in the Hellenic subduction zone has a history of caldera-forming Plinian eruptions, most recently in the Late Bronze Age 3.4 kya, and it remains volcanically active. To inform volcanic hazard assessments, it is crucial to understand where melt is distributed. The PROTEUS experiment in 2015 recorded >14,000 controlled marine sound sources on 165 land and seafloor seismic stations. Tomographic inversion of this data revealed low P-wave velocities in the upper 4 kilometers beneath the caldera and nearby Kolumbo seamount interpreted as the magma system (McVey et al., 2020; Chrapkewiecz et al., 2022). However, structure of the magma system was only determined in the upper (<4-6km) crust and melt content is only weakly constrained. In this study we improve constraints on the deeper magma system and subsurface melt content with a tomographic P and S wave velocity structure. To do so, we add to the inverse problem arrival times from ~1500 local earthquakes with magnitudes from 0.5 to 3.0 that occurred between 5 and 20 km depth. The events were recorded on 142 3-component ocean bottom and island seismic stations that span the seafloor ~60 km west and east of the island and the nearby islands. Results beneath Santorini and Kolumbo suggest that the upper crustal magma reservoirs extend deeper than previously found, and we image a high Vp layer (~5-8 km) under the magma reservoir at Kolumbo. We identify this layer as strong, cooled, intruded magma and correlate it to the location of earthquakes, within which, swarms of rapidly upward propagating seismicity support prior inferences of melt conduits traversing a rheologically strong layer (Schmid et al, 2022). We give values for melt content of the upper crustal reservoirs using a scaled Vp/Vs model. Since the number of arrivals, apriori assigned uncertainty, and differences in ray geometry can result in P and S waves with different resolving power, we use measured resolution to scale the Vs perturbations and create a more realistic Vp/Vs model. The addition of earthquake arrivals allows us to map the magma reservoirs beneath the Santorini-Kolumbo magma system to 8 km depth and identify regions of elevated melt content.more » « less
-
Abstract The architecture of magma plumbing systems plays a fundamental role in volcano eruption and evolution. However, the precise configuration of crustal magma reservoirs and conduits responsible for supplying eruptions are difficult to explore across most active volcanic systems. Consequently, our understanding of their correlation with eruption dynamics is limited. Axial Seamount is an active submarine volcano located along the Juan de Fuca Ridge, with known eruptions in 1998, 2011, and 2015. Here we present high-resolution images of P-wave velocity, attenuation, and estimates of temperature and partial melt beneath the summit of Axial Seamount, derived from multi-parameter full waveform inversion of a 2D multi-channel seismic line. Multiple magma reservoirs, including a newly discovered western magma reservoir, are identified in the upper crust, with the maximum melt fraction of ~15–32% in the upper main magma reservoir (MMR) and lower fractions of 10% to 26% in other satellite reservoirs. In addition, a feeding conduit below the MMR with a melt fraction of ~4–11% and a low-velocity throat beneath the eastern caldera wall connecting the MMR roof with eruptive fissures are imaged. These findings delineate an asymmetric shallow plumbing system beneath Axial Seamount, providing insights into the magma pathways that fed recent eruptions.more » « less
-
Quantitative estimates of magma storage are fundamental to evaluating volcanic dynamics and hazards. Yet our understanding of subvolcanic magmatic plumbing systems and their variability remains limited. There is ongoing debate regarding the ephemerality of shallow magma storage and its volume relative to eruptive output, and so whether an upper-crustal magma body could be a sign of imminent eruption. Here we present seismic imaging of subvolcanic magmatic systems along the Cascade Range arc from systematically modelling the three-dimensional scattered wavefield of teleseismic body waves. This reveals compelling evidence of low-seismic-velocity bodies indicative of partial melt between 5 and 15 km depth beneath most Cascade Range volcanoes. The magma reservoirs beneath these volcanoes vary in depth, size and complexity, but upper-crustal magma bodies are widespread, irrespective of the eruptive flux or time since the last eruption of the associated volcano. This indicates that large volumes of melts can persist at shallow depth throughout eruption cycles beneath large volcanoes.more » « less
-
null (Ed.)Caldera footprints and erupted magma volumes provide a unique constraint on vertical dimensions of upper crustal magma reservoirs that feed explosive silicic eruptions. Here we define a Vertical Separation (VS) ratio in which we compare the geometric vertical extent with the range of depths indicated petrologically by melt inclusion water and CO2 saturation pressures for fifteen caldera-forming eruptions spanning ∼10^0 km3 to ∼10^3 km3 in volume. We supplement melt inclusion saturation pressures with rhyolite-MELTS barometry and plagioclase-melt hygrometry to generate a petrologic image of magma reservoir architecture. We find that pre-eruptive upper crustal magma reservoirs range from contiguous bodies (where petrologic and geometric estimates match closely) to vertically dispersed structures. Vertically dispersed pre-eruptive reservoirs are more common among intermediate-volume eruptions than among the smallest and largest caldera-forming eruptions. We infer that the architecture of magma reservoirs tracks the thermomechanical evolution of large volcanic systems.more » « less