An official website of the United States government
The City of Columbus, Ohio is implementing a tunnel system to reduce the number of episodes of combined sewer overflows into the Scioto River. The tunnel systems provide relief to the existing Olentangy Scioto Interceptor Sewer. Two new tunnels being implemented are the OSIS Augmentation and Relief Sewer (OARS), in service since July 2017, and the Lower Olentangy Tunnel (LOT) that is planned to be in service in 2025. The performance of these tunnels in respect to high inflow conditions was investigated with the use of the HAST mixed flow model and the OpenFOAM CFD model to determine the magnitude of surges, the possibility of air pocket entrapment, air–water surging, and the consequences of uncontrolled air pocket releases through shafts. Inflows into the systems were obtained from a calibrated collection system SWMM model. Modeling results quantified surging in the tunnel dropshafts and their mitigation from built-in surge control chambers. HAST simulations also pointed to locations where air pockets could form. These results were used in OpenFOAM to determine the effects of uncontrolled air release through the shaft that links the two tunnels. It was shown that proper ventilation at the shaft will mitigate the growth of air phase pressure to damaging levels.
more »
« less
Experimental Study of Geysering in an Upstream Vertical Shaft
Transient flows in stormwater systems can lead to damaging and dangerous operational conditions, as exemplified by geysering events created by the uncontrolled release of entrapped air pockets. Extreme rain and associated rapid inflows may result in air pocket entrapment, which causes significant changes in flow conditions and potentially geysering. Stormwater geysers have been studied in different experimental and numerical modeling studies, as well as from limited data gathered within real systems. However, there is still no complete understanding of geysering events, as stormwater system geometries vary considerably. Most past studies involved releasing air from an intermediate shaft, in which a significant fraction of the entrapped air may bypass the release. This work advances the understanding of geysering by considering uncontrolled air release through an upstream shaft or manhole. In such cases, the entire air pocket is released upon reaching the shaft, worsening the occurrence of geysering. Pressure and water level measurements were performed for various combinations of initial water pressure, trapped air pocket volume, and vertical shaft geometries, indicating the higher severity of these geysering events. The results obtained also corroborate previous studies in that the measured pressure heads were lower than the grade elevation. Future studies should include larger-scale testing and the representation of this geometry using CFD.
more »
« less
- Award ID(s):
- 2048607
- PAR ID:
- 10418824
- Date Published:
- Journal Name:
- Water
- Volume:
- 15
- Issue:
- 9
- ISSN:
- 2073-4441
- Page Range / eLocation ID:
- 1740
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Urban expansion and the increasing frequency and intensity of extreme precipitation events bring new challenges to stormwater collection systems. One underrecognized issue is the occurrence of transient flow conditions that lead to adverse multiphase flow interactions (AMFI): essentially, the formation, collapse, and uncontrolled release of air pockets within stormwater system flows. While the fundamental physics of AMFI have been evaluated in laboratory experiments and idealized modeling studies, much less is known about their development in real or simulated stormwater networks, and about the roles played by rainfall and network properties. A necessary precursor to AMFI is the development of pressurized flow conditions within a network. The goal of this study is to understand how spatiotemporal rainfall variability affects the occurrence of pressurized conditions in a stormwater drainage network in the Richmond district of San Francisco, California. High-resolution bias-corrected radar rainfall fields for 24 recent storms were used as the independent variable of EPA-SWMM simulations. Model analyses indicate that the incidence of pressurized flow increases with storm intensity and is more sensitive to rainfall temporal variability than spatial variability. This research provides a reference for analyzing AMFI precursors in other networks and may have important implications for the improvement of stormwater infrastructures.more » « less
-
Stormwater control measures (SCMs) such as retention basins, bioswales, and bioinfiltration systems are used to reduce peak flows and remove pollutants from stormwater in temperate urban landscapes. However, the application of de-icing salts to roadways can substantially increase the salinity of stormwater basin media (i.e., engineered soil), likely impacting the physical properties of these soils. Further, SCM soils can become moderately compacted, potentially altering the extent and effects of salinization on soil physical properties. Although many studies have documented the high salinity of roadside soils in winter, the effects of salinity on soil hydraulic properties is not well understood, especially in the context of urban stormwater basins. Here, we compared the water retention properties (spanning pressure potentials of -10 to -1,000,000 hPa) of salinity-affected stormwater media (1-100 dS m-1, using Na+ and Mg2+ salts) that was either uncompacted or compacted. The effects of salinity on both matric and osmotic potential included shifts in the plant-available range with the magnitude depending on a combination of salt type and concentration. We attribute these changes to salinity inducing shifts in both surface tension and pore size distributions. Further, compaction increased the severity of salinization under low salinity conditions but not high. Climate change may increase the number and intensity of snow events in many temperate urban regions, which may increase salt loads to stormwater control measures, exacerbating the aforementioned effects.more » « less
-
Retrofitting urban watersheds with wireless sensing and control technologies will enable the next generation of autonomous water systems. While many studies have highlighted the benefits of real-time controlled gray infrastructure, few have evaluated real-time controlled green infrastructure. Motivated by a controlled bioretention site where phosphorus is a major runoff pollutant, phosphorus removal was simulated over a range of influent concentrations and storm conditions for three scenarios: a passive, uncontrolled bioretention cell (baseline), a real-time controlled cell (autonomous upgrade), and a cell with soil amendments (passive upgrade). Results suggest the autonomous upgrade matched the pollutant treatment performance of the baseline scenario in half the spatial footprint. The autonomous upgrade also matched the performance of the passive upgrade; suggesting real-time control may provide a ‘digital’ alternative to existing, passive upgrades. These findings may help site- and cost-constrained stormwater managers meet their water quality goals.more » « less
-
Consecutive oscillatory eruptions of a mixture of gas and liquid in urban stormwater systems, commonly referred to as sewer geysers, are investigated using transient three-dimensional (3D) computational fluid dynamics (CFD) models. This study provides a detailed mechanistic understanding of geyser formation under partially filled dropshaft conditions, an area not previously explored in depth. The maximum geyser eruption velocities were observed to reach 14.58 m/s under fully filled initial conditions (hw/hd = 1) and reduced to 5.17 m/s and 3.02 m/s for partially filled conditions (hw/hd = 0.5 and 0.23, respectively). The pressure gradients along the horizontal pipe drove slug formation and correlated directly with the air ingress rates and dropshaft configurations. The influence of the dropshaft diameter was also assessed, showing a 116% increase in eruption velocity when the dropshaft to horizontal pipe diameter ratio (Dd/Dt) was reduced from 1.0 to 0.5. It was found that the strength of the geyser (as represented by the eruption velocity from the top of the dropshaft) increased with an increase in the initial water depth in the dropshaft and a reduction in the dropshaft diameter. Additionally, the Kelvin–Helmholtz instability criteria were satisfied during transitions from stratified to slug flow, and they were responsible for the jump and transition of the flow during the initial rise and fallback of the water in the dropshaft. The present study shows that, under an initially lower water depth in the dropshaft, immediate spillage is not guaranteed. However, the subsequent mixing of air from the horizontal pipe generated a less dense mixture, causing a change in pressure distribution along the tunnel, which drove the entire geyser mechanism. This study underscores the critical role of the initial conditions and geometric parameters in influencing geyser dynamics, offering practical guidelines for urban drainage infrastructure.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.3390/w15091740
