Epitaxial (Ti1−
Multifunctionality as a paradigm requires materials exhibiting multiple superior properties. Integrating second‐order optical nonlinearity and large bandgap with piezoelectricity can, for example, enable broadband, strain‐tunable photonics. Though very different phenomena at distinct frequencies, both second‐order optical nonlinearity and piezoelectricity are third‐rank polar tensors present only in acentric crystal structures. However, simultaneously enhancing both phenomena is highly challenging since it involves competing effects with tradeoffs. Recently, a large switchable ferroelectric polarization of ≈80 μC cm−2was reported in Zn1
- Award ID(s):
- 2210933
- NSF-PAR ID:
- 10419232
- Publisher / Repository:
- Wiley Blackwell (John Wiley & Sons)
- Date Published:
- Journal Name:
- Advanced Physics Research
- Volume:
- 2
- Issue:
- 12
- ISSN:
- 2751-1200
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
more » « less
Abstract x Mgx )0.25Al0.75N(0001)/Al2O3(0001) layers are used as a model system to explore how Fermi‐level engineering facilitates structural stabilization of a host matrix despite the intentional introduction of local bonding instabilities that enhance the piezoelectric response. The destabilizing octahedral bonding preference of Ti dopants and the preferred 0.67 nitrogen‐to‐Mg ratio for Mg dopants deteriorate the wurtzite AlN matrix for both Ti‐rich (x < 0.2) and Mg‐rich (x ≥ 0.9) alloys. Conversely,x = 0.5 leads to a stability peak with a minimum in the lattice constant ratioc /a , which is caused by a Fermi‐level shift into the bandgap and a trend toward nondirectional ionic bonding, leading to a maximum in the expected piezoelectric stress constante 33. The refractive index and the subgap absorption decrease withx , the optical bandgap increases, and the elastic constant along the hexagonal axisC 33= 270 ± 14 GPa remains composition independent, leading to an expected piezoelectric constantd 33= 6.4 pC N−1atx = 0.5, which is 50% larger than for the pure AlN matrix. Thus, contrary to the typical anticorrelation between stability and electromechanical coupling, the (Ti1−x Mgx )0.25Al0.75N system exhibits simultaneous maxima in the structural stability and the piezoelectric response atx = 0.5. -
more » « less
Abstract The new compounds Li2Mg2Si2S6and Li2Mg2Ge2S6have been prepared via traditional high‐temperature, solid‐state synthesis. The title compounds crystallize in the polar, noncentrosymmetric, trigonal space group
P 31m (No. 157) and adopt a new structure type featuring staggered, ethane‐like (T2S6)6−units, where T=Si or Ge. These (T2S6)6−units are nestled within the holes of magnesium‐sulfide “layers” that are created through the edge‐sharing of MgS6octahedra. The holes found in the lithium‐sulfide “layers”, created by LiS6edge‐sharing octahedra, remain vacant, containing no (T2S6)6−anionic group. Through the face sharing of the respective MgS6and LiS6octahedra, the magnesium‐sulfide and lithium‐sulfide “layers” are stitched together resulting in an overall three‐dimensional structure. The optical bandgaps of Li2Mg2Si2S6and Li2Mg2Ge2S6are 3.24 and 3.18 eV, respectively, as estimated from optical diffuse reflectance UV‐Vis‐NIR spectroscopy. The compounds exhibit second harmonic generation responses of ∼0.24×KDP and ∼2.92×α‐quartz for Li2Mg2Si2S6and ∼0.17×KDP and ∼2.08×α‐quartz for Li2Mg2Ge2S6, using a Nd:YAG laser at 1.064 μm. Electronic structure calculations were performed using density functional theory and the linearized augmented plane‐wave approach within the WIEN2k software package. Examination of the electronic band structures shows that these compounds are indirect bandgap semiconductors. -
more » « less
Abstract Next‐generation electronics and energy technologies can now be developed as a result of the design, discovery, and development of novel, environmental friendly lead (Pb)‐free ferroelectric materials with improved characteristics and performance. However, there have only been a few reports of such complex materials’ design with multi‐phase interfacial chemistry, which can facilitate enhanced properties and performance. In this context, herein, novel lead‐free piezoelectric materials (1‐
x )Ba0.95Ca0.05Ti0.95Zr0.05O3‐(x )Ba0.95Ca0.05Ti0.95Sn0.05O3, are reported, which are represented as (1‐x )BCZT‐(x )BCST, with demonstrated excellent properties and energy harvesting performance. The (1‐x )BCZT‐(x )BCST materials are synthesized by high‐temperature solid‐state ceramic reaction method by varyingx in the full range (x = 0.00–1.00). In‐depth exploration research is performed on the structural, dielectric, ferroelectric, and electro‐mechanical properties of (1‐x )BCZT‐(x )BCST ceramics. The formation of perovskite structure for all ceramics without the presence of any impurity phases is confirmed by X‐ray diffraction (XRD) analyses, which also reveals that the Ca2+, Zr4+, and Sn4+are well dispersed within the BaTiO3lattice. For all (1‐x )BCZT‐(x )BCST ceramics, thorough investigation of phase formation and phase‐stability using XRD, Rietveld refinement, Raman spectroscopy, high‐resolution transmission electron microscopy (HRTEM), and temperature‐dependent dielectric measurements provide conclusive evidence for the coexistence of orthorhombic + tetragonal (Amm2 +P4mm ) phases at room temperature. The steady transition ofAmm2 crystal symmetry toP4mm crystal symmetry with increasingx content is also demonstrated by Rietveld refinement data and related analyses. The phase transition temperatures, rhombohedral‐orthorhombic (TR‐O), orthorhombic‐ tetragonal (TO‐T), and tetragonal‐cubic (TC), gradually shift toward lower temperature with increasingx content. For (1‐x )BCZT‐(x )BCST ceramics, significantly improved dielectric and ferroelectric properties are observed, including relatively high dielectric constantε r≈ 1900–3300 (near room temperature),ε r≈ 8800–12 900 (near Curie temperature), dielectric loss, tanδ ≈ 0.01–0.02, remanent polarizationP r≈ 9.4–14 µC cm−2, coercive electric fieldE c≈ 2.5–3.6 kV cm−1. Further, high electric field‐induced strainS ≈ 0.12–0.175%, piezoelectric charge coefficientd 33≈ 296–360 pC N−1, converse piezoelectric coefficient ≈ 240–340 pm V−1, planar electromechanical coupling coefficientk p≈ 0.34–0.45, and electrostrictive coefficient (Q 33)avg≈ 0.026–0.038 m4C−2are attained. Output performance with respect to mechanical energy demonstrates that the (0.6)BCZT‐(0.4)BCST composition (x = 0.4) displays better efficiency for generating electrical energy and, thus, the synthesized lead‐free piezoelectric (1‐x )BCZT‐(x )BCST samples are suitable for energy harvesting applications. The results and analyses point to the outcome that the (1‐x )BCZT‐(x )BCST ceramics as a potentially strong contender within the family of Pb‐free piezoelectric materials for future electronics and energy harvesting device technologies. -
more » « less
Abstract The local compositional heterogeneity associated with the short‐range ordering of Mg and Nb in PbMg1/3Nb2/3O3(PMN) is correlated with its characteristic relaxor ferroelectric behavior. Fully ordered PMN is not prepared as a bulk material. This work examines the relaxor behavior in PMN thin films grown at temperatures below 1073 K by artificially reducing the degree of disorder via synthesis of heterostructures with alternate layers of Pb(Mg2/3Nb1/3)O3and PbNbO3, as suggested by the random‐site model. 100 nm thick, phase‐pure films are grown epitaxially on (111) SrTiO3substrates using alternate target timed pulsed‐laser deposition of Pb(Mg2/3Nb1/3)O3and PbNbO3targets with 20% excess Pb. Selected area electron diffraction confirms the emergence of (1/2, 1/2, 1/2) superlattice spots with randomly distributed ordered domains as large as ≈150 nm. These heterostructures exhibit a dielectric constant of 800, loss tangents of ≈0.03 and 2× remanent polarization of ≈11 µC cm−2at room temperature. Polarization–electric field hysteresis loops, Rayleigh data, and optical second‐harmonic generation measurements are consistent with the development of ferroelectric domains below 140 K. Temperature‐dependent permittivity measurements demonstrate reduced frequency dispersion compared to short range ordered PMN films. This work suggests a continuum between normal and relaxor ferroelectric behavior in the engineered PMN thin films.
-
more » « less
Nonlinear optical (NLO) crystals with superior properties are significant for advancing laser technologies and applications. Introducing rare earth metals to borates is a promising and effective way to modify the electronic structure of a crystal to improve its optical properties in the visible and ultraviolet range. In this work, we computationally discover inversion symmetry breaking in EuBa3(B3O6)3, which was previously identified as centric, and demonstrate noncentrosymmetry via synthesizing single crystals for the first time by the floating zone method. We determine the correct space group to be
P 6¯. The material has a large direct bandgap of 5.56 eV and is transparent down to 250 nm. The complete anisotropic linear and nonlinear optical properties were also investigated with ad 11of ∼0.52 pm/V for optical second harmonic generation. Further, it is Type I and Type II phase matchable. This work suggests that rare earth metal borates are an excellent crystal family for exploring future deep ultraviolet (DUV) NLO crystals. It also highlights how first principles computations combined with experiments can be used to identify noncentrosymmetric materials that have been wrongly assigned to be centrosymmetric.
