Subduction zones host some of Earth's most damaging natural hazards, including megathrust earthquakes and earthquake‐induced tsunamis. A major control on the initiation and rupture characteristics of subduction megathrust earthquakes is how the coupled zone along the subduction interface accumulates elastic strain between events. We present results from observations of slow slip events (SSEs) in Cascadia occurring during the interseismic period downdip of the fully coupled zone, which imply that the orientation of strain accumulation within the coupled zone can vary with depth. Interseismic GPS motions suggest that forces derived from relative plate motions across a shallow, offshore locked plate interface dominate over decadal timescales. Deeper on the plate interface, below the locked (seismogenic) patch, slip during SSEs dominantly occurs in the updip direction, reflecting a dip‐parallel force acting on the slab, such as slab pull. This implies that in subduction zones with obliquely convergent plate motions, the seismogenic zone of the megathrust is loaded by forces acting in two discrete directions, leading to a depth‐varying orientation of strain accumulation on the plate interface.
The Cascadia subduction megathrust off the Pacific Northwest follows an “end member” seismogenic behavior, producing large (up to moment magnitude 9) but infrequent (every several hundred years) earthquakes and tsunamis. Crustal deformation associated with the ongoing plate convergence has been characterized by land‐based geodetic observations, but the state of locking across the full breadth of the seismogenic fault is poorly constrained. We report results of offshore monitoring of borehole fluid pressure, as a proxy for formation volumetric strain, at a site ∼20 km landward of the Cascadia subduction deformation front since 2010. The multi‐depth pressure records were plagued by hydrologic noise, but noise at the deepest monitoring level (303 m sub‐seafloor) abated in 2015. Subsequently, including at the times of regional large earthquakes that caused significant dynamic stressing, no persistent pressure transients are present above a threshold of 0.08 kPa imposed by unremovable oceanographic signals, corresponding to a strain detection limit of ∼16 nanostrain. Simple dislocation models using local megathrust geometry suggest a resolvable slip of <1 cm along a trench‐normal corridor beneath the borehole for a range of slip‐patch dimensions. A large slip patch can be well resolved even at considerable along‐strike distances from the borehole; for instance, ∼10 cm slip is detectable over a 200‐km strike range for a slip‐patch radius of ∼50 km. This high sensitivity for detecting slip, along with the lack of observed events, stands in stark contrast to observations at other subduction zones, and suggests that the Northern Cascadia megathrust is most likely fully locked.
more » « less- PAR ID:
- 10430998
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Geochemistry, Geophysics, Geosystems
- Volume:
- 24
- Issue:
- 6
- ISSN:
- 1525-2027
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
more » « less
Abstract -
more » « less
Abstract Within the fore‐arc of the Cascadia Subduction Zone, there are significant along‐strike differences in the orientation of splay faults, sediment consolidation, and fault roughness. Here, we use dynamic rupture simulations of megathrust earthquakes on different realizations of a fault system that incorporate fore‐arc properties representative of offshore Oregon and Washington to estimate how splay faults may behave in future megathrust earthquakes in Cascadia. While splay faults were activated in all of our simulations, splay orientation is a primary control on slip amplitude. Seaward vergent faults accommodate significant amounts of slip resulting in large seafloor uplift and significantly larger tsunami amplitudes. For example, our median tsunami heights including splay faults are about a factor of two larger than those that did not include splay fault deformation. We suggest that there is an urgent need to revisit existing approaches to tsunami hazard assessment in Cascadia to include the influence of splay faults.
-
more » « less
Because splay faults branch at a steep dip angle from the plate-boundary décollement in an accretionary wedge, their coseismic displacement can potentially result in larger tsunamis with distinct characteristics compared to megathrust-only fault ruptures, posing an enhanced hazard to coastal communities. Elsewhere, there is evidence of coseismic slip on splay faults during many of the largest subduction zone earthquakes, but our understanding of potentially active splay faults and their hazards at the Cascadia subduction zone remains limited. To identify the most recently active splay faults at Cascadia, we conduct stratigraphic and structural interpretations of near-surface deformation in the outer accretionary wedge for the ~400 km along-strike length of the landward vergence zone. We analyze recently acquired high-frequency sparker seismic data and crustal-scale multi-channel seismic data to examine the record of deformation in shallow slope basins and the upper ~1 km of the surrounding accreted sediments and to investigate linkages to deeper décollement structure. We present a new fault map for widest, most completely locked portion of Cascadia from 45 to 48°N latitude, which documents the distribution of faults that show clear evidence of recent late Quaternary activity. We find widespread evidence for active splay faulting up to 30 km landward of the deformation front, in what we define as the active domain, and diminished fault activity landward outside of this zone. The abundance of surface-deforming splay faults in the active outer wedge domain suggests Cascadia megathrust events may commonly host distributed shallow rupture on multiple splay faults located within 30 km of the deformation front.
-
more » « less
The origin of rupture segmentation along subduction zone megathrusts and linkages to the structural evolution of the subduction zone are poorly understood. Here, regional-scale seismic imaging of the Cascadia margin is used to characterize the megathrust spanning ~900 km from Vancouver Island to the California border, across the seismogenic zone to a few tens of kilometers from the coast. Discrete domains in lower plate geometry and sediment underthrusting are identified, not evident in prior regional plate models, which align with changes in lithology and structure of the upper plate and interpreted paleo-rupture patches. Strike-slip faults in the lower plate associated with oblique subduction mark boundaries between regions of distinct lower plate geometry. Their formation may be linked to changes in upper plate structure across long-lived upper plate faults. The Juan de Fuca plate is fragmenting within the seismogenic zone at Cascadia as the young plate bends beneath the heterogeneous upper plate resulting in structural domains that coincide with paleo-rupture segmentation.
-
more » « less
Abstract Fluids influence fault zone strength and the occurrence of earthquakes, slow slip events, and aseismic slip. We introduce an earthquake sequence model with fault zone fluid transport, accounting for elastic, viscous, and plastic porosity evolution, with permeability having a power‐law dependence on porosity. Fluids, sourced at a constant rate below the seismogenic zone, ascend along the fault. While the modeling is done for a vertical strike‐slip fault with 2D antiplane shear deformation, the general behavior and processes are anticipated to apply also to subduction zones. The model produces large earthquakes in the seismogenic zone, whose recurrence interval is controlled in part by compaction‐driven pressurization and weakening. The model also produces a complex sequence of slow slip events (SSEs) beneath the seismogenic zone. The SSEs are initiated by compaction‐driven pressurization and weakening and stalled by dilatant suctions. Modeled SSE sequences include long‐term events lasting from a few months to years and very rapid short‐term events lasting for only a few days; slip is ∼1–10 cm. Despite ∼1–10 MPa pore pressure changes, porosity and permeability changes are small and hence fluid flux is relatively constant except in the immediate vicinity of slip fronts. This contrasts with alternative fault valving models that feature much larger changes in permeability from the evolution of pore connectivity. Our model demonstrates the important role that compaction and dilatancy have on fluid pressure and fault slip, with possible relevance to slow slip events in subduction zones and elsewhere.
