An official website of the United States government
Abstract. This study analyzes turbulent energy fluxes in the Arctic atmospheric boundary layer (ABL) using measurements with a small uncrewed aircraft system (sUAS). Turbulent fluxes constitute a major part of the atmospheric energy budget and influence the surface heat balance by distributing energy vertically in the atmosphere. However, only few in situ measurements of the vertical profile of turbulent fluxes in the Arctic ABL exist. The study presents a method to derive turbulent heat fluxes from DataHawk2 sUAS turbulence measurements, based on the flux gradient method with a parameterization of the turbulent exchange coefficient. This parameterization is derived from high-resolution horizontal wind speed measurements in combination with formulations for the turbulent Prandtl number and anisotropy depending on stability. Measurements were taken during the MOSAiC (Multidisciplinary drifting Observatory for the Study of Arctic Climate) expedition in the Arctic sea ice during the melt season of 2020. For three example cases from this campaign, vertical profiles of turbulence parameters and turbulent heat fluxes are presented and compared to balloon-borne, radar, and near-surface measurements. The combination of all measurements draws a consistent picture of ABL conditions and demonstrates the unique potential of the presented method for studying turbulent exchange processes in the vertical ABL profile with sUAS measurements.
more »
« less
Atmospheric Turbulent Intermittency Over the Arctic Sea‐Ice Surface During the MOSAiC Expedition
Abstract Turbulent motions in the Arctic stable boundary layer are characterized by intermittency, but they are rarely investigated due to limited observations, in particular over the sea‐ice surface. In the present study, we explore the characteristics of turbulent intermittency over the Arctic sea‐ice surface using data collected during the Multidisciplinary drifting Observation for the Study of Arctic Climate expedition from October 2019 to September 2020. We first develop a new algorithm, which performs well in identifying the spectral gap over the Arctic sea‐ice surface. Then the characteristics of intermittency are investigated. It is found that the strength of intermittency increases under the conditions of light surface wind speed, small surface wind speed gradient, and strong surface air temperature gradient. The momentum flux, sensible heat flux, and latent heat flux calculated by raw eddy‐covariance fluctuations are overestimated by 3%, 10%, and 24%, respectively, because submesoscale motions are included. Furthermore, the characteristics of the atmospheric boundary layer structure under various intermittency conditions reveal that strong low‐level jets are favorable to surface turbulent motions that result in weak intermittency, while strong temperature inversions above the surface layer suppress surface turbulent motions and lead to strong intermittency.
more »
« less
- Award ID(s):
- 1724551
- PAR ID:
- 10442219
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Journal of Geophysical Research: Atmospheres
- Volume:
- 128
- Issue:
- 15
- ISSN:
- 2169-897X
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Arctic amplification has been attributed predominantly to a positive lapse rate feedback in winter, when boundary layer temperature inversions focus warming near the surface. Predicting high-latitude climate change effectively thus requires identifying the local and remote physical processes that set the Arctic’s vertical warming structure. In this study, we analyze output from the CESM Large Ensemble’s twenty-first-century climate change projection to diagnose the relative influence of two Arctic heating sources, local sea ice loss and remote changes in atmospheric heat transport. Causal effects are quantified with a statistical inference method, allowing us to assess the energetic pathways mediating the Arctic temperature response and the role of internal variability across the ensemble. We find that a step-increase in latent heat flux convergence causes Arctic lower-tropospheric warming in all seasons, while additionally reducing net longwave cooling at the surface. However, these effects only lead to small and short-lived changes in boundary layer inversion strength. By contrast, a step-decrease in sea ice extent in the melt season causes, in fall and winter, surface-amplified warming and weakened boundary layer temperature inversions. Sea ice loss also enhances surface turbulent heat fluxes and cloud-driven condensational heating, which mediate the atmospheric temperature response. While the aggregate effect of many moist transport events and seasons of sea ice loss will be different than the response to hypothetical perturbations, our results nonetheless highlight the mechanisms that alter the Arctic temperature inversion in response to CO2forcing. As sea ice declines, the atmosphere’s boundary layer temperature structure is weakened, static stability decreases, and a thermodynamic coupling emerges between the Arctic surface and the overlying troposphere.more » « less
-
Abstract Models struggle to accurately simulate observed sea ice thickness changes, which could be partially due to inadequate representation of thermodynamic processes. We analyzed co‐located winter observations of the Arctic sea ice from the Multidisciplinary Drifting Observatory for the Study of the Arctic Climate for evaluating and improving thermodynamic processes in sea ice models, aiming to enable more accurate predictions of the warming climate system. We model the sea ice and snow heat conduction for observed transects forced by realistic boundary conditions to understand the impact of the non‐resolved meter‐scale snow and sea ice thickness heterogeneity on horizontal heat conduction. Neglecting horizontal processes causes underestimating the conductive heat flux of 10% or more. Furthermore, comparing model results to independent temperature observations reveals a ∼5 K surface temperature overestimation over ice thinner than 1 m, attributed to shortcomings in parameterizing surface turbulent and radiative fluxes rather than the conduction. Assessing the model deficiencies and parameterizing these unresolved processes is required for improved sea ice representation.more » « less
-
Abstract Tides are an important factor shaping the sea ice system in the Arctic Ocean by altering vertical heat fluxes and advection patterns. Unfortunately, observations are sparse, and the analysis of tides is complicated by the proximity of wind-driven inertial oscillations to the semidiurnal frequencies. Furthermore, computational costs typically prohibit the inclusion of tides in ocean models, leaving a significant gap in our understanding. Motivated by summer observations showing elevated downward surface heat fluxes in the presence of tides, we analyzed simulations carried out with an eddy-permitting coupled ice–ocean model to quantify the impact of tidal effects on Arctic sea ice. In line with previous studies, we find an overall decrease in sea ice volume when tides are included in the simulations, associated with increased vertical mixing and the upward flux of heat from deeper layers of the Arctic Ocean, but this sea ice volume decrease is less pronounced than previously thought. Surprisingly, our simulations suggest that in summer, Arctic sea ice area is larger, by up to 1.5%, when tides are included in the simulations. This effect is partly caused by an increased downward surface heat flux and a consequently lower sea surface temperature, delaying sea ice melting predominantly in the Siberian Seas, where tides are moderately strong and the warm Atlantic Water core is located relatively deep and does not encroach on the wide continental shelf. Here, tidally enhanced downward heat flux from the surface in summer can dominate over the increased upward heat flux from the warm Atlantic Water layer. Significance StatementThis study sheds light on the complex and understudied role of tides in Arctic sea ice dynamics. By utilizing advanced computer models, our research uncovers that, contrary to common expectations, tides contribute to a seasonal increase in sea ice area by up to 1.5% in summer. This effect is attributed to enhanced advection of sea ice into the Siberian Seas and a local increase in downward heat flux reducing sea surface temperatures, thereby delaying sea ice melting in this region. Our findings challenge prevailing notions about the negative impact of tides on sea ice and highlight the importance of incorporating tidal impacts in ocean models to improve predictions of Arctic sea ice changes, key for our understanding of both Arctic and global climate dynamics.more » « less
-
An incoming canonical spatially developing turbulent boundary layer (SDTBL) over a 2-D curved hill is numerically investigated via the Reynolds-averaged Navier–Stokes (RANS) equations plus two eddy-viscosity models: the K−ω SST (henceforth SST) and the Spalart–Allmaras (henceforth SA) turbulence models. A spatially evolving thermal boundary layer has also been included, assuming temperature as a passive scalar (Pr = 0.71) and a turbulent Prandtl number, Prt, of 0.90 for wall-normal turbulent heat flux modeling. The complex flow with a combined strong adverse/favorable streamline curvature-driven pressure gradient caused by concave/convex surface curvatures has been replicated from wind-tunnel experiments from the literature, and the measured velocity and pressure fields have been used for validation purposes (the thermal field was not experimentally measured). Furthermore, direct numerical simulation (DNS) databases from the literature were also employed for the incoming turbulent flow assessment. Concerning first-order statistics, the SA model demonstrated a better agreement with experiments where the turbulent boundary layer remained attached, for instance, in Cp, Cf, and Us predictions. Conversely, the SST model has shown a slightly better match with experiments over the flow separation zone (in terms of Cp and Cf) and in Us profiles just upstream of the bubble. The Reynolds analogy, based on the St/(Cf/2) ratio, holds in zero-pressure gradient (ZPG) zones; however, it is significantly deteriorated by the presence of streamline curvature-driven pressure gradient, particularly due to concave wall curvature or adverse-pressure gradient (APG). In terms of second-order statistics, the SST model has better captured the positively correlated characteristics of u′ and v′ or positive Reynolds shear stresses ( > 0) inside the recirculating zone. Very strong APG induced outer secondary peaks in and turbulence production as well as an evident negative slope on the constant shear layer.more » « less
