An official website of the United States government
Abstract Most great earthquakes on subduction zone plate boundaries have large coseismic slip concentrated along the contact between the subducting slab and the upper plate crust. On 4 March 2021, a magnitude 7.4 foreshock struck 1 hr 47 min before a magnitude 8.1 earthquake along the northern Kermadec island arc. The mainshock is the largest well‐documented underthrusting event along the ∼2,500‐km long Tonga‐Kermadec subduction zone. Using teleseismic, geodetic, and tsunami data, we find that all substantial coseismic slip in the mainshock is located along the mantle/slab interface at depths from 20 to 55 km, with the large foreshock nucleating near the down‐dip edge. Smaller foreshocks and most aftershocks are located up‐dip of the mainshock, where substantial prior moderate thrust earthquake activity had occurred. The upper plate crust is ∼17 km thick in northern Kermadec with only moderate‐size events along the crust/slab interface. A 1976 sequence withMWvalues of 7.9, 7.8, 7.3, 7.0, and 7.0 that spanned the 2021 rupture zone also involved deep megathrust rupture along the mantle/slab contact, but distinct waveforms exclude repeating ruptures. Variable waveforms for eight deep M6.9+ thrusting earthquakes since 1990 suggest discrete slip patches distributed throughout the region. The ∼300‐km long plate boundary in northern Kermadec is the only documented subduction zone region where the largest modeled interplate earthquakes have ruptured along the mantle/slab interface, suggesting that local frictional properties of the putatively hydrated mantle wedge may involve a dense distribution of Antigorite‐rich patches with high slip rate velocity weakening behavior in this locale.
more »
« less
Lower Mantle Seismicity Following the 2015 Mw 7.9 Bonin Islands Deep‐Focus Earthquake
Abstract Deep‐focus earthquakes provide insight into how subducting slabs deform over a range of spatial and temporal scales as they descend into the mantle. This study uses a 4D source imaging approach to determine centroid locations of the 2015 Mw 7.9 Bonin Islands deep‐focus earthquake and its aftershock sequence. Imaged sources of the mainshock show a complex rupture, but one that is compatible with a sub‐horizontal rupture plane. Previously undetected early aftershocks are imaged down to depths of approximately 750 km and represent the first reported earthquakes that initiate in the lower mantle. These events and a previously reported group of shallower distal aftershocks occur at the lower and upper boundaries of an imaged slab segment that deforms as it penetrates into the lower mantle. We hypothesize that mainshock failure allowed gravitational settling of the slab segment to occur which produced the distal aftershock sequences.
more »
« less
- PAR ID:
- 10443519
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Geophysical Research Letters
- Volume:
- 48
- Issue:
- 13
- ISSN:
- 0094-8276
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract The Alaska Peninsula section of the Alaska-Aleutian subduction zone shows significant along-strike variations in seismic activity and interseismic plate coupling. This region experienced the 2020 Mw 7.8 Simeonof megathrust, Mw 7.6 Sand Point strike-slip, and 2021 Mw 8.2 Chignik megathrust earthquakes. This study, utilizing deep learning techniques, presents a high-precision earthquake catalog, providing insights into background seismicity, aftershocks, and slab geometry. An abrupt change in the slab dip angle at 30–40 km depths in the Shumagin segment acted as a barrier to the Simeonof and Sand Point earthquake ruptures. The Simeonof event triggered more aftershocks in the overriding plate than the Chignik event, suggesting the overriding plate is more deformed and hydrated in the Shumagin segment. The Sand Point earthquake triggered numerous aftershocks in the overriding plate, delineating a fault in the overriding plate with similar geometry as the intraslab mainshock fault, but activated around seven days after the mainshock.more » « less
-
Abstract The number of aftershocks increases with mainshock size following a well‐defined scaling law. However, excursions from the average behavior are common. This variability is particularly concerning for large earthquakes where the number of aftershocks varies by factors of 100 for mainshocks of comparable magnitude. Do observable factors lead to differences in aftershock behavior? We examine aftershock productivity relative to the global average for all mainshocks () from 1990 to 2019. A global map of earthquake productivity highlights the influence of tectonic regimes. Earthquake depth, lithosphere age, and plate boundary type correspond well with earthquake productivity. We investigate the role of mainshock attributes by compiling source dimensions, radiated seismic energy, stress drop, and a measure of slip heterogeneity based on finite‐fault source inversions for the largest earthquakes from 1990 to 2017. On an individual basis, stress drop, normalized rupture width, and aspect ratio most strongly correlate with aftershock productivity. A multivariate analysis shows that a particular set of parameters (dip, lithospheric age, and normalized rupture area) combines well to improve predictions of aftershock productivity on a cross‐validated data set. Our overall analysis is consistent with a model in which the volumetric abundance of nearby stressed faults controls the aftershock productivity rather than variations in source stress. Thus, we suggest a complementary approach to aftershock forecasts based on geological and rupture properties rather than local calibration alone.more » « less
-
On February 6, 2023, two large earthquakes occurred near the Turkish town of Kahramanmaraş. The moment magnitude (Mw) 7.8 mainshock ruptured a 310 km-long segment of the left-lateral East Anatolian Fault, propagating through multiple releasing step-overs. The Mw 7.6 aftershock involved nearby left-lateral strike-slip faults of the East Anatolian Fault Zone, causing a 150 km-long rupture. We use remote-sensing observations to constrain the spatial distribution of coseismic slip for these two events and the February 20 Mw 6.4 aftershock near Antakya. Pixel tracking of optical and synthetic aperture radar data of the Sentinel-2 and Sentinel-1 satellites, respectively, provide near-field surface displacements. High-rate Global Navigation Satellite System data constrain each event separately. Coseismic slip extends from the surface to about 15 km depth with a shallow slip deficit. Most aftershocks cluster at major fault bends, surround the regions of high coseismic slip, or extend outward of the ruptured faults. For the mainshock, rupture propagation stopped southward at the diffuse termination of the East Anatolian fault and tapered off northward into the Pütürge segment, some 20 km south of the 2020 Mw 6.8 Elaziğ earthquake, highlighting a potential seismic gap. These events underscore the high seismic potential of immature fault systems.more » « less
-
Abstract On 4 and 6 July 2019, two large strike‐slip earthquakes withW‐phase moment magnitudesMWW6.5 (foreshock) andMWW7.1 (mainshock) struck the Eastern California Shear Zone, northeast of Ridgecrest. The faulting geometry and kinematic coseismic slip distribution of both events are determined by jointly inverting seismological and geodetic observations guided by aftershock and surface rupture locations. The foreshock ruptured two orthogonal faults with a prominent L‐shaped geometry with maximum slip of ~1.1 m on the NE‐SW segment. The mainshock faulting extended NW‐SE along several primary fault segments that straddle the foreshock slip. The surface rupture and slip model indicate mostly near‐horizontal strike‐slip motion with maximum slip of ~3.7 m, but there is a localized vertical dip‐slip motion. Both the foreshock and mainshock ruptures terminate in regions of complex surface offsets. High aftershock productivity and low rupture velocity may be the result of rupture of a relatively immature fault system.more » « less
