An official website of the United States government
Containment barrier systems, such as vertical slurry walls and low-permeable liners in waste containment systems, are commonly used to prevent groundwater contamination. However, traditional low-permeable clays used in these barriers have limitations in effectively removing various contaminants, including phosphate, which is a contaminant of global concern. The overarching goal of this work is to create a novel chitosan-bentonite composite barrier for improving the performance of containment systems. Chitosan, a material derived by deacetylating chitin, is a promising barrier material due to its ability to adsorb various contaminants. The purpose of this study is to investigate incorporating chitosan into these barriers to enhance their contaminant adsorption capacity. Previous studies were performed on three chitosans with varying degree of deacetylation (DOD) and molecular weights (MW) and one type of bentonite. The current study presents results from batch tests on four additional chitosan materials and a different source of bentonite. These tests assessed their individual phosphate removal capabilities and were compared with earlier findings. The chitosans exhibited varying phosphate removal efficiencies based on DOD, MW, surface area, and source. The highest removal efficiency ranging from 20.9% to 85.6%, at different initial phosphate concentrations, was achieved by one of the chitosan variants. In contrast, bentonite achieved 15.3% to 41.6% removal at different phosphate concentrations. Results suggest a composite material of chitosan and bentonite in engineered barriers could significantly enhance phosphate removal, especially at lower concentrations (0.5 mg/l), compared to a simple bentonite-based barrier.
more »
« less
Phosphate Removal from Synthetic Stormwater Using Chitosan and Clay
Excessive levels of phosphate in stormwater runoff can negatively impact receiving surface water bodies, such as retention ponds, and may also seep into groundwater. Liner systems composed of materials with greater phosphate selectivity have the potential to mitigate infiltration and eliminate phosphate. One potential material is chitosan, an abundant naturally occurring biopolymer. This study evaluated five materials for their ability to remove phosphate from synthetic stormwater using batch tests with different initial phosphate concentrations ranging from 0.5 to 12 mg/L and a fixed 24-h exposure time. The materials included two types of clayey soils (kaolin and bentonite) and three different varieties of chitosan with varying molecular weights (low, medium, and high). The phosphate removal efficiency of kaolin was found to be the highest, with efficiencies ranging from 100% to 56% at different concentrations, while bentonite was found to be the least effective, with removal efficiencies ranging from 40% to 12%. The removal efficiencies of all three types of chitosans analyzed were higher than those of bentonite but lower than those of kaolin. The removal efficiencies ranged from 77% to 19% for low-molecular-weight chitosan, 84% to 31% for medium-molecular-weight chitosan, and 55% to 18% for high-molecular-weight chitosan. The removal mechanism of phosphate by kaolin and bentonite was attributed to surface adsorption and precipitation. In chitosan, the likely mechanism is electrostatic attraction. The maximum adsorption capacity for kaolin was not reached under the tested phosphate concentration range, indicating potential adsorption sites remained available on the particle surfaces. The results for bentonite, low-molecular-weight chitosan, and high-molecular-weight chitosan showed that these materials nearly reached their maximum adsorption capacities, indicating that fewer adsorption sites were remaining. The Langmuir adsorption isotherm was found to be the best-fit model for phosphate adsorption in all the materials tested compared to the Freundlich isotherm. According to the Langmuir model, the maximum adsorption capacities for kaolin, bentonite, low-molecular-weight chitosan, medium-molecular-weight chitosan, and high-molecular-weight chitosan were found to be 140.85, 33, 48.78, 82.64, and 51.28 mg/kg, respectively.
more »
« less
- PAR ID:
- 10465004
- Publisher / Repository:
- ASCE
- Date Published:
- Journal Name:
- Journal of Hazardous, Toxic, and Radioactive Waste
- Volume:
- 28
- Issue:
- 1
- ISSN:
- 2153-5493
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Toxic oxyanions of Cr(VI) can be potentially removed by adsorbents with positively charged surfaces. In this study, we synthesized a stable and insoluble amine-rich polymer composite (CS–PEI–GLA) by crosslinking polyethyleneimine (PEI), a soluble amine-rich synthetic polymer, and chitosan (CS) with glutaraldehyde (GLA). The positively charged amine groups were the main adsorption sites. The batch investigation demonstrated that the adsorbent was able to remove ≥90% of chromium at pH ranging from 2 to 8. Due to deprotonation of the amine groups, chromium removal decreased at higher pH values. The adsorption was fast and reached equilibrium after 45 min. The maximum adsorption capacity was 500 mg g−1 according to the Langmuir isotherm and did not decrease in the presence of monovalent anions. In the column study, the adsorption capacity was the highest when the flow rate was the lowest (5 mL min−1), influent concentration was medium (225 mg L−1), and the bed height was the shortest (3.5 cm). NaOH was the best recovery reagent with recovery of 67% in batch and 31% in the column. The CS–PEI–GLA composite was able to remove 97.1 ± 0.1% chromium in batch and treat 750 mL of electroplating wastewater with a 3.5 cm packed-bed column.more » « less
-
Modern industrial waste waters often contain high concentrations of phosphate, and many methods have been explored to aid in its removal. This study investigates the use of magnetic nanoparticles as an adsorbent for phosphate removal. Aluminum-doped magnetic nanoparticles were synthesized using a co-precipitation method. Structure and composition analysis of the prepared magnetic nanoparticles indicated an inverse spinal structure with a composition of FeAl0.75Fe1.25O4. These nanoparticles were tested for their phosphate removal properties, including adsorption capacity, selectivity, and kinetic models. They showed great affinity to phosphate with a maximum adsorption capacity of 102 mg/g. Additionally, the adsorption was selective, and the presence of other common anions and organic matters did not interfere with the phosphate adsorption efficacy. The kinetic analysis of phosphate adsorption suggested a pseudo-second-order adsorption behavior, and the adsorption isotherm studies indicated a Langmuir type adsorption. The phosphate removal capabilities of the nanoparticles were also tested in poultry rinsing water, tap water, and municipal wastewaters, all with high phosphate removal efficiency. The overall results from these experiments showed promising results for the phosphate removal efficacy of these nanoparticles.more » « less
-
This study critically appraises employing chitosan as a composite with bentonite, biochar, or both materials as an alternative to conventional barrier materials. A comprehensive literature review was conducted to identify the studies reporting chitosan-bentonite composite (CBC), chitosan amended biochar (CAB), and chitosan-bentonite-biochar composite (CBBC) for effective removal of various contaminants. The study aims to review the synthesis of these composites, identify fundamental properties affecting their adsorption capacities, and examine how these properties affect or enhance the removal abilities of other materials within the composite. Notably, CBC composites have the advantage of adsorbing both cationic and anionic species, such as heavy metals and dyes, due to the cationic nature of chitosan and the anionic nature of montmorillonite, along with the increased accessible surface area due to the clay. CAB composites have the unique advantage of being low-cost sorbents with high specific surface area, affinity for a wide range of contaminants owing to the high surface area and microporosity of biochar, and abundant available functional groups from the chitosan. Limited studies have reported the utilization of CBBC composites to remove various contaminants. These composites can be prepared by combining the steps employed in preparing CBC and CAB composites. They can benefit from the favorable adsorption properties of all three materials while also satisfying the mechanical requirements of a barrier material. This study serves as a knowledge base for future research to develop novel composite barrier materials by incorporating chitosan and biochar as amendments to bentonite.more » « less
-
Anionic carboxylated cellulose nanofibers (CNF) are effective media to remove cationic contaminants from water. In this study, sustainable cationic CNF-based adsorbents capable of removing anionic contaminants were demonstrated using a simple approach. Specifically, the zero-waste nitro-oxidization process was used to produce carboxylated CNF (NOCNF), which was subsequently converted into a cationic scaffold by crosslinking with aluminum ions. The system, termed Al-CNF, is found to be effective for the removal of fluoride ions from water. Using the Langmuir isotherm model, the fluoride adsorption study indicates that Al-CNF has a maximum adsorption capacity of 43.3 mg/g, which is significantly higher than that of alumina-based adsorbents such as activated alumina (16.3 mg/g). The selectivity of fluoride adsorption in the presence of other anionic species (nitrate or sulfate) by Al-CNF at different pH values was also evaluated. The results indicate that Al-CNF can maintain a relatively high selectivity towards the adsorption of fluoride. Finally, the sequential applicability of using spent Al-CNF after the fluoride adsorption to further remove cationic contaminant such as Basic Red 2 dye was demonstrated. The low cost and relatively high adsorption capacity of Al-CNF make it suitable for practical applications in fluoride removal from water.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1061/JHTRBP.HZENG-1270
