An official website of the United States government
Abstract BackgroundSilk proteins have emerged as versatile biomaterials with unique chemical and physical properties, making them appealing for various applications. Among them, spider silk, known for its exceptional mechanical strength, has attracted considerable attention. Recombinant production of spider silk represents the most promising route towards its scaled production; however, challenges persist within the upstream optimization of host organisms, including toxicity and low yields. The high cost of downstream cell lysis and protein purification is an additional barrier preventing the widespread production and use of spider silk proteins. Gram-positive bacteria represent an attractive, but underexplored, microbial chassis that may enable a reduction in the cost and difficulty of recombinant silk production through attributes that include, superior secretory capabilities, frequent GRAS status, and previously established use in industry. ResultsIn this study, we explore the potential of gram-positive hosts by engineering the first production and secretion of recombinant spider silk in theBacillusgenus. Using an industrially relevantB. megateriumhost, it was found that the Sec secretion pathway enables secretory production of silk, however, the choice of signal sequence plays a vital role in successful secretion. Attempts at increasing secreted titers revealed that multiple translation initiation sites in tandem do not significantly impact silk production levels, contrary to previous findings for other gram-positive hosts and recombinant proteins. Notwithstanding, targeted amino acid supplementation in minimal media was found to increase production by 135% relative to both rich media and unaltered minimal media, yielding secretory titers of approximately 100 mg/L in flask cultures. ConclusionIt is hypothesized that the supplementation strategy addressed metabolic bottlenecks, specifically depletion of ATP and NADPH within the central metabolism, that were previously observed for anE. colihost producing the same recombinant silk construct. Furthermore, this study supports the hypothesis that secretion mitigates the toxicity of the produced silk protein on the host organism and enhances host performance in glucose-based minimal media. While promising, future research is warranted to understand metabolic changes more precisely in theBacillushost system in response to silk production, optimize signal sequences and promoter strengths, investigate the mechanisms behind the effect of tandem translation initiation sites, and evaluate the performance of this system within a bioreactor.
more »
« less
Two-step conversion of polyethylene into recombinant proteins using a microbial platform
Abstract BackgroundThe increasing prevalence of plastic waste combined with the inefficiencies of mechanical recycling has inspired interest in processes that can convert these waste streams into value-added biomaterials. To date, the microbial conversion of plastic substrates into biomaterials has been predominantly limited to polyhydroxyalkanoates production. Expanding the capabilities of these microbial conversion platforms to include a greater diversity of products generated from plastic waste streams can serve to promote the adoption of these technologies at a larger scale and encourage a more sustainable materials economy. ResultsHerein, we report the development of a new strain ofPseudomonasbacteria capable of converting depolymerized polyethylene into high value bespoke recombinant protein products. Using hexadecane, a proxy for depolymerized polyethylene, as a sole carbon nutrient source, we optimized media compositions that facilitate robust biomass growth above 1 × 109 cfu/ml, with results suggesting the benefits of lower hydrocarbon concentrations and the use of NH4Cl as a nitrogen source. We genomically integrated recombinant genes for green fluorescent protein and spider dragline-inspired silk protein, and we showed their expression inPseudomonas aeruginosa, reaching titers of approximately 10 mg/L when hexadecane was used as the sole carbon source. Lastly, we demonstrated that chemically depolymerized polyethylene, comprised of a mixture of branched and unbranched alkanes, could be converted into silk protein byPseudomonas aeruginosaat titers of 11.3 ± 1.1 mg/L. ConclusionThis work demonstrates a microbial platform for the conversion of a both alkanes and plastic-derived substrates to recombinant, protein-based materials. The findings in this work can serve as a basis for future endeavors seeking to upcycle recalcitrant plastic wastes into value-added recombinant proteins.
more »
« less
- Award ID(s):
- 2036768
- PAR ID:
- 10469575
- Publisher / Repository:
- Springer Science + Business Media
- Date Published:
- Journal Name:
- Microbial Cell Factories
- Volume:
- 22
- Issue:
- 1
- ISSN:
- 1475-2859
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Protein‐based biomaterials have played a key role in tissue engineering, and additional exciting applications as self‐healing materials and sustainable polymers are emerging. Over the past few decades, recombinant expression and production of various fibrous proteins from microbes have been demonstrated; however, the resulting proteins typically must then be purified and processed by humans to form usable fibers and materials. Here, we show that the Gram‐positive bacteriumBacillus subtiliscan be programmed to secrete silk through its translocon via an orthogonal signal peptide/peptidase pair. Surprisingly, we discover that this translocation mechanism drives the silk proteins to assemble into fibers spontaneously on the cell surface, in a process we call secretion‐catalyzed assembly (SCA). Secreted silk fibers form self‐healing hydrogels with minimal processing. Alternatively, the fibers retained on the membrane provide a facile route to create engineered living materials fromBacilluscells. This work provides a blueprint to achieve autonomous assembly of protein biomaterials in useful morphologies directly from microbial factories.more » « less
-
Substrate identification of putative NCS1 and NCS2 nucleobase transporters in Pseudomonas aeruginosaMathee, Kalai; Dandekar, Ajai A (Ed.)ABSTRACT Pseudomonas aeruginosais an opportunistic pathogen that can salvage nucleobases from the environment to conserve nutrients that would otherwise be spent onde novonucleotide biosynthesis. However, little is known regarding the substrate specificity of the 13 putative nucleobase transporters inP. aeruginosa. Here, using a combination of genetic and chemical approaches, we report substrate identifications for 10 putative nucleobase transporters inP. aeruginosa. Specifically, we individually expressed each transporter in a genetic background lacking all 13 putative nucleobase transporters and quantified growth on a panel of 10 nucleobases as sole nitrogen sources. We confirmed these expression-based substrate identifications using targeted genetic knockouts. In a complementary approach, we utilized four toxic nucleobase antimetabolites to characterize antimicrobial activity in these same strains. We identified the sole allantoin transporter as well as transporters for guanine, xanthine, uric acid, cytosine, thymine, uracil, and dihydrouracil. Furthermore, we associated at least five nucleobase transporters with hypoxanthine, which has been recently reported to be an antibiofilm cue inP. aeruginosa. These results provide an initial characterization of the putative nucleobase transporters inP. aeruginosa, significantly advancing our understanding of nucleobase transport in this clinically relevant organism. IMPORTANCEPseudomonas aeruginosais a frequently multidrug-resistant opportunistic pathogen and one of the most common causes of healthcare-acquired infections. While nucleobases are known to support growth in nutrient-limited conditions, recent work showed that adenine and hypoxanthine can also decreaseP. aeruginosabiofilm formation by disrupting c-di-GMP metabolism. Thus, nucleobase transport may be relevant to multiple aspects ofP. aeruginosabiology and pathogenesis. However, there is currently little known about the transport of nucleobases inP. aeruginosa. Our work reports initial substrate identifications for 10 putative nucleobase transporters inP. aeruginosa, providing new tools to address previously difficult-to-test hypotheses relating to nucleobase transport in this organism.more » « less
-
Urban streams that receive untreated domestic and hospital waste can transmit infectious diseases and spread drug residues, including antimicrobials, which can then increase the selection of antimicrobial-resistant bacteria. Here, water samples were collected from three different urban streams in the state of São Paulo, Brazil, to relate their range of Water Quality Indices (WQIs) to the diversity and composition of aquatic microbial taxa, virulence genes (virulome), and antimicrobial resistance determinants (resistome), all assessed using untargeted metagenome sequencing. There was a predominance of phyla Proteobacteria, Actinobacteria, and Bacteroidetes in all samples, and Pseudomonas was the most abundant detected genus. Virulence genes associated with motility, adherence, and secretion systems were highly abundant and mainly associated with Pseudomonas aeruginosa. Furthermore, some opportunistic pathogenic genera had negative correlations with WQI. Many clinically relevant antimicrobial resistance genes (ARGs) and efflux pump-encoding genes that confer resistance to critically important antimicrobials were detected. The highest relative abundances of ARGs were β-lactams and macrolide-lincosamide-streptogramin. No statistically supported relationship was detected between the abundance of virulome/resistome and collection type/WQI. On the other hand, total solids were a weak predictor of gene abundance patterns. These results provide insights into various microbial outcomes given urban stream quality and point to its ecological complexity. In addition, this study suggests potential consequences for human health as mediated by aquatic microbial communities responding to typical urban outputs.more » « less
-
Subramaniam, B. Executive Editor (Ed.)This research presents pioneering work on transforming a variety of waste plastic into synthetic graphite of high quality and purity. Six recycled plastics in various forms were obtained – including reprocessed polypropylene, high-density polyethylene flakes, shredded polyethylene films, reprocessed polyethylene (all obtained from Pennsylvania Recycling Markets Center), polystyrene foams and polyethylene terephthalate bottles (both sourced from a local recycling bin). The waste plastics were carbonized in sealed tubing reactors. The study shows that this versatile process can be used on a mix of waste plastics in a variety of recycled forms to obtain a uniform graphitic carbon phase, hence addressing the challenges of separation and transportation faced by the plastic recycling industry. The conversion yield to elemental carbon for recycled plastics was improved by up to 250% by using graphene oxide (GO) additives. Five different grades of GO and graphene were used to gain insights into the interaction mechanisms between plastics and GO during pyrolysis. The effect of GO additives on carbonization was analyzed using thermogravimetric analysis / differential scanning calorimetry and ReaxFF-based reactive molecular dynamics simulations. The obtained cokes were graphitized at 2500 ℃ and the graphitic quality of the synthetic graphites was analyzed using X-ray diffraction, transmission electron microscopy, and Raman spectroscopy. The plastic waste-derived synthetic graphites exhibit remarkable graphitic quality with crystallite sizes comparable with a model graphitizable material – anthracene coke. The thin, flake-like morphology and nanostructure featuring well-stacked contiguous lamellae make these graphitic carbons highly promising candidates for energy storage applications. Based on our experiments and atomistic-scale simulations we propose interaction mechanisms between the plastic polymers and the graphenic additives that explain the chemical conversion pathways for GO-assisted waste plastic carbonization and graphitization.more » « less
