An official website of the United States government
In this work, a Pt catalyst supported on an equimolar Al 2 O 3 –CeO 2 binary oxide (Pt–Al–Ce) was prepared and applied in photo-thermo-chemical dry reforming of methane (DRM) driven by concentrated solar irradiation. It was found that the Pt–Al–Ce catalyst showed good stability in DRM reactions and significant enhancements in H 2 and CO production rates compared with Pt/CeO 2 (Pt–Ce) and Pt/Al 2 O 3 (Pt–Al) catalysts. At a reaction temperature of 700 °C under 30-sun equivalent solar irradiation, the Pt–Al–Ce catalyst exhibits a stable DRM catalytic performance at a H 2 production rate of 657 mmol g −1 h −1 and a CO production rate of 666 mmol g −1 h −1 , with the H 2 /CO ratio almost equal to unity. These production rates and the H 2 /CO ratio were significantly higher than those obtained in the dark at the same temperature. The light irradiation was found to induce photocatalytic activities on Pt–Al–Ce and reduce the reaction activation energy. In situ diffuse reflectance infrared Fourier transform spectroscopy ( in situ DRIFTS) was applied to identify the active intermediates in the photo-thermo-chemical DRM process, which were bidentate/monodentate carbonate, absorbed CO on Pt, and formate. The benefits of the binary Al 2 O 3 –CeO 2 substrate could be ascribed to Al 2 O 3 promoting methane dissociation while CeO 2 stabilized and eliminated possible coke formation, leading to high catalytic DRM activity and stability.
more »
« less
Balancing elementary steps enables coke-free dry reforming of methane
Abstract Balancing kinetics, a crucial priority in catalysis, is frequently achieved by sacrificing activity of elementary steps to suppress side reactions and enhance catalyst stability. Dry reforming of methane (DRM), a process operated at high temperature, usually involves fast C-H activation but sluggish carbon removal, resulting in coke deposition and catalyst deactivation. Studies focused solely on catalyst innovation are insufficient in addressing coke formation efficiently. Herein, we develop coke-free catalysts that balance kinetics of elementary steps for overall thermodynamics optimization. Beginning from a highly active cobalt aluminum oxide (CoAl2O4) catalyst that is susceptible to severe coke formation, we substitute aluminum (Al) with gallium (Ga), reporting a CoAl0.5Ga1.5O4-R catalyst that performs DRM stably over 1000 hours without observable coke deposition. We find that Ga enhances DRM stability by suppressing C-H activation to balance carbon removal. A series of coke-free DRM catalysts are developed herein by partially substituting Al from CoAl2O4with other metals.
more »
« less
- Award ID(s):
- 2108307
- PAR ID:
- 10474562
- Publisher / Repository:
- Nature Publishing Group
- Date Published:
- Journal Name:
- Nature Communications
- Volume:
- 14
- Issue:
- 1
- ISSN:
- 2041-1723
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
null (Ed.)Nonoxidative alkane dehydrogenation is a promising route to produce olefins, commonly used as building blocks in the chemical industry. Metal oxides, including γ-Al 2 O 3 and β-Ga 2 O 3 , are attractive dehydrogenation catalysts due to their surface Lewis acid–base properties. In this work, we use density functional theory (DFT) to investigate nonoxidative dehydrogenation of ethane, propane, and isobutane on the Ga-doped and undoped (100) γ-Al 2 O 3 via the concerted and stepwise mechanisms. We revealed that doping (100) γ-Al 2 O 3 with Ga atoms has significant improvement in the dehydrogenation activity by decreasing the C–H activation barriers of the kinetically favored concerted mechanism and increasing the overall dehydrogenation turnover frequencies. We identified the dissociated H 2 binding energy as an activity descriptor for alkane dehydrogenation, accounting for the strength of the Lewis acidity and basicity of the active sites. We demonstrate linear correlations between the dissociated H 2 binding energy and the activation barriers of the rate determining steps for both the concerted and stepwise mechanisms. We further found the carbenium ion stability to be a quantitative reactant-type descriptor, correlating with the C–H activation barriers of the different alkanes. Importantly, we developed an alkane dehydrogenation model that captures the effect of catalyst acid–base surface properties (through dissociated H 2 binding energy) and reactant substitution (through carbenium ion stability). Additionally, we show that the dissociated H 2 binding energy can be used to predict the overall dehydrogenation turnover frequencies. Taken together, our developed methodology facilitates the screening and discovery of alkane dehydrogenation catalysts and demonstrates doping as an effective route to enhance catalytic activity.more » « less
-
Abstract Propane and propene oxidations on M1 phase MoVTeNb mixed oxide catalysts exhibit relatively high selectivity to acrolein and acrylic acid. We probe the ability of the reactant molecules to access the catalytic sites inside the heptagonal pores of these oxides and analyze elementary steps that limit selectivity. Measured propane/cyclohexane activation rate ratios on MoVTeNbO are nearly an order of magnitude higher than non‐microporous VOx/SiO2, which suggests significant contribution of M1 phase pores to propane activation because both molecules react via homologous rate‐limiting C−H activation. Density functional theory suggests that desired C3H8dehydrogenation and C3H6allylic oxidation to acrolein and acrylic acid are limited by C−H activation steps, while less valuable oxygenates form via steps limited by C−O bond formation. Calculated activation barriers for C−O formation are invariably higher than C−H activation when these activations occur inside the pores, suggesting that reactions restricted within the pores are highly selective to desired products. These results demonstrate the role of pore confinement and a framework to assess selectivity limitation in hydrocarbon oxidations involving a complex network of sequential and parallel steps.more » « less
-
Abstract The pathways for the reactions of aluminum oxide cluster ions with ethane have been measured. For selected ions (Al2O+, Al3O2+, Al3O4+, Al4O7+) the structure of the collisionally‐stabilized reaction intermediates were explored by measuring the photodissociation vibrational spectra from 2600 cm−1–3100 cm−1. Density functional theory was used to calculate features of the potential energy surfaces for the reactions and the vibrational spectra of intermediates. Generally, more than one isomer contributes to the observed spectrum. The oxygen‐deficient clusters Al2O+and Al3O2+have large C−H activation barriers, so only the entrance channel complexes in which intact C2H6binds to aluminum are observed. This interaction leads to a substantial (~200 cm−1) red shift of the C−H symmetric stretch in ethane, indicating significant weakening of the proximal C−H bonds. In Al3O4+, the complex formed by interactions with three C2H6is investigated and, in addition to entrance channel complexes, the C−H activation intermediate Al3O4H+(C2H5)(C2H6)2is observed. For oxygen‐rich Al4O7+, the C2H6is favored to bind at an aluminum site far from the reactive superoxide group, reducing the reactivity. As expected, oxygen‐rich species and open‐shell cluster ions have smaller barriers for C−H bond activation, except for Al3O4+which is predicted and observed to be reactive.more » « less
-
Abstract Developing improved catalysts for sustainable chemical processes often involves understanding atomistic origins of catalytic activity, selectivity, and stability. Using density functional theory and steady‐state kinetic analyses, we probe the elementary steps that form decomposition products that limit selectivity in vinyl acetate (VA) synthesis on Pd surfaces covered with acetate species. Acetate formation and coupling with ethylene control the VA formation catalytic cycle and steady‐state coverage, but acetate and ethylene can separately decompose to form CO2. Both decompositions involve initial C−H activations at acetate vacancies, followed by additional C−H activations and eventual C−O formations and C−C cleavages involving reactions with molecular oxygen. Acetate decomposition paths with non‐oxidative kinetically‐relevant steps exhibit similar free energy barriers to oxidative paths. In contrast, the non‐oxidative ethylene path involving an ethylidyne intermediate exhibits a much lower barrier than paths with oxidative kinetically‐relevant steps. Ethylene decomposition is very facile at low coverages but is more coverage‐sensitive, leading to similar decomposition and VA formation barriers at coverages accessible at steady state, which is consistent with moderate VA selectivity in measurements and ethylene vs. acetate decomposition contributions assessed from regressed kinetic parameters. These insights provide a detailed framework for describing VA synthesis rates and selectivity on metallic catalyst surfaces.more » « less
