The direct-growth technique was used to synthesize several macromonomers (MMs) employing reversible addition–fragmentation chain transfer (RAFT) polymerization by growing directly from a norbornene-functionalized chain transfer agent (CTA). We aimed to investigate the formation of bisnorbornenyl species resulting from radical termination by combination ( i.e. , coupling) during RAFT polymerization at different monomer conversion values in four types of monomers: styrene, tert -butyl acrylate, methyl methacrylate and N -acryloyl morpholine. Ring-opening metathesis polymerization (ROMP) of these MMs using Grubbs' 3rd generation catalyst (G3) at an MM : G3 ratio of 100 : 1 resulted in the formation of bottlebrush polymers. Analysis by size-exclusion chromatography (SEC) revealed high molar mass shoulders of varying intensities attributed to the incorporation of these bisnorbornenyl species to generate dimeric or higher-order bottlebrush polymer oligomers. The monomer type in the RAFT step heavily influenced the amount of these bottlebrush polymer dimers and oligomers, as did the monomer conversion value in the RAFT step: We found that the ROMP of polystyrene MMs with a target backbone degree of polymerization of 100 produced detectable coupling at ≥20% monomer conversion in the RAFT step, while it took ≥80% monomer conversion to observe coupling in the poly( tert -butyl acrylate) MMs. We did not detect coupling in the poly(methyl methacrylate) MMs, but broadening of the SEC peaks and an increase in dispersity occurred, suggesting the presence of metathesis-active alkene-containing chain ends created by disproportionation. Finally, poly( N -acryloyl morpholine) MMs, even when reaching 90% monomer conversion in the RAFT step, showed no detectable coupling in the bottlebrush polymers. These results highlight the importance of monomer choice and RAFT polymerization conditions in making MMs for ROMP grafting-through to make well-defined bottlebrush polymers.
more »
« less
This content will become publicly available on December 14, 2024
Ring-Opening Metathesis Polymerization of the Dewar Isomer of 1,2-Azaborinine, a B–N Isostere of Benzene
The successful polymerization of the Dewar isomer of an azaborinine heterocycle is reported. Controlled ring-opening metathesis polymerization was accomplished with Grubbs and Hoveya−Grubbs second generation catalysts (G2, HG2), as well as a Z-selective Ru catalyst (HGM2001). The structure of the polymers
containing 4-membered B−N heterocycles was verified by GPC and multinuclear and 2D NMR. Differences in stereochemistry of polymers derived from G2/HG2 versus the Z-selective catalyst HGM2001 were
substantiated by 2D NOESY, FT-IR, and Raman analyses. The incorporation of B−N heterocycles into these polymer structures is promising as a route to functional polymers that contain polar side
groups.
more »
« less
- Award ID(s):
- 1904791
- NSF-PAR ID:
- 10481291
- Publisher / Repository:
- ACS
- Date Published:
- Journal Name:
- ACS Macro Letters
- Volume:
- 13
- ISSN:
- 2161-1653
- Page Range / eLocation ID:
- 21 to 27
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
more » « less
Abstract Cationic bottlebrush homopolymers are polymerized using a grafting‐through approach by ring‐opening metathesis polymerization (ROMP) to afford well‐defined polymers. Quaternary ammonium macromonomers (MMs) are prepared by quaternizing tertiary amine MMs synthesized by reversible addition‐fragmentation chain transfer (RAFT) polymerization. The quaternary ammonium MMs undergo ROMP to target molecular weights (
M n= 30 000–100 000 g mol−1) and a low dispersity (Đ = 1.10–1.30). Halide‐ligand exchange between the third generation Grubbs catalyst (G3) and halide counter ions (bromide and iodide ions) of MMs changes the catalyst activity throughout ROMP, causing it to deviate from pseudo‐first order kinetic behavior; however, the polymerization still follows controlled behavior without significant catalyst termination. Increasing steric bulk of the MMs decreases the polymerization rate as well. Amphiphilic block copolymers are synthesized by sequential polymerization of quaternary ammonium MMs and polystyrene (PS) MMs. Using a PS macroinitiator affords block copolymers with lowerĐ values as compared to the less active cationic macroinitiator. -
Organocatalyzed ring-opening polymerization (O-ROP) of a six-five bicyclic lactone, 4,5- trans -cyclohexyl-fused γ-butyrolactone (4,5-T6GBL), can be topologically selective or living at room temperature, depending on catalyst structure. A screening of (thio)urea [(T)U] and organic base pairs revealed unique trends in reactivity for this monomer as well as the most active catalyst pairs, which were employed as received commercially to produce relatively high molecular weight ( M n up to 106 kDa), low dispersity ( Đ = 1.04) linear poly(4,5-T6GBL) in a living fashion. The ROP using a hybrid organic/inorganic pair of TU/KOMe in neat conditions led to poly(4,5-T6GBL) with even higher molecular weight ( M n = 215 kDa, Đ = 1.04). In comparison to the metal-catalyzed system, (T)U-base pairs exhibited competitive kinetics and reached higher monomer conversions, and their reactions can be performed in air. In addition, the resulting polymers required less purification to produce materials with higher onset decomposition temperature. (T)U-base pairs were selective towards linear polymerization only, whereas triazabicyclodecene can catalyze both polymerization and (quantitative) depolymerization processes, depending on reaction conditions. Cyclic polymers with M n = 41–72 kDa were selectively formed via N-heterocyclic carbene-mediated zwitterionic O-ROP.more » « less
-
more » « less
ABSTRACT In this work, by means of quantum chemistry (Density Functional Theory (DFT), PW6B95/def2-TZVPP; DLPNO-CCSD(T)/CBS), HCN polymerization [(HCN)1 − 4] initiated and catalysed by a siloxyl radical (Si-O•) on a model silica surface is analysed. Linear HCN polymers (pHCN) are obtained by a radical initiated mechanism at a SiO• site and are characterized by a -(HC-N)- skeleton due to radical localization on the terminal N atom and radical attack on the C centre. NC heterocycles are formed by cyclization of the linear SiO-(HCN)3 − 4 and are always thermodynamically preferred over their linear counterparts, acting as thermodynamic sinks. Of particular interest to the astrochemistry community is the formation of the N-heterocycle 1,3,5-triazine that can be released into the gas phase at relatively low T (ΔG† = 23.3 kcal/mol). Full hydrogenation of SiO-(HCN•) follows two reaction channels with products: (a) SiO-CH3 + •NH2 or (b) amino-methanol + Si•, though characterized by slow kinetics. Nucleophilic addition of H2O to the electron-rich SiO-(HCN•) shows an unfavourable thermodynamics as well as a high-activation energy. The cleavage of the linear (HCN)1−4 from the SiO• site also shows a high thermodynamic energy penalty (ΔG≥82.0 kcal/mol). As a consequence, the silicate surface will be passivated by a chemically active ‘pHCN brush’ modifying the surface physico-chemical properties. The prospect of surface-catalysed HCN polymers exhibiting a high degree of chemical reactivity and proposed avenues for the formation of 1,3,5-triazine and amino-methanol opens exciting new chemical pathways to Complex Organic Matter formation in astrochemistry.
-
more » « less
Abstract The ring‐opening metathesis polymerization (ROMP) of cyclopropenes using hydrazonium initiators is described. The initiators, which are formed by the condensation of 2,3‐diazabicyclo[2.2.2]octane and an aldehyde, polymerize cyclopropene monomers by a sequence of [3+2] cycloaddition and cycloreversion reactions. This process generates short chain polyolefins (
M n≤9.4 kg mol−1) with relatively low dispersities (Đ ≤1.4). The optimized conditions showed efficiency comparable to that achieved with Grubbs’ 2ndgeneration catalyst for the polymerization of 3‐methyl‐3‐phenylcyclopropene. A positive correlation between monomer to initiator ratio and degree of polymerization was revealed through NMR spectroscopy.
