An official website of the United States government
Abstract Number: 327 Working Group: Aerosol Chemistry Abstract Low-pH aerosols comprise a large fraction of atmospheric fine particulate matter. The effects of pH on secondary organic aerosol (SOA) formation are not well understood, in part because of the difficulty of accurately measuring aerosol pH. Of particular interest are the atmospherically-abundant isoprene epoxydiols (IEPOX), which undergo acid-driven reactions to form SOA. Models have assumed no upper limit for IEPOX-SOA formation rates as acidity increases. However, recent work has shown that organosulfate formation from IEPOX slows as the equilibrium of inorganic sulfate (Sulfinorg) shifts from sulfate (SO42-) towards bisulfate (HSO4-), which is a weaker nucleophile. We performed a series of trans-ß-IEPOX uptake experiments with ammonium sulfate seed solutions acidified to between pH 0 and 3, and modelled time-resolved methyltetrol (MT) and methyltetrol sulfate (MTS) formation and Sulfinorg consumption (kMT = 0.018 M-2 s-1, kMTS = 0.28 M-2 s-1). We found an inflection point between pH 1 and 1.4, below which MT formation dominates and above which MTS formation dominates, consistent with a changing balance of protonated and deprotonated Sulfinorg. Modelled MT and MTS formation fit the experimental data well both above and below the inflection point except at pH 1.4, where it significantly underpredicted the data at low initial IEPOX/Sulfinorg ratios. This indicates multi-phase chemical dynamics beyond those represented in our model, leading to very efficient IEPOX-SOA formation at pH 1.4. Further investigation is warranted into the connection of IEPOX-SOA formation with initial IEPOX/Sulfinorg ratio and aerosol pH.
more »
« less
Formation Kinetics of Isoprene Epoxydiol-Derived Secondary Organic Aerosol Are Altered Near the Sulfate/Bisulfate pKa
Low-pH aerosols comprise a large fraction of atmospheric fine particulate matter. The effects of pH on secondary organic aerosol (SOA) formation are not well understood, in part because of the difficulty of accurately measuring aerosol pH. Of particular interest are the atmospherically-abundant isoprene epoxydiols (IEPOX), which undergo acid-driven reactions to form SOA. Models have assumed no upper limit for IEPOX-SOA formation rates as acidity increases. However, recent work has shown that organosulfate formation from IEPOX slows as the equilibrium of inorganic sulfate (Sulfinorg) shifts from sulfate (SO42-) towards bisulfate (HSO4-), which is a weaker nucleophile. We performed a series of trans-ß-IEPOX uptake experiments with ammonium sulfate seed solutions acidified to between pH 0 and 3, and modelled time-resolved methyltetrol (MT) and methyltetrol sulfate (MTS) formation and Sulfinorg consumption (kMT = 0.018 M-2 s-1, kMTS = 0.28 M-2 s-1). We found an inflection point between pH 1 and 1.4, below which MT formation dominates and above which MTS formation dominates, consistent with a changing balance of protonated and deprotonated Sulfinorg. Modelled MT and MTS formation fit the experimental data well both above and below the inflection point except at pH 1.4, where it significantly underpredicted the data at low initial IEPOX/Sulfinorg ratios. This indicates multi-phase chemical dynamics beyond those represented in our model, leading to very efficient IEPOX-SOA formation at pH 1.4. Further investigation is warranted into the connection of IEPOX-SOA formation with initial IEPOX/Sulfinorg ratio and aerosol pH.
more »
« less
- Award ID(s):
- 2001027
- PAR ID:
- 10486827
- Publisher / Repository:
- AAAR
- Date Published:
- Journal Name:
- 41st Meeting AAAR
- Format(s):
- Medium: X
- Location:
- Portland,
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
ABSTRACT: Isoprene has the highest atmospheric emissions of any nonmethane hydrocarbon, and isoprene epoxydiols (IEPOX) are well-established oxidation products and the primary contributors forming isoprene-derived secondary organic aerosol (SOA). Highly acidic particles (pH 0−3) widespread across the lower troposphere enable acid-driven multiphase chemistry of IEPOX, such as epoxide ring-opening reactions forming methyltetrol sulfates through nucleophilic attack of sulfate (SO4 2−). Herein, we systematically demonstrate an unexpected decrease in SOA formation from IEPOX on highly acidic particles (pH < 1). While IEPOX-SOA formation is commonly assumed to increase at low pH when more [H+] is available to protonate epoxides, we observe maximum SOA formation at pH 1 and less SOA formation at pH 0.0 and 0.4. This is attributed to limited availability of SO4 2− at pH values below the acid dissociation constant (pKa) of SO42− and bisulfate (HSO4−). The nucleophilicity of HSO4− is 100× lower than SO42−, decreasing SOA formation and shifting particulate products from low-volatility organosulfates to higher-volatility polyols. Current model parameterizations predicting SOA yields for IEPOX-SOA do not properly account for the SO42−/HSO4 − equilibrium, leading to overpredictions of SOA formation at low pH. Accounting for this underexplored acidity-dependent behavior is critical for accurately predicting SOA concentrations and resolving SOA impacts on air quality.more » « less
-
Oxidation of isoprene, the biogenic volatile organic compound with the highest emissions globally, is a large source of secondary organic aerosol (SOA) in the atmosphere. Organosulfates, particularly methyltetrol sulfates, formed from acid-driven reactions of isoprene epoxydiols (IEPOX), a key oxidation product, are important contributors to SOA mass. To date, most studies have focused on organosulfate formation on ammonium sulfate particles at low pH. However, recent work has shown sea spray aerosol (SSA) in the accumulation mode (~100 nm) is often quite acidic (pH ~ 2) and IEPOX-derived organosulfates have been identified in marine environments. Herein, we demonstrate that substantial SOA, including organosulfates, are formed on acidic sodium sulfate particles (pH = 1.3), representative of marine aerosol heterogeneously reacting with H2SO4 to form Na2SO4. For acidic sodium and ammonium sulfate particles, 31 and 28% (±1%), respectively, of inorganic sulfate is incorporated into organosulfate species, even though acidic particles with sodium versus ammonium as the primary cation formed 5% (±0.2) less SOA volume and 45% (±6%) less methyltetrol sulfates, suggesting other organosulfates may form. Even though both exhibited core-shell morphology after IEPOX uptake, physicochemical differences were observed via Raman microspectroscopy, with organosulfates identified in both the core and shell of acidic ammonium sulfate SOA particles, but only in the core for acidic sodium sulfate SOA via Raman microspectroscopy. Our results suggest that isoprene-derived SOA formed on aged SSA is potentially an important, but underappreciated, source of SOA and organosulfates in marine and coastal regions and could modify SOA budgets in these environments.more » « less
-
Oxidation of isoprene, the biogenic volatile organic compound with the highest emissions globally, is a large source of secondary organic aerosol (SOA) in the atmosphere. Organosulfates, particularly methyltetrol sulfates formed from acid-driven reactions of the oxidation product isoprene epoxydiol (IEPOX) onto particulate sulfate, are important contributors to SOA mass. To date, most studies have focused on organosulfate formation on ammonium sulfate particles at low pH. However, recent work has shown that sea spray aerosol (SSA) in the accumulation mode (~100 nm) is often quite acidic (pH ~ 2). Marine biota are well-established sources of isoprene, with annual global oceanic fluxes of isoprene estimated to range from 1-12 Tg, and IEPOX-derived organosulfates have been identified in marine environments. Herein, we demonstrate that substantial SOA, including organosulfates, are formed on acidic sodium sulfate particles, representative of marine aerosol heterogeneously reacting with H2SO4 to form Na2SO4. We compare SOA formed from the reactive uptake of IEPOX onto particulate sulfate and find that the cation (sodium vs. ammonium) impacts the physical properties and chemical composition of the SOA formed. Additionally, we investigate the formation of SOA derived from sodium sulfate based on key properties including particle acidity and the extent of exposure to oxidation via OH radicals. Our results suggest that isoprene-derived SOA formed on aged SSA is potentially an important, but underappreciated, source of SOA and organosulfates in marine and coastal regions and could modify SOA budgets and composition in these environments.more » « less
-
ABSTRACT: At fixed aerosol acidity, we recently demonstrated that dimers in isoprene epoxydiol-derived secondary organic aerosol (IEPOX-SOA) can heterogeneously react with hydroxyl radical (·OH) at faster rates than monomers. Aerosol acidity influences this aging process by enhancing the formation of oligomers in freshly generated IEPOX-SOA. Therefore, we systematically examined the role of aerosol acidity on kinetics and products resulting from heterogeneous ·OH oxidation of freshly generated IEPOX-SOA. IEPOX reacted with inorganic sulfate aerosol of varying initial pH (0.5, 1.5, and 2.5) in a steady state smog chamber to yield a constant source of freshly generated IEPOX-SOA, which was aged in an oxidation flow reactor for 0−22 equiv days of atmospheric ·OH exposure. Molecular-level chemical analyses revealed that the most acidic sulfate aerosol (pH 0.5) formed the largest oligomeric mass fraction, causing the slowest IEPOX-SOA mass decay with aging. Reactive uptake coefficients of ·OH (γOH) were 0.24 ± 0.06, 0.40 ± 0.05, and 0.49 ± 0.20 for IEPOX-SOA generated at pH 0.5, 1.5, and 2.5, respectively. IEPOXSOA became more liquid-like for pH 1.5 and 2.5, while exhibiting an irregular pattern for pH 0.5 with aging. Using kinetic and physicochemical data derived for a single aerosol pH in atmospheric models could inaccurately predict the fate of the IEPOX-SOA.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Conference Paper:
- The DOI is not currently available.
