More Like this

1. NASICON Li _1.2 Mg _0.1 Zr _1.9 (PO ₄ ) ₃ Solid Electrolyte for an All‐Solid‐State Li‐Metal Battery

   https://doi.org/10.1002/smtd.202000764  

   Zhou, Qiongyu; Xu, Biyi; Chien, Po‐Hsiu; Li, Yutao; Huang, Bing; Wu, Nan; Xu, Henghui; Grundish, Nicholas S.; Hu, Yan‐Yan; Goodenough, John B. (September 2020, Small Methods)

   Abstract A thin solid electrolyte with a high Li⁺conductivity is used to separate the metallic lithium anode and the cathode in an all‐solid‐state Li‐metal battery. However, most solid Li‐ion electrolytes have a small electrochemical stability window, large interfacial resistance, and cannot block lithium‐dendrite growth when lithium is plated on charging of the cell. Mg²⁺stabilizes a rhombohedral NASICON‐structured solid electrolyte of the formula Li_1.2Mg_0.1Zr_1.9(PO₄)₃(LMZP). This solid electrolyte has Li‐ion conductivity two orders of magnitude higher at 25 °C than that of the triclinic LiZr₂(PO₄)₃.⁷Li and⁶Li NMR confirm the Li‐ions in two different crystallographic sites of the NASICON framework with 85% of the Li‐ions having a relatively higher mobility than the other 15%. The anode–electrolyte interface is further investigated with symmetric Li/LMZP/Li cell testing, while the cathode–electrolyte interface is explored with an all‐solid‐state Li/LMZP/LiFePO₄cell. The enhanced performance of these cells enabled by the Li_1.2Mg_0.1Zr_1.9(PO₄)₃solid electrolyte is stable upon repeated charge/discharge cycling. 

   more » « less
2. Lithium‐Ion Mobility in Layered Oxide Li ₂ (La _0.75 Li _0.25 )(Ta _1.5 Ti _0.5 )O ₇ Containing Lithium on both Intra and Inter‐Stack Positions

   https://doi.org/10.1002/ejic.202100950  

   Fanah, Selorm_Joy; Ramezanipour, Farshid (February 2022, European Journal of Inorganic Chemistry)

   Abstract With the aid of neutron diffraction and electrochemical impedance spectroscopy, we have demonstrated the effect of the increase in lithium concentration and distribution on Li‐ion conductivity. This has been done through the synthesis of a layered oxide Li₂(La_0.75Li_0.25)(Ta_1.5Ti_0.5)O₇, with the so‐called Ruddlesden‐Popper type structure, where bilayer stacks of (Ta/Ti)O₆octahedra are separated by lithium ions, located in inter‐stack spaces. There are also intra‐stack spaces that are occupied by a mixture of La and Li, as confirmed by neutron diffraction. The distribution of lithium over both inter‐ and intra‐stack positions leads to the enhancement of Li‐ion conductivity in Li₂(La_0.75Li_0.25)(Ta_1.5Ti_0.5)O₇compared to Li₂La(TaTi)O₇, which has a lower concentration of lithium ions, located only in inter‐stack spaces. The analyses of real and imaginary components of electrochemical impedance data confirm the enhanced mobility of ions in Li₂(La_0.75Li_0.25)(Ta_1.5Ti_0.5)O₇. While the Li‐ion conductivity needs further improvement for practical applications, the success of the strategy implemented in this work offers a useful methodology for the design of layered ionic conductors. 

   more » « less
3. Sr(Ag _1−x Li _x ) ₂ Se ₂ and [Sr ₃ Se ₂ ][(Ag _1−x Li _x ) ₂ Se ₂ ] Tunable Direct Band Gap Semiconductors

   https://doi.org/10.1002/anie.202301191  

   Zhou, Xiuquan; Wilfong, Brandon; Chen, Xinglong; Laing, Craig; Pandey, Indra R.; Chen, Ying‐Pin; Chen, Yu‐Sheng; Chung, Duck‐Young; Kanatzidis, Mercouri G. (February 2023, Angewandte Chemie International Edition)

   Abstract Synthesizing solids in molten fluxes enables the rapid diffusion of soluble species at temperatures lower than in solid‐state reactions, leading to crystal formation of kinetically stable compounds. In this study, we demonstrate the effectiveness of mixed hydroxide and halide fluxes in synthesizing complex Sr/Ag/Se in mixed LiOH/LiCl. We have accessed a series of two‐dimensional Sr(Ag_1−xLi_x)₂Se₂layered phases. With increased LiOH/LiCl ratio or reaction temperature, Li partially substituted Ag to form solid solutions of Sr(Ag_1−xLi_x)₂Se₂withxup to 0.45. In addition, a new type of intergrowth compound [Sr₃Se₂][(Ag_1−xLi_x)₂Se₂] was synthesized upon further reaction of Sr(Ag_1−xLi_x)₂Se₂with SrSe. Both Sr(Ag_1−xLi_x)₂Se₂and [Sr₃Se₂][(Ag_1−xLi_x)₂Se₂] exhibit a direct band gap, which increases with increasing Li substitution (x). Therefore, the band gap of Sr(Ag_1−xLi_x)₂Se₂can be precisely tuned via fine‐tuningxthat is controlled by only the flux ratio and temperature. 

   more » « less
4. C ₉ N ₄ and C ₂ N ₆ S ₃ monolayers as promising anchoring materials for lithium–sulfur batteries: weakening the shuttle effect via optimizing lithium bonds

   https://doi.org/10.1039/D1CP01022K  

   Dong, Yinan; Xu, Bai; Hu, Haiyu; Yang, Jiashu; Li, Fengyu; Gong, Jian; Chen, Zhongfang (June 2021, Physical Chemistry Chemical Physics)

   The notorious polysulfide shuttle effect is a crucial factor responsible for the degradation of Li-S batteries. A good way to suppress the shuttle effect is to effectively anchor dissoluble lithium polysulfides (LPSs, Li 2 S n ) on appropriate substrates. Previous studies have revealed that Li of Li 2 S n is prone to interact with the N of N-containing materials to form Li–N bonds. In this work, by means of density functional theory (DFT) computations, we explored the possibility to form Li bonds on ten different N-containing monolayers, including BN, C 2 N, C 2 N 6 S 3 , C 9 N 4 , a covalent triazine framework (CTF), g -C 3 N 4 , p -C 3 N 4 , C 3 N 5 , S -N 2 S, and T -N 2 S, by examining the adsorption behavior of Li 2 S n ( n = 1, 2, 3, 4, 6, 8) on these two-dimensional (2D) anchoring materials (AMs), and investigated the performance of the formed Li bonds (if any) in inhibiting the shuttle effect. By comparing and analyzing the nitrogen content, the N-containing pore size, charge transfer, and Li bonds, we found that the N content and N-containing pore size correlate with the number of Li bonds, and the formed Li–N bonds between LPSs and AMs correspond well with the adsorption energies of the LPSs. The C 9 N 4 and C 2 N 6 S 3 monolayers were identified as promising AMs in Li-S batteries. From the view of Li bonds, this work provides guidelines for designing 2D N-containing materials as anchoring materials to reduce the shuttle effect in Li-S batteries, and thus improving the performance of Li-S batteries. 

   more » « less
5. Tailoring Ion Transport in Li _3‐3y Ho _1+y Cl _6‐x Br _x via Transition‐Metal Free Structural Planes and Charge Carrier Distribution

   https://doi.org/10.1002/advs.202409668  

   Ogbolu, Bright_O; Poudel, Tej_P; Dikella, Thilina_N_D_D; Truong, Erica; Chen, Yudan; Hou, Dewen; Li, Tianyi; Liu, Yuzi; Gabriel, Eric; Xiong, Hui; et al (December 2024, Advanced Science)

   Abstract Localized atomistic disorder in halide‐based solid electrolytes (SEs) can be leveraged to boost Li⁺mobility. In this study, Li⁺transport in structurally modified Li₃HoCl₆, via Br⁻introduction and Li⁺deficiency, is explored. The optimized Li_3‐3yHo_1+yCl_6‐xBr_xachieves an ionic conductivity of 3.8 mS cm⁻¹at 25 °C, the highest reported for holmium halide materials.^6,7Li nuclear magnetic resonance and relaxometry investigations unveil enhanced ion dynamics with bromination, attaining a Li⁺motional rate neighboring 116 MHz. X‐ray diffraction analyses reveal mixed‐anion‐induced phase transitions with disproportionate octahedral expansions and distortions, creating Ho‐free planes with favorable energetics for Li⁺migration. Bond valence site energy analysis highlights preferred Li⁺transport pathways, particularly in structural planes devoid of Ho³⁺blocking effects. Molecular dynamics simulations corroborate enhanced Li⁺diffusion with Br⁻introduction into Li₃HoCl₆. Li‐Ho electrostatic repulsions in the (001) plane presumably drive Li⁺diffusion into the Ho‐free (002) layer, enabling rapid intraplanar Li⁺motion and exchange between the 2d and 4h sites. Li_3‐3yHo_1+yCl_6‐xBr_xalso demonstrates good battery cycling stability. These findings offer valuable insights into the intricate correlations between structure and ion transport and will help guide the design of high‐performance fast ion conductors for all‐solid‐state batteries. 

   more » « less