An official website of the United States government
Total pelagic fish abundance data were collected annually in mid-summer using sonar along a set of transects in each of eight lakes (Allequash, Big Muskellunge, Crystal, Sparkling, Trout, Mendota, Monona, and Fish), from 1981-1999, and in Lakes Monona and Fish from 1995-1999. This data is not available online (contact gahler@wisc.edu). No data was collected in 2000. In 2001, collection resumed on Crystal, Sparkling, and Trout. In 2005, collection resumed on Lake Mendota. This data is included in this dataset as CSV files. The data represent lake-wide density estimates for abundant pelagic prey species in each lake. The sampling on each lake was conducted in depths greater than 5 meters to avoid hazards to equipment. In addition, because of the near field acoustic effects, the upper 2 meters of the water column is not represented in the data. Although they were rare, large targets representing predatory species were excluded from the density estimation for pelagic prey species using the proportion of large targets identified during single target analysis on each lake. Densities for Sparkling, Crystal and Mendota are for the entire basin of each lake. The data shown for Trout Lake represent densities in only the south basin. Number of sites: 4
more »
« less
Spatially Distributed Lake Mendota EXO Multi-Parameter Sonde Measurements 2019-2022
This data was collected over 34 sampling trips during four summers (May-October), 2019-2022. 35 grid boxes were generated over Lake Mendota. Before each sampling effort, sample point locations were randomized within each grid box. Surface measurements were taken with an EXO multi-parameter sonde at a subset of the 35 grid boxes throughout Lake Mendota during each sampling trip. Measurements include temperature, conductivity, chlorophyll, phycocyanin, turbidity, dissolved organic material, ODO, pH, and pressure.
more »
« less
- Award ID(s):
- 2025982
- PAR ID:
- 10492857
- Publisher / Repository:
- Environmental Data Initiative
- Date Published:
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Zooplankton samples for the 4 southern Wisconsin LTER lakes (Mendota, Monona, Wingra, Fish) have been collected for analysis by LTER since 1995 (1996 Wingra, Fish) when the southern Wisconsin lakes were added to the North Temperate Lakes LTER project. Samples are collected as a vertical tow using an 80-micron mesh conical net with a 30-cm diameter opening (net mouth: net length ratio = 1:3) consistent with sampling conducted by the Wisconsin Dept. Natural Resources in prior years. Zooplankton tows are taken in the deep hole region of each lake at the same time and location as other limnological sampling; zooplankton samples are preserved in 70% ethanol for later processing. Samples are usually collected with standard tow depths on most dates (e.g., 20 meters for Lake Mendota) but not always, so tow depth is recorded as a variate in the database. Crustacean species are identified and counted for Mendota and Monona and body lengths are recorded for a portion of each species identified (see data protocol for counting procedure); samples for Wingra and Fish lakes are archived but not routinely counted. Numerical densities for Mendota and Monona zooplankton samples are reported in the database as number or organisms per square meter without correcting for net efficiency. [Net efficiency varies from a maximum of about 70% under clear water conditions; net efficiency declines when algal blooms are dense (Lathrop, R.C. 1998. Water clarity responses to phosphorus and Daphnia in Lake Mendota. Ph.D. Thesis, University of Wisconsin-Madison.)] Organism densities in number per cubic meter can be obtained by dividing the reported square-meter density by the tow depth, although adjustments for the oxygenated depth zone during the summer and early fall stratified season is required to obtain realistic zooplankton volumetric densities in the lake's surface waters. Biomass densities can be calculated using literature formulas for converting organism body lengths reported in the database to body masses. Sampling Frequency: bi-weekly during ice-free season from late March or early April through early September, then every 4 weeks through late November; sampling is conducted usually once during the winter (depending on ice conditions). Number of sites: 4 Note: for a period between approximately 2011 and 2015, a calculation error caused density values to be significantly greater than they should have been for the entire dataset. That issue has been corrected.more » « less
-
Phytoplankton samples for the 4 southern Wisconsin LTER lakes (Mendota, Monona, Wingra, Fish) have been collected for analysis by LTER since 1995 (1996 Wingra, Fish) when the southern Wisconsin lakes were added to the North Temperate Lakes LTER project. Samples are collected as a composite whole-water sample and are preserved in gluteraldehyde. Composite sample depths are 0-8 meters for Lake Mendota (to conform to samples collected and analyzed since 1990 for a UW/DNR food web research study), and 0-2 meters for the other three lakes. A tube sampler is used for the 0-8 m Lake Mendota samples; samples for the other lakes are obtained by collecting water at 1-meter intervals using a Kemmerer water sampler and compositing the samples in a bucket. Samples are taken in the deep hole region of each lake at the same time and location as other limnological sampling. Phytoplankton samples are analyzed by PhycoTech, Inc., a private lab specializing in phytoplankton analyses (see data protocol for procedures). Samples for Wingra and Fish lakes are archived but not routinely counted. Permanent slide mounts (3 per sample) are prepared for all analyzed Mendota and Monona samples as well as 6 samples per year for Wingra and Fish; the slide mounts are archived at the University of Wisconsin - Madison Zoology Museum. Phytoplankton are identified to species using an inverted microscope (Utermohl technique) and are reported as natural unit (i.e., colonies, filaments, or single cells) densities per mL, cell densities per mL, and algal biovolume densities per mL. Multiple entries for the same species on the same date may be due to different variants or vegetative states - (e.g., colonial or attached vs. free cell.) Biovolumes for individual cells of each species are determined during the counting procedure by obtaining cell measurements needed to calculate volumes for geometric solids (e.g., cylinders, spheres, truncated cones) corresponding to actual cell shapes. Biovolume concentrations are then computed by mulitplying the average cell biovolume by the cell densities in the water sample. Note that one million cubicMicrometers of biovolume PerMilliliter of water are equal to a biovolume concentration of one cubicMillimeterPerMilliliter. Assuming a cell density equal to water, a cubicMillimeterPerMilliliter of biovolume converts to a biomass concentration of one milligramPerLiter. Sampling Frequency: bi-weekly during ice-free season from late March or early April through early September, then every 4 weeks through late November; sampling is conducted usually once during the winter (depending on ice conditions). Number of sites: 4 Several taxonomic updates have been made to this dataset February 2013, see methods for details.more » « less
-
Parameters characterizing the physical limnology of the eleven primary lakes (Allequash, Big Muskellunge, Crystal, Sparkling, Trout, bog lakes 27-02 [Crystal Bog] and 12-15 [Trout Bog], Mendota, Monona, Wingra and Fish) are measured at one station in the deepest part of each lake at 0.25-m to 1-m depth intervals depending on the lake. Measured parameters in the data set include water temperature, vertical penetration of photosynthetically active radiation (PAR), dissolved oxygen, as well as the derived parameter percent oxygen saturation. Sampling Frequency: fortnightly during ice-free season - every 6 weeks during ice-covered season for the northern lakes. The southern lakes are similar except that sampling occurs monthly during the fall and typically only once during the winter (depending on ice conditions). Number of sites: 11 Please consult NTL's website for information on experimental lake manipulations and the DNR's website for management activitiesmore » « less
-
Conductivity and chloride were measured for 2 years in nine tributaries of Lake Mendota and Lake Monona in Dane County, WI. HOBO Conductivity loggers continuously measured absolute conductivity and water temperature every 30 minutes. Breaks in data collection were due to a calibration period or if the loggers were out of the water. Grab samples for chloride concentration occurred weekly or biweekly. Conductivity and water temperature were measured with a field meter at each sampling excursion. This data was needed for a master’s research thesis with the goal of characterizing the spatial distribution and loading of chloride in the Upper Yahara River Watershed.more » « less
