Various tools have been developed to model the aerodynamics of flapping wings. In particular, quasi-steady models, which are considerably faster and easier to solve than the Navier–Stokes equations, are often utilized in the study of flight dynamics of flapping wing flyers. However, the accuracy of the quasi-steady models has not been properly documented. The objective of this study is to assess the accuracy of a quasi-steady model by comparing the resulting aerodynamic forces against three-dimensional (3D) Navier–Stokes solutions. The same wing motion is prescribed at a fruit fly scale. The pitching amplitude, axis, and duration are varied. Comparison of the aerodynamic force coefficients suggests that the quasi-steady model shows significant discrepancies under extreme pitching motions, i.e., the pitching motion is large, quick, and occurs about the leading or trailing edge. The differences are as large as 1.7 in the cycle-averaged lift coefficient. The quasi-steady model performs well when the kinematics are mild, i.e., the pitching motion is small, long, and occurs near the mid-chord with a small difference in the lift coefficient of 0.01. Our analysis suggests that the main source for the error is the inaccuracy of the rotational lift term and the inability to model the wing-wake interaction in the quasi-steady model.
more »
« less
Aerodynamic response of a red-tailed hawk to discrete transverse gusts
A limiting factor in the design of smaller size uncrewed aerial vehicles is their inability to navigate through gust-laden environments. As a result, engineers have turned towards bio-inspired engineering approaches for gust mitigation techniques. In this study, the aerodynamics of a red-tailed hawk’s response to variable-magnitude discrete transverse gusts was investigated. The hawk was flown in an indoor flight arena instrumented by multiple high-speed cameras to quantify the 3D motion of the bird as it navigated through the gust. The hawk maintained its flapping motion across the gust in all runs; however, it encountered the gust at different points in the flapping pattern depending on the run and gust magnitude. The hawk responded with a downwards pitching motion of the wing, decreasing the wing pitch angle to between −20∘and −5∘, and remained in this configuration until gust exit. The wing pitch data was then applied to a lower-order aerodynamic model that estimated lift coefficients across the wing. In gusts slower than the forward flight velocity (low gust ratio), the lift coefficient increases at a low-rate, to a maximum of around 2–2.5. In gusts faster than the forward flight velocity (high gust ratio), the lift coefficient initially increased rapidly, before increasing at a low-rate to a value around 4–5. In both regimes, the hawk’s observed height change due to gust interaction was similar (and small), despite larger estimated lift coefficients over the high gust regime. This suggests another mitigation factor apart from the wing response is present. One potential factor is the tail pitching response observed here, which prior work has shown serves to mitigate pitch disturbances from gusts.
more » « less- NSF-PAR ID:
- 10498748
- Publisher / Repository:
- IOP Publishing
- Date Published:
- Journal Name:
- Bioinspiration & Biomimetics
- Volume:
- 19
- Issue:
- 3
- ISSN:
- 1748-3182
- Format(s):
- Medium: X Size: Article No. 036011
- Size(s):
- Article No. 036011
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
This paper experimentally investigates the flow field development and unsteady loading of three force-mitigating pitch manoeuvres during a transverse gust encounter. The manoeuvres are constructed using varying levels of theoretical and simulation fidelity and implemented as open-loop kinematics in a water towing tank. It is found that pitch actuation during a gust encounter results in two important changes in flow topology: (i) early detachment of the leading-edge vortex (LEV) and (ii) formation of an LEV on the pressure side of the wing upon gust exit. Each of the pitch manoeuvres is found to mitigate a significant portion of the circulatory contribution of the lift force while only manoeuvres with accurate modelling of the added-mass force are found to adequately mitigate the total lift force. The penalty of aerodynamic lift mitigation using pitch manoeuvres was a twofold increase in the pitching moment transients experienced by the wing for all cases. By quantifying changes in the vertical gust momentum before and after the encounter, lift-mitigating manoeuvres were found to reduce the disturbance to the gust's flow field, thereby reducing the momentum exchange between the gust and the wing.more » « less
-
Abstract Flapping flight of animals has captured the interest of researchers due to their impressive flight capabilities across diverse environments including mountains, oceans, forests, and urban areas. Despite the significant progress made in understanding flapping flight, high-altitude flight as showcased by many migrating animals remains underexplored. At high-altitudes, air density is low, and it is challenging to produce lift. Here we demonstrate a first lift-off of a flapping wing robot in a low-density environment through wing size and motion scaling. Force measurements showed that the lift remained high at 0.14 N despite a 66% reduction of air density from the sea-level condition. The flapping amplitude increased from 148 to 233 degrees, while the pitch amplitude remained nearly constant at 38.2 degrees. The combined effect is that the flapping-wing robot benefited from the angle of attack that is characteristic of flying animals. Our results suggest that it is not a simple increase in the flapping frequency, but a coordinated increase in the wing size and reduction in flapping frequency enables the flight in lower density condition. The key mechanism is to preserve the passive rotations due to wing deformation, confirmed by a bioinspired scaling relationship. Our results highlight the feasibility of flight under a low-density, high-altitude environment due to leveraging unsteady aerodynamic mechanisms unique to flapping wings. We anticipate our experimental demonstration to be a starting point for more sophisticated flapping wing models and robots for autonomous multi-altitude sensing. Furthermore, it is a preliminary step towards flapping wing flight in the ultra-low density Martian atmosphere.more » « less
-
Abstract Insect wings are heterogeneous structures, with flexural rigidity varying one to two orders of magnitude over the wing surface. This heterogeneity influences the deformation the flapping wing experiences during flight. However, it is not well understood how this flexural rigidity gradient affects wing performance. Here, we develop a simplified 2D model of a flapping wing as a pitching, plunging airfoil using the assumed mode method and unsteady vortex lattice method to model the structural and fluid dynamics, respectively. We conduct parameter studies to explore how variable flexural rigidity affects mean lift production, power consumption and the forces required to flap the wing. We find that there is an optimal flexural rigidity distribution that maximizes lift production; this distribution generally corresponds to a 3:1 ratio between the wing’s flapping and natural frequencies, though the ratio is sensitive to flapping kinematics. For hovering flight, the optimized flexible wing produces 20% more lift and requires 15% less power compared to a rigid wing but needs 20% higher forces to flap. Even when flapping kinematics deviate from those observed during hover, the flexible wing outperforms the rigid wing in terms of aerodynamic force generation and power across a wide range of flexural rigidity gradients. Peak force requirements and power consumption are inversely proportional with respect to flexural rigidity gradient, which may present a trade-off between insect muscle size and energy storage requirements. The model developed in this work can be used to efficiently investigate other spatially variant morphological or material wing features moving forward.more » « less
-
more » « less
Flapping wings of insects serve for both generating aerodynamic forces and enhancing olfactory sensitivities when navigating on the odor-rich planet. Despite the extensive investigations of the aerodynamic function of flapping wings, we have limited understanding of how the flapping wings potentially affect the physiological sensitivities during flight. In this paper, direct numerical simulations were used to investigate a fruit fly model in an upwind surging motion. The wing pitch kinematics were prescribed using a hyperbolic function, which can change the wing pitch profile from a sinusoidal function to a step function by adjusting the “C” factor in the hyperbolic function. Both aerodynamic performance and olfactory detections were quantified at various wing pitch kinematics patterns. The effects of flapping wings on the odor transport were visualized using the Lagrangian approach by uniformly releasing passive odor tracers in upstream. The study revealed that the insect had the potential to achieve higher aerodynamic performance by tailoring wing pitch kinematics, but it could reduce the odor mass flux around the antenna. It was suspected that the natural flyers might sacrifice certain aerodynamic potential to enhance their olfactory sensitivity for surviving purposes. In addition, a trap-and-flick mechanism is proposed here during the supination phase in order to enhance the olfactory sensitivity. Similar to the clip-and-fling mechanism for enhancing the force generation during the pronation phase, the newly proposed trap-and-flick mechanism is also due to the wing-wing interaction in flapping flight. These findings could provide important implications for engineering applications of odor-guided flapping flight.
