An official website of the United States government
Abstract One systematic limitation of solar coronal hole (CH) detection at extreme ultraviolet (EUV) wavelengths is the obscuration of dark regions of the corona by brighter structures along the line of sight. Another problem arises when using CHs to compute the Sun’s open magnetic flux, where surface measurements of the radial magnetic field, , are situated slightly below the effective height of coronal EUV emission. In this paper, we explore these two limitations utilizing a thermodynamic magnetohydrodynamic (MHD) model of the corona for Carrington rotation (CR) 2101, where we generate CH detections from EUV 193 Å images of the corona forward-modeled from the MHD solution, and where the modeled open field is known. We demonstrate a method to combine EUV images into a full Sun map that helps alleviate CH obscuration called theminimum intensity diskmerge(MIDM). We also show the variation in measured open flux and CH area that is due to the effective height differences between EUV and measurements. We then apply the MIDM method to SDO/AIA 193 Å observations from CR 2101, and conduct an analogous analysis. In this case, the MIDM method uses time-varying images, the effects of which are discussed. We show that overall, the MIDM method and an appreciation of the effective height mismatch provide a useful new way to extract a broader view of CHs, especially near the poles. In turn, they enable improved estimates of the open magnetic flux, and help facilitate comparisons between models and observations.
more »
« less
Adjusting the Potential Field Source Surface Height Based on Magnetohydrodynamic Simulations
Abstract A potential field solution is widely used to extrapolate the coronal magnetic field above the Sun’s surface to a certain height. This model applies the current-free approximation and assumes that the magnetic field is entirely radial beyond the source surface height, which is defined as the radial distance from the center of the Sun. Even though the source surface is commonly specified at 2.5Rs(solar radii), previous studies have suggested that this value is not optimal in all cases. In this study, we propose a novel approach to specify the source surface height by comparing the areas of the open magnetic field regions from the potential field solution with predictions made by a magnetohydrodynamic model, in our case the Alfvén Wave Solar atmosphere Model. We find that the adjusted source surface height is significantly less than 2.5Rsnear solar minimum and slightly larger than 2.5Rsnear solar maximum. We also report that the adjusted source surface height can provide a better open flux agreement with the observations near the solar minimum, while the comparison near the solar maximum is slightly worse.
more »
« less
- PAR ID:
- 10498833
- Publisher / Repository:
- DOI PREFIX: 10.3847
- Date Published:
- Journal Name:
- The Astrophysical Journal Letters
- Volume:
- 965
- Issue:
- 1
- ISSN:
- 2041-8205
- Format(s):
- Medium: X Size: Article No. L1
- Size(s):
- Article No. L1
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Context.Coronal mass ejections (CMEs) are eruptions of plasma from the Sun that travel through interplanetary space and may encounter Earth. CMEs often enclose a magnetic flux rope (MFR), the orientation of which largely determines the CMEs’ geoeffectiveness. Current operational CME models do not model MFRs, but a number of research ones do, including the Open Solar Physics Rapid Ensemble Information (OSPREI) model. Aims.We report the sensitivity of OSPREI to a range of user-selected photospheric and coronal conditions. Methods.We modeled four separate CMEs observed in situ by Parker Solar Probe (PSP). We varied the input photospheric conditions using four input magnetograms (HMI Synchronic, HMI Synoptic, GONG Synoptic Zero-Point Corrected, and GONG ADAPT). To vary the coronal field reconstruction, we employed the Potential Field Source Surface (PFSS) model and varied its source-surface height in the range 1.5–3.0R⊙with 0.1R⊙increments. Results.We find that both the input magnetogram and PFSS source surface often affect the evolution of the CME as it propagates through the Sun’s corona into interplanetary space, and therefore the accuracy of the MFR prediction compared to in situ data at PSP. There is no obvious best combination of input magnetogram and PFSS source surface height. Conclusions.The OSPREI model is moderately sensitive to the input photospheric and coronal conditions. Based on where the source region of the CME is located on the Sun, there may be best practices when selecting an input magnetogram to use.more » « less
-
Abstract We use in situ measurements from the first 19 encounters of Parker Solar Probe and the most recent five encounters of Solar Orbiter to study the evolution of the turbulent sonic Mach numberMt(the ratio of the amplitude of velocity fluctuations to the sound speed) with radial distance and its relationship to density fluctuations. We focus on the near-Sun region with radial distances ranging from about 11 to 80R⊙. Our results show that (1) the turbulent sonic Mach numberMtgradually moves toward larger values as it approaches the Sun, until at least 11R⊙, whereMtis much larger than the previously observed value of 0.1 at and above 0.3 au; (2) transonic turbulence withMt ∼ 1 is observed in situ for the first time and is found mostly near the Alfvén critical surface; (3) Alfvén Mach number of the bulk flowMAshows a strong correlation with the plasma beta, indicating that most of the observed sub-Alfvénic intervals correspond to a low-beta plasma; (4) the scaling relation between density fluctuations andMtgradually changes from a linear scaling at larger radial distances to a quadratic scaling at smaller radial distances; and (5) transonic turbulence is more compressible than subsonic turbulence, with enhanced density fluctuations and slightly flatter spectra than subsonic turbulence. A systematic understanding of compressible turbulence near the Sun is necessary for future solar wind modeling efforts.more » « less
-
Abstract Coronal holes are recognized as the primary sources of heliospheric open magnetic flux (OMF). However, a noticeable gap exists between in situ measured OMF and that derived from remote-sensing observations of the Sun. In this study, we investigate the OMF evolution and its connection to solar structures throughout 2014, with special emphasis on the period from September to October, where a sudden and significant OMF increase was reported. By deriving the OMF evolution at 1 au, modeling it at the source surface, and analyzing solar photospheric data, we provide a comprehensive analysis of the observed phenomenon. First, we establish a strong correlation between the OMF increase and the solar magnetic field derived from a potential-field source-surface model (ccPearson= 0.94). Moreover, we find a good correlation between the OMF and the open flux derived from solar coronal holes (ccPearson= 0.88), although the coronal holes only contain 14%–32% of the Sun’s total open flux. However, we note that while the OMF evolution correlates with coronal hole open flux, there is no correlation with the coronal hole area evolution (ccPearson= 0.0). The temporal increase in OMF correlates with the vanishing remnant magnetic field at the southern pole, caused by poleward flux circulations from the decay of numerous active regions months earlier. Additionally, our analysis suggests a potential link between the OMF enhancement and the concurrent emergence of the largest active region in solar cycle 24. In conclusion, our study provides insights into the strong increase in OMF observed during 2014 September–October.more » « less
-
Using non-linear force free field (NLFFF) extrapolation, 3D magnetic fields were modeled from the 12-min cadence Solar Dynamics Observatory Helioseismic and Magnetic Imager (HMI) photospheric vector magnetograms, spanning a time period of 1 hour before through 1 hour after the start of 18 X-class and 12 M-class solar flares. Several magnetic field parameters were calculated from the modeled fields directly, as well as from the power spectrum of surface maps generated by summing the fields along the vertical axis, for two different regions: areas with photospheric |Bz|≥ 300 G (active region—AR) and areas above the photosphere with the magnitude of the non-potential field (BNP) greater than three standard deviations above of the AR field and either the unsigned twist number |Tw| ≥ 1 turn or the shear angle Ψ ≥ 80° (non-potential region—NPR). Superposed epoch (SPE) plots of the magnetic field parameters were analyzed to investigate the evolution of the 3D solar field during the solar flare events and discern consistent trends across all solar flare events in the dataset, as well as across subsets of flare events categorized by their magnetic and sunspot classifications. The relationship between different flare properties and the magnetic field parameters was quantitatively described by the Spearman ranking correlation coefficient, rs. The parameters that showed the most consistent and discernable trends among the flare events, particularly for the hour leading up to the eruption, were the total unsigned fluxϕ), free magnetic energy (EFree), total unsigned magnetic twist (τTot), and total unsigned free magnetic twist (ρTot). Strong (|rs| ∈ [0.6, 0.8)) to very strong (|rs| ∈ [0.8, 1.0]) correlations were found between the magnetic field parameters and the following flare properties: peak X-ray flux, duration, rise time, decay time, impulsiveness, and integrated flux; the strongest correlation coefficient calculated for each flare property was 0.62, 0.85, 0.73, 0.82, −0.81, and 0.82, respectively.more » « less
