Abstract Three binuclear species [LCoIII2(μ‐Pz)2](ClO4)3(1), [LNiII2(CH3OH)2Cl2]ClO4(2), and [LZnII2Cl2]PF6(3) supported by the deprotonated form of the ligand 2,6‐bis[bis(2‐pyridylmethyl) amino‐methyl]‐4‐methylphenol were synthesized, structurally characterized as solids and in solution, and had their electrochemical and spectroscopic behavior established. Species1–3had their water reduction ability studied aiming to interrogate the possible cooperative catalytic activity between two neighboring metal centers. Species1and2reduced H2O to H2effectively at an applied potential of −1.6 VAg/AgCl, yielding turnover numbers of 2,820 and 2,290, respectively, after 30 minutes. Species3lacked activity and was used as a negative control to eliminate the possibility of ligand‐based catalysis. Pre‐ and post‐catalytic data gave evidence of the molecular nature of the process within the timeframe of the experiments. Species1showed structural, rather than electronic cooperativity, while species2displayed no obvious cooperativity. DFT methods complemented the experimental results determining plausible mechanisms.
more »
« less
Aqueous Zn-Tetrazine Batteries with Cooperative Zn 2+ /H + Insertion
- Award ID(s):
- 2011876
- PAR ID:
- 10513018
- Publisher / Repository:
- ACS
- Date Published:
- Journal Name:
- ACS Applied Materials & Interfaces
- Volume:
- 16
- Issue:
- 5
- ISSN:
- 1944-8244
- Page Range / eLocation ID:
- 5937 to 5942
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Fibrin is the main component of blood clots. The mechanical properties of fibrin are therefore of critical importance in successful hemostasis. One of the divalent cations released by platelets during hemostasis is Zn2+; however, its effect on the network structure of fibrin gels and on the resultant mechanical properties remains poorly understood. Here, by combining mechanical measurements with three-dimensional confocal microscopy imaging, we show that Zn2+can tune the fibrin network structure and alter its mechanical properties. In the presence of Zn2+, fibrin protofibrils form large bundles that cause a coarsening of the fibrin network due to an increase in fiber diameter and reduction of the total fiber length. We further show that the protofibrils in these bundles are loosely coupled to one another, which results in a decrease of the elastic modulus with increasing Zn2+concentrations. We explore the elastic properties of these networks at both low and high stress: At low stress, the elasticity originates from pulling the thermal slack out of the network, and this is consistent with the thermal bending of the fibers. By contrast, at high stress, the elasticity exhibits a common master curve consistent with the stretching of individual protofibrils. These results show that the mechanics of a fibrin network are closely correlated with its microscopic structure and inform our understanding of the structure and physical mechanisms leading to defective or excessive clot stiffness.more » « less
-
null (Ed.)Stimuli-responsive supramolecular gels and metallogels have been widely explored in the past decade, but the fabrication of metallogels with reversible photoresponsive properties remains largely unexplored. In this study, we report the construction of photoresponsive hybrid zinc-based metallohydrogel systems coassembled from an imidazole functionalized phenylalanine derivative gelator (ImF) and carboxylic acid functionalized arylazopyrazole (AzoPz) molecular photoswitches in the presence of Zn 2+ ions. Unlike traditional covalent conjugation, noncovalent introduction of small molecular switches into the gel matrix provides a convenient route to generate photoresponsive functional materials with tunable properties and expands the scope of optically controlled molecular self-assemblies. It has been found that the carboxylic acid functionalized AzoPz derivatives alone or mixed with the ImF moiety could not self-assemble to form any gels. However, in the presence of Zn 2+ ions they readily formed the coassembled hybrid metallogels in an alkaline aqueous solution with various morphologies. These results suggest that the gelation process was triggered by the Zn 2+ ions. In addition, the ImF gelator shows specific response to Zn 2+ ions only. The presence of the AzoPz moiety in the gel matrix makes the metallogel coassemblies photoresponsive and the reversible gel-to-sol phase transition was studied by UV-vis spectroscopy. The gels showed a slow reversible light-induced gel-to-sol phase transition under UV ( λ = 365 nm) and then sol-to-gel transition by green light ( λ = 530) irradiation resulting in the reformation of the original gel state. The morphology and viscoelastic properties of the fibrillar opaque metallogels have been characterized by transmission electron microscopy (TEM) and rheological measurement, respectively.more » « less
An official website of the United States government

