An official website of the United States government
Simultaneous spectral and polarimetric imaging enables versatile detection and multimodal characterization of targets of interest. Current architectures incorporate a 2×2 pixel arrangement to acquire the full linear polarimetric information causing spatial sampling artifacts. Additionally, they suffer from limited spectral selectivity and high color crosstalk. Here, we demonstrate a bio-inspired spectral and polarization sensor structure based on integrating semitransparent polarization-sensitive organic photovoltaics (P-OPVs) and liquid crystal polymer (LCP) retarders in a tandem configuration. Color tuning is realized by leveraging the dynamic chromatic retardation control of LCP films, while polarization sensitivity is realized by exploiting the flexible anisotropic properties of P-OPVs. The structure is marked by its ultra-thin design and its ability to detect spectral and polarimetric contents along the same optical axis, thereby overcoming the inherent limitations associated with conventional division-of-focal plane sensors.
more »
« less
Measuring the spectral response of a division-of-focal-plane polarization imager using a grating monochromator
Spectral characterizations are performed on imagers to obtain a relative spectral response (RSR) curve. This process often utilizes a grating monochromator with an output that changes polarization as a function of wavelength (our monochromator’s degree of linear polarization was found to vary from less than 10% to more than 70%). When characterizing a polarization-sensitive imager, this introduces polarization artifacts into the RSR curve. We present a simple method to avoid these polarization artifacts for division-of-focal-plane polarization imagers by directly illuminating the camera with the monochromator output and calculating the S0Stokes parameter at each super pixel, then we show consistent results from this method for two division-of-focal-plane polarization imagers. We also show that ignoring the monochromator polarization results in order-of-magnitude RSR errors. The recommended method uses an iris to limit the spatial extent of the monochromator output, which was found experimentally to increase the minimum signal-to-noise ratio by more than a factor of 2.
more »
« less
- Award ID(s):
- 1757351
- PAR ID:
- 10531252
- Publisher / Repository:
- Optical Society of America
- Date Published:
- Journal Name:
- Applied Optics
- Volume:
- 61
- Issue:
- 9
- ISSN:
- 1559-128X; APOPAI
- Format(s):
- Medium: X Size: Article No. 2364
- Size(s):
- Article No. 2364
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Recent advancements in nanofabrication technology has led to commercialization of single-chip polarization and color-polarization imaging sensors in the visible spectrum. Novel applications have arisen with the emergence of these sensors leading to questions about noise in the reconstructed polarization images. In this paper, we provide theoretical analysis for the input and output referred noise for the angle and degree of linear polarization information. We validated our theoretical model with experimental data collected from a division of focal plane polarization sensor. Our data indicates that the noise in the angle of polarization images depends on both incident light intensity and degree of linear polarization and is independent of the incident angle of polarization. However, noise in degree of linear polarization images depends on all three parameters: incident light intensity, angle and degree of linear polarization. This theoretical model can help guide the development of imaging setups to record optimal polarization information.more » « less
-
This Letter presents a novel, to the best of our knowledge, method to calibrate multi-focus microscopic structured-light three-dimensional (3D) imaging systems with an electrically adjustable camera focal length. We first leverage the conventional method to calibrate the system with a reference focal lengthf0. Then we calibrate the system with other discrete focal lengthsfiby determining virtual features on a reconstructed white plane usingf0. Finally, we fit the polynomial function model using the discrete calibration results forfi. Experimental results demonstrate that our proposed method can calibrate the system consistently and accurately.more » « less
-
When imaging underwater scenes from above the water surface, the reflection from the air–water interface creates an obscuring background that varies with illumination and viewing angles. It is well known that the reflected light is horizontally polarized, and using a vertically transmitting polarizing filter is a common technique to improve the contrast of underwater scenes. However, to our knowledge, no quantitative measurements of polarization-enabled contrast enhancement have been reported in the literature. In this work, panchromatic and RGB division-of-focal-plane polarization cameras were used to record images of black and white tiles submerged in water for determining contrast as a function of viewing angle, both without a polarizer and with a vertical polarizer. Experiments were conducted in two outdoor locations and in a black tub indoors with controlled color and brightness of the reflected background. The maximum contrast through a vertical polarizer occurred near the Brewster angle, but the amount of contrast enhancement (the ratio of contrast through a polarizer to contrast without a polarizer) was found to increase until much larger angles. Also, the observed changes in contrast resulting from changing properties of the reflected background were consistent with the Fresnel reflection coefficients.more » « less
-
ABSTRACT Spectropolarimetry enables us to measure the geometry and chemical structure of the ejecta in supernova explosions, which is fundamental for the understanding of their explosion mechanism(s) and progenitor systems. We collected archival data of 35 Type Ia supernovae (SNe Ia), observed with Focal Reducer and Low-Dispersion Spectrograph (FORS) on the Very Large Telescope at 127 epochs in total. We examined the polarization of the Si ii λ6355 Å line ($$p_{\rm Si\, \small {II}}$$) as a function of time, which is seen to peak at a range of various polarization degrees and epochs relative to maximum brightness. We reproduced the $$\Delta m_{15}\!-\!p_{\rm Si\, \small {II}}$$ relationship identified in a previous study, and show that subluminous and transitional objects display polarization values below the $$\Delta m_{15}\!-\!p_{\rm Si\, \small {II}}$$ relationship for normal SNe Ia. We found a statistically significant linear relationship between the polarization of the Si ii λ6355 Å line before maximum brightness and the Si ii line velocity and suggest that this, along with the $$\Delta m_{15}\!-\!p_{\rm Si\, \small {II}}$$ relationship, may be explained in the context of a delayed-detonation model. In contrast, we compared our observations to numerical predictions in the $$\Delta m_{15}\!-\!v_{\rm Si\, \small {II}}$$ plane and found a dichotomy in the polarization properties between Chandrasekhar and sub-Chandrasekhar mass explosions, which supports the possibility of two distinct explosion mechanisms. A subsample of SNe displays evolution of loops in the q–u plane that suggests a more complex Si structure with depth. This insight, which could not be gleaned from total flux spectra, presents a new constraint on explosion models. Finally, we compared our statistical sample of the Si ii polarization to quantitative predictions of the polarization levels for the double-detonation, delayed-detonation, and violent-merger models.more » « less
