An official website of the United States government
The binding of linear diamine counterions with different methylene chain lengths to the amino-acid-based surfactants undecanoic L-isoleucine (und-IL) and undecanoic L-norleucine (und-NL) was investigated with NMR spectroscopy. The counterions studied were 1,2-ethylenediamine, 1,3-diaminopropane, 1,4-diaminobutane, 1,5-diaminopentane, and 1,6-diaminohexane. These counterions were all linear diamines with varying spacer chain lengths between the two amine functional groups. The sodium counterion was studied as well. Results showed that when the length of the counterion methylene chain was increased, the surfactants’ critical micelle concentrations (CMC) decreased. This decrease was attributed to diamines with longer methylene chains binding to multiple surfactant monomers below the CMC and thus acting as templating agents for the formation of micelles. The entropic hydrophobic effect and differences in diamine counterion charge also contributed to the size of the micelles and the surfactants’ CMCs in the solution. NMR diffusion measurements showed that the micelles formed by both surfactants were largest when 1,4-diaminobutane counterions were present in the solution. This amine also had the largest mole fraction of micelle-bound counterions. Finally, the und-NL micelles were larger than the und-IL micelles when 1,4-diaminobutane counterions were bound to the micelle surface. A model was proposed in which this surfactant formed non-spherical aggregates with both the surfactant molecules’ hydrocarbon chains and n-butyl amino acid side chains pointing toward the micelle core. The und-IL micelles, in contrast, were smaller and likely spherically shaped.
more »
« less
An Investigation of the Effect of pH on Micelle Formation by a Glutamic Acid-Based Biosurfactant
NMR spectroscopy, molecular modeling, and conductivity experiments were used to investigate micelle formation by the amino acid-based surfactant tridecanoic L-glutamic acid. Amino acid-based biosurfactants are green alternatives to surfactants derived from petroleum. NMR titrations were used to measure the monomeric surfactant’s primary and gamma (γ) carboxylic acid pKa values. Intramolecular hydrogen bonding within the surfactant’s headgroup caused the primary carboxylic acid to be less acidic than the corresponding functional group in free L-glutamic acid. Likewise, intermolecular hydrogen bonding caused the micellar surfactant’s γ carboxylic functional group to be less acidic than the corresponding monomer value. The binding of four positive counterions to the anionic micelles was also investigated. At pH levels below 7.0 when the surfactant headgroup charge was −1, the micelle hydrodynamic radii were larger (~30 Å) and the mole fraction of micelle-bound counterions was in the 0.4–0.7 range. In the pH range of 7.0–10.5, the micelle radii decreased with increasing pH and the mole fraction of micelle bound counterions increased. These observations were attributed to changes in the surfactant headgroup charge with pH. Above pH 10.5, the counterions deprotonated and the mole fraction of micelle-bound counterions decreased further. Finally, critical micelle concentration measurements showed that the micelles formed at lower concentrations at pH 6 when the headgroup charge was predominately −1 and at higher concentrations at pH 7 where headgroups had a mixture of −1 and −2 charges in solution.
more »
« less
- Award ID(s):
- 2203652
- PAR ID:
- 10534990
- Publisher / Repository:
- MDPI
- Date Published:
- Journal Name:
- Colloids and Interfaces
- Volume:
- 8
- Issue:
- 3
- ISSN:
- 2504-5377
- Page Range / eLocation ID:
- 38
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Fluorinated surfactants are used in a wide range of applications that involve aqueous solvents incorporating various additives. The presence of organic compounds such as urea is expected to affect the self-assembly of fluorinated surfactants, however, very little is known about this. We investigated the effect of urea on the micellization in water of the common fluorinated surfactant ammonium perfluorooctanoate (APFO), and on the structure and microenvironment of the micelles that APFO forms. Addition of urea to aqueous APFO solution decreased the critical micellization concentration (CMC) and increased the counterion dissociation. The observed increase in surface area per APFO headgroup and decrease in packing density at the micelle surface suggest the localization of urea at the micelle surface in a manner that reduces headgroup repulsions. Micropolarity data further support this picture. The results presented here indicate that significant differences exist between urea effects on fluorinated surfactant and on hydrocarbon surfactant micellization in aqueous solution. For example, the CMC of sodium dodecyl sulfate (SDS) increased with urea addition, while the increase in surface area per headgroup and packing density of SDS with urea addition are much lower than those observed for APFO. This study informs fluorinated surfactant fate and transport in the environment, and also applications involving aqueous media in which urea or similar additives are present.more » « less
-
Electrical conductimetry and dynamic light scattering (DLS) were used to investigate the aggregation behaviors of four amino acid-based surfactants (AABSs; undecanoyl-glycine, undecanoyl-l-alanine, undecanoyl-l-valine, undecanoyl-l-leucine) in the presence of five linear diamine counterions (1,2-diaminoethane, 1,3-diaminopropane, 1,4-diaminobutane, 1,5-diaminopentane, 1,6-diaminohexane). Electrical conductimetry was used to measure the CMCs for each system, which ranged from 5.1 to 22.5 mM. With respect to counterions, the obtained CMCs decreased with increases in the interamine spacer length; this was attributed to the improved torsional binding flexibility in longer counterions. Strong linear correlations (mean R2 = 0.9443) were observed between the CMCs and predicted surfactant partition coefficients (logP; water/octanol), suggesting that micellization is primarily driven by the AABS’s hydrophobicity for these systems. However, significant deviations in this linear relationship were observed for systems containing 1,2-diaminoethane, 1,4-diaminobutane, and 1,6-diaminohexane (p = 0.0774), suggesting altered binding dynamics for these counterions. pH measurements during the CMC determination experiments indicated the full deprotonation of the AABSs but did not give clear insights into the counterion protonation states, thus yielding an inconclusive evaluation of their charge stabilization effects during binding. However, DLS measurements revealed that the micellar size remained largely independent of the counterion length for counterions longer than 1,2-diaminoethane, with hydrodynamic diameters ranging from 2.2 to 2.8 nm. This was explained by the formation of charge-stabilized noncovalent dimers, with each counterion bearing a full +2 charge. Conductimetry-based estimates of the degrees of counterion binding (β) and free energies of micellization (ΔG°M) revealed that bulky AABSs exhibit preferential binding to counterions with an even number of methylene groups. It is proposed that when these counterions form noncovalent dimers, perturbations in their natural geometries result in the formation of a binding pocket that accommodates the AABS steric bulk. While the direct application of these systems remains to be seen, this study provides valuable insights into the structure–property relationships that govern AABS aggregation.more » « less
-
null (Ed.)This work establishes a correlation between the selectivity of hydrogen-bonding interactions and the functionality of micelle-containing layer-by-layer (LbL) assemblies. Specifically, we explore LbL films formed by assembly of poly(methacrylic acid) (PMAA) and upper critical solution temperature block copolymer micelles (UCSTMs) composed of poly(acrylamide- co -acrylonitrile) P(AAm- co -AN) cores and polyvinylpyrrolidone (PVP) coronae. UCSTMs had a hydrated diameter of ∼380 nm with a transition temperature between 45 and 50 °C, regardless of solution pH. Importantly, micelles were able to hydrogen-bond with PMAA, with the critical interaction pH being temperature dependent. To better understand the thermodynamic nature of these interactions, in depth studies using isothermal titration calorimetry (ITC) were conducted. ITC reveals opposite signs of enthalpies for binding of PMAA with micellar coronae vs. with the cores. Moreover, ITC indicates that pH directs the interactions of PMAA with micelles, selectively enabling binding with the micellar corona at pH 4 or with both the corona and the core at pH 3. We then explore UCSTM/PMAA LbL assemblies and show that the two distinct modes of PMAA interaction with the micelles ( i.e. whether or not PMAA binds with the core) had significant effects on the film composition, structure, and functionality. Consistent with PMAA hydrogen bonding with the P(AAm- co -AN) micellar cores, a significantly higher fraction of PMAA was found within the films assembled at pH 3 compared to pH 4 by both spectroscopic ellipsometry and neutron reflectometry. Selective interaction of PMAA with PVP coronae of the assembled micelles, achieved by the emergence of partial ionization of PMAA at pH 4 was critical for preserving film functionality demonstrated as temperature-controlled swelling and release of a model small molecule, pyrene. The work done here can be applied to a multitude of assembled polymer systems in order to predict suppression/retention of their stimuli-responsive behavior.more » « less
-
Micelle fragmentation, one of the key mechanisms responsible for equilibration of kinetically trapped micelles, is investigated for block copolymer micelles in ionic liquids. In particular, the role of driving force for micelle fragmentation is studied by altering the solvent quality after micelle preparation, amounting to a jump in interfacial tension γ between solvent and the micelle core. Direct dissolution of a 1,2-polybutadiene-b-poly(ethylene oxide) copolymer (Mn = 17.5 kDa and fPEO = 0.38) in the ionic liquid [C2mim][TFSI] results in large micelles with average size 〖"〈" "R" _"h" "〉" 〗_"∘" " ≈ 68" nm and dispersity "Đ ≈ 1.27" . The solution of the as-prepared micelles is then diluted by the careful addition of a second ionic liquid [C10mim][TFSI] having lower γ with the micelle core, such that the micelles remain unaffected. The γ and hence the quality of the solvent mixture was controlled by the degree of dilution. The choice of the second solvent is based on the measurement of γ for a series of [Cxmim][TFSI] ILs with 1-2-polybutadiene homopolymer, carried out using a pendant drop test. Diluting the micelles by adding another ionic liquid with lower γ tends to decrease the equilibrium micelle size which, in turn, enhances the driving force for fragmentation of the bigger as-prepared micelles, represented by increase in the ratio of aggregation numbers Q/Qeq. Subjecting the diluted micellar solution to temperature-jump to 170 °C followed by thermal annealing leads to fragmentation of the as-prepared micelles to attain a near-equilibrium state. The micelles are characterized using in-situ dynamic light scattering technique to observe the time evolution of average micelle size, from which the relaxation time is obtained. Additionally, small-angle X-ray scattering and cryogenic transmission electron microscopy measurements were carried out to obtain the micelle core size and distribution in the micellar solutions before and after fragmentation. The enhancement in the driving force achieved by controlling the amount of low γ solvent resulted in faster fragmentation; the characteristic fragmentation time decreases monotonically on increasing the size ratio Q/Qeq from 1.2 to 5.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.3390/colloids8030038
