An official website of the United States government
Solar energy has the potential to offset a significant fraction of non-renewable electricity demands globally, yet it may occupy extensive areas when deployed at this level. There is growing concern that large renewable energy installations will displace other land uses. Where should future solar power installations be placed to achieve the highest energy production and best use the limited land resource? The premise of this work is that the solar panel efficiency is a function of the location’s microclimate within which it is immersed. Current studies largely ignore many of the environmental factors that influence Photovoltaic (PV) panel function. A model for solar panel efficiency that incorporates the influence of the panel’s microclimate was derived from first principles and validated with field observations. Results confirm that the PV panel efficiency is influenced by the insolation, air temperature, wind speed and relative humidity. The model was applied globally using bias-corrected reanalysis datasets to map solar panel efficiency and the potential for solar power production given local conditions. Solar power production potential was classified based on local land cover classification, with croplands having the greatest median solar potential of approximately 28 W/m2. The potential for dual-use, agrivoltaic systems may alleviate land competition or other spatial constraints for solar power development, creating a significant opportunity for future energy sustainability. Global energy demand would be offset by solar production if even less than 1% of cropland were converted to an agrivoltaic system.
more »
« less
Template-free scalable roll-to-roll fabrication of textured transparent film for passive radiation cooling of photovoltaics
Solar panels contributed to over 115,000 GWh of energy being produced in the United States and solar panel energy consumption has increased by 27 % at the start of the 21st century. Given the decrease of photovoltaic efficiency at higher temperatures and the increasing demand for clean energy, the development of an economical technology for solar panel cooling is necessary. Passive cooling can be achieved by infrared radiating into space. Typical solar arrays require large functional areas in order to supply a significant amount of power as compared to other sources. As such, any method to help reduce the temperature of the solar panel surfaces needs to maintain manufacturing scalability for sustainable use. We demonstrate a rapid, low-cost, template-free roll coating method to fabricate photonic composite film with SiO2 nanoparticles which possess high emissivity in the atmospheric transparent window while passing visible and near infrared light to photovoltaics beneath. When facing direct sunlight at summer noon, the coatings show a 3.5°C temperature decrease without loss of photovoltaic efficiency while having hydrophobic and contamination-resistance merits.
more »
« less
- Award ID(s):
- 2031558
- PAR ID:
- 10545238
- Publisher / Repository:
- Elsevier
- Date Published:
- Journal Name:
- Manufacturing Letters
- Volume:
- 35
- Issue:
- S
- ISSN:
- 2213-8463
- Page Range / eLocation ID:
- 166 to 173
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Solar energy has the potential to offset a significant fraction of non-renewable electricity demands globally, yet it may occupy extensive areas when deployed at this level. There is growing concern that large renewable energy installations will displace other land uses. Where should future solar power installations be placed to achieve the highest energy production and best use the limited land resource? The premise of this work is that the solar panel efficiency is a function of the location’s microclimate within which it is immersed. Current studies largely ignore many of the environmental factors that influence Photovoltaic (PV) panel function. A model for solar panel efficiency that incorporates the influence of the panel’s microclimate was derived from first principles and validated with field observations. Results confirm that the PV panel efficiency is influenced by the insolation, air temperature, wind speed and relative humidity. The model was applied globally using bias-corrected reanalysis datasets to map solar panel efficiency and the potential for solar power production given local conditions. Solar power production potential was classified based on local land cover classification, with croplands having the greatest median solar potential of approximately 28 W/m2. The potential for dual-use, agrivoltaic systems may alleviate land competition or other spatial constraints for solar power development, creating a significant opportunity for future energy sustainability. Global energy demand would be offset by solar production if even less than 1% of cropland were converted to an agrivoltaic system.more » « less
-
The temperature dependency of photovoltaic power conversion efficiency (PCE) has been a key challenge to solar applications due to intrinsic processes. Herein, an alternative strategy is developed by modulating the solar light spectrum with a series of photonic hybrids. Transparent thin films are synthesized with the solutions of porphyrin compounds and iron oxides which exhibit strong absorptions in the UV and IR regions. These spectral modulating thin films are photonically tuned via compositional optimization to absorb photons near 400 nm and above 1127 nm from solar spectrum to reduce thermalization and sub‐bandgap absorption. These spectral modulators are applied in a particular configuration above a commercial silicon panel to partially filter the simulated solar light. The PCE of the silicon panel suffers a significant decrease due to temperature increase from 22.9 to 92.9 °C after 60 min solar irradiation, resulting in a PCE decrease from 25.1% to 16.3%. With the transparent spectral modulators, upon solar irradiation for 60 min, the maximum PCE has maintained at 20.5%. The mechanisms of PCE enhancement are identified based on reduced thermalization and sub‐bandgap absorption.more » « less
-
Photovoltaic (PV) array analytics and control have become necessary for remote solar farms and for intelligent fault detection and power optimization. The management of a PV array requires auxiliary electronics that are attached to each solar panel. A collaborative industry-university-government project was established to create a smart monitoring device (SMD) and establish associated algorithms and software for fault detection and solar array management. First generation smart monitoring devices (SMDs) were built in Japan. At the same time, Arizona State University initiated research in algorithms and software to monitor and control individual solar panels. Second generation SMDs were developed later and included sensors for monitoring voltage, current, temperature, and irradiance at each individual panel. The latest SMDs include a radio and relays which allow modifying solar array connection topologies. With each panel equipped with such a sophisticated SMD, solar panels in a PV array behave essentially as nodes in an Internet of Things (IoT) type of topology. This solar energy IoT system is currently programmable and can: a) provide mobile analytics, b) enable solar farm control, c) detect and remedy faults, d) optimize power under different shading conditions, and e) reduce inverter transients. A series of federal and industry grants sponsored research on statistical signal analysis, communications, and optimization of this system. A Cyber-Physical project, whose aim is to improve solar array efficiency and robustness using new machine learning and imaging methods, was launched recentlymore » « less
-
Abstract Co‐locating solar photovoltaics with vegetation could provide a sustainable solution to meeting growing food and energy demands. However, studies quantifying multiple co‐benefits resulting from maintaining vegetation at utility‐scale solar power plants are limited. We monitored the microclimate, soil moisture, panel temperature, electricity generation and soil properties at a utility‐scale solar facility in a continental climate with different site management practices. The compounding effect of photovoltaic arrays and vegetation may homogenize soil moisture distribution and provide greater soil temperature buffer against extreme temperatures. The vegetated solar areas had significantly higher soil moisture, carbon, and other nutrients compared to bare solar areas. Agrivoltaics in agricultural areas with carbon debt can be an effective climate mitigation strategy along with revitalizing agricultural soils, generating income streams from fallow land, and providing pollinator habitats. However, the benefits of vegetation cooling effects on electricity generation are rather site‐specific and depend on the background climate and soil properties. Overall, our findings provide foundational data for site preservation along with targeting site‐specific co‐benefits, and for developing climate resilient and resource conserving agrivoltaic systems.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1016/j.mfglet.2023.08.006
