An official website of the United States government
A lubrication analysis is presented for the resistances between permeable spherical particles in near contact,$$h_0/a\ll 1$$, where$$h_0$$is the minimum separation between the particles, and$$a=a_1 a_2/(a_1+a_2)$$is the reduced radius. Darcy's law is used to describe the flow inside the permeable particles and no-slip boundary conditions are applied at the particle surfaces. The weak permeability regime$$K=k/a^{2} \ll 1$$is considered, where$$k=\frac {1}{2}(k_1+k_2)$$is the mean permeability. Particle permeability enters the lubrication resistances through two functions of$$q=K^{-2/5}h_0/a$$, one describing axisymmetric motions, the other transverse. These functions are obtained by solving an integral equation for the pressure in the near-contact region. The set of resistance functions thus obtained provide the complete set of near-contact resistance functions for permeable spheres and match asymptotically to the standard hard-sphere resistances that describe pairwise hydrodynamic interactions away from the near-contact region. The results show that permeability removes the contact singularity for non-shearing particle motions, allowing rolling without slip and finite separation velocities between touching particles. Axisymmetric and transverse mobility functions are presented that describe relative particle motion under the action of prescribed forces and in linear flows. At contact, the axisymmetric mobility under the action of oppositely directed forces is$$U/U_0=d_0K^{2/5}$$, where$$U$$is the relative velocity,$$U_0$$is the velocity in the absence of hydrodynamic interactions and$$d_0=1.332$$. Under the action of a constant tangential force, a particle in contact with a permeable half-space rolls without slipping with velocity$$U/U_0=d_1(d_2+\log K^{-1})^{-1}$$, where$$d_1=3.125$$and$$d_2=6.666$$; in shear flow, the same expression holds with$$d_1=7.280$$.
more »
« less
Near-contact approach of two permeable spheres
An analysis is presented for the axisymmetric lubrication resistance between permeable spherical particles. Darcy's law is used to describe the flow in the permeable medium and a slip boundary condition is applied at the interface. The pressure in the near-contact region is governed by a non-local integral equation. The asymptotic limit$$K=k/a^{2} \ll 1$$is considered, where$$k$$is the arithmetic mean permeability, and$$a^{-1}=a^{-1}_{1}+a^{-1}_{2}$$is the reduced radius, and$$a_1$$and$$a_2$$are the particle radii. The formulation allows for particles with distinct particle radii, permeabilities and slip coefficients, including permeable and impermeable particles and spherical drops. Non-zero particle permeability qualitatively affects the axisymmetric near-contact motion, removing the classical lubrication singularity for impermeable particles, resulting in finite contact times under the action of a constant force. The lubrication resistance becomes independent of gap and attains a maximum value at contact$$F=6{\rm \pi} \mu a W K^{-2/5}\tilde {f}_c$$, where$$\mu$$is the fluid viscosity,$$W$$is the relative velocity and$$\tilde {f}_c$$depends on slip coefficients and weakly on permeabilities; for two permeable particles with no-slip boundary conditions,$$\tilde {f}_c=0.7507$$; for a permeable particle in near contact with a spherical drop,$$\tilde {f}_c$$is reduced by a factor of$$2^{-6/5}$$.
more »
« less
- Award ID(s):
- 1603806
- PAR ID:
- 10558292
- Publisher / Repository:
- Cambridge University Press
- Date Published:
- Journal Name:
- Journal of Fluid Mechanics
- Volume:
- 925
- ISSN:
- 0022-1120
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Electrophoresis is the motion of a charged colloidal particle in an electrolyte under an applied electric field. The electrophoretic velocity of a spherical particle depends on the dimensionless electric field strength$$\beta =a^*e^*E_\infty ^*/k_B^*T^*$$, defined as the ratio of the product of the applied electric field magnitude$$E_\infty ^*$$and particle radius$$a^*$$, to the thermal voltage$$k_B^*T^*/e^*$$, where$$k_B^*$$is Boltzmann's constant,$$T^*$$is the absolute temperature, and$$e^*$$is the charge on a proton. In this paper, we develop a spectral element algorithm to compute the electrophoretic velocity of a spherical, rigid, dielectric particle, of fixed dimensionless surface charge density$$\sigma$$over a wide range of$$\beta$$. Here,$$\sigma =(e^*a^*/\epsilon ^*k_B^*T^*)\sigma ^*$$, where$$\sigma ^*$$is the dimensional surface charge density, and$$\epsilon ^*$$is the permittivity of the electrolyte. For moderately charged particles ($$\sigma ={O}(1)$$), the electrophoretic velocity is linear in$$\beta$$when$$\beta \ll 1$$, and its dependence on the ratio of the Debye length ($$1/\kappa ^*$$) to particle radius (denoted by$$\delta =1/(\kappa ^*a^*)$$) agrees with Henry's formula. As$$\beta$$increases, the nonlinear contribution to the electrophoretic velocity becomes prominent, and the onset of this behaviour is$$\delta$$-dependent. For$$\beta \gg 1$$, the electrophoretic velocity again becomes linear in field strength, approaching the Hückel limit of electrophoresis in a dielectric medium, for all$$\delta$$. For highly charged particles ($$\sigma \gg 1$$) in the thin-Debye-layer limit ($$\delta \ll 1$$), our computations are in good agreement with recent experimental and asymptotic results.more » « less
-
We examine the circular, self-similar expansion of frictional rupture due to fluid injected at a constant rate. Fluid migrates within a thin permeable layer parallel to and containing the fault plane. When the Poisson ratio$$\nu =0$$, self-similarity of the fluid pressure implies fault slip also evolves in an axisymmetric, self-similar manner, reducing the three-dimensional problem for the evolution of fault slip to a single self-similar dimension. The rupture radius grows as$$\lambda \sqrt {4\alpha _{hy} t}$$, where$$t$$is time since the start of injection and$$\alpha _{hy}$$is the hydraulic diffusivity of the pore fluid pressure. The prefactor$$\lambda$$is determined by a single parameter,$$T$$, which depends on the pre-injection stress state and injection conditions. The prefactor has the range$$0\lt \lambda \lt \infty$$, the lower and upper limits of which correspond to marginal pressurisation of the fault and critically stressed conditions, in which the fault-resolved shear stress is close to the pre-injection fault strength. In both limits, we derive solutions for slip by perturbation expansion, to arbitrary order. In the marginally pressurised limit ($$\lambda \rightarrow 0$$), the perturbation is regular and the series expansion is convergent. For the critically stressed limit ($$\lambda \rightarrow \infty$$), the perturbation is singular, contains a boundary layer and an outer solution, and the series is divergent. In this case, we provide a composite solution with uniform convergence over the entire rupture using a matched asymptotic expansion. We provide error estimates of the asymptotic expansions in both limits and demonstrate optimal truncation of the singular perturbation in the critically stressed limit.more » « less
-
Abstract Given a family$$\mathcal{F}$$of bipartite graphs, theZarankiewicz number$$z(m,n,\mathcal{F})$$is the maximum number of edges in an$$m$$by$$n$$bipartite graph$$G$$that does not contain any member of$$\mathcal{F}$$as a subgraph (such$$G$$is called$$\mathcal{F}$$-free). For$$1\leq \beta \lt \alpha \lt 2$$, a family$$\mathcal{F}$$of bipartite graphs is$$(\alpha,\beta )$$-smoothif for some$$\rho \gt 0$$and every$$m\leq n$$,$$z(m,n,\mathcal{F})=\rho m n^{\alpha -1}+O(n^\beta )$$. Motivated by their work on a conjecture of Erdős and Simonovits on compactness and a classic result of Andrásfai, Erdős and Sós, Allen, Keevash, Sudakov and Verstraëte proved that for any$$(\alpha,\beta )$$-smooth family$$\mathcal{F}$$, there exists$$k_0$$such that for all odd$$k\geq k_0$$and sufficiently large$$n$$, any$$n$$-vertex$$\mathcal{F}\cup \{C_k\}$$-free graph with minimum degree at least$$\rho (\frac{2n}{5}+o(n))^{\alpha -1}$$is bipartite. In this paper, we strengthen their result by showing that for every real$$\delta \gt 0$$, there exists$$k_0$$such that for all odd$$k\geq k_0$$and sufficiently large$$n$$, any$$n$$-vertex$$\mathcal{F}\cup \{C_k\}$$-free graph with minimum degree at least$$\delta n^{\alpha -1}$$is bipartite. Furthermore, our result holds under a more relaxed notion of smoothness, which include the families$$\mathcal{F}$$consisting of the single graph$$K_{s,t}$$when$$t\gg s$$. We also prove an analogous result for$$C_{2\ell }$$-free graphs for every$$\ell \geq 2$$, which complements a result of Keevash, Sudakov and Verstraëte.more » « less
-
We explored the settling dynamics of vertically aligned particles in a quiescent, stratified two-layer fluid using particle tracking velocimetry. Glass spheres of$$d=4\,{\rm mm}$$diameter were released at frequencies of 4, 6 and 8 Hz near the free surface, traversing through an upper ethanol layer ($$H_1$$), whereHis height or layer thickess, varying from$$10d$$to$$40d$$and a lower oil layer. Results reveal pronounced lateral particle motion in the ethanol layer, attributed to a higher Galileo number ($$Ga = 976$$, ratio of buoyancy–gravity to viscous effects), compared with the less active behaviour in the oil layer ($$Ga = 16$$). The ensemble vertical velocity of particles exhibited a minimum just past the density interface, becoming more pronounced with increasing$$H_1$$, and suggesting that enhanced entrainment from ethanol to oil resulted in an additional buoyancy force. This produced distinct patterns of particle acceleration near the density interface, which were marked by significant deceleration, indicating substantial resistance to particle motion. An increased drag coefficient occurred for$$H_1/d = 40$$compared with a single particle settling in oil; drag reduced as the particle-release frequency ($$\,f_p$$) increased, likely due to enhanced particle interactions at closer proximity. Particle pair dispersions, lateral ($$R^2_L$$) and vertical ($$R^2_z$$), were modulated by$$H_1$$, initial separation$$r_0$$and$$f_p$$. The$$R^2_L$$dispersion displayed ballistic scaling initially, Taylor scaling for$$r_0 < H_1$$and Richardson scaling for$$r_0 > H_1$$. In contrast,$$R^2_z$$followed a$$R^2_z \sim t^{5.5}$$scaling under$$r_0 < H_1$$. Both$$R^2_L$$and$$R^2_z$$plateaued at a distance from the interface, depending on$$H_1$$and$$f_p$$.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript
- Journal Article:
- https://doi.org/10.1017/jfm.2021.588
