An official website of the United States government
Piezoresistive microcantilever sensors for the detection of viruses, pathogens, and trace chemical gasses, with appropriate measurement and signal processing methods, can be a powerful instrument with high speed and sensitivity, with in situ and real-time capabilities. This paper discusses a novel method for mass sensing on the order of a few femtograms, using a dual-microcantilever piezoresistive sensor with a vibrating common base. The two microcantilevers have controllably shifted natural frequencies with only one of them being active. Two active piezoresistors are located on the surfaces of each of the two flexures, which are specifically connected in a Wheatstone bridge with two more equivalent passive resistors located on the sensor base. A dedicated experimental system measures the voltages of the two half-bridges and, after determining their amplitude–frequency responses, finds the modulus of their differences. The modified amplitude–frequency response possesses a cusp point which is a function of the natural frequencies of the microcantilevers. The signal processing theory is derived, and experiments are carried out on the temperature variation in the natural frequency of the active microcantilever. Theoretical and experimental data of the temperature–frequency influence and equivalent mass with the same impact are obtained. The results confirm the sensor’s applicability for the detection of ultra-small objects, including early diagnosis and prediction in microbiology, for example, for the presence of SARS-CoV-2 virus, other viruses, and pathogens. The versatile nature of the method makes it applicable to other fields such as medicine, chemistry, and ecology.
more »
« less
This content will become publicly available on December 1, 2025
Evaluation of the Influence of Lorentz Forces on the Natural Frequencies of a Dual-Microcantilever Sensor for Ultralow Mass Detection
In this paper, the impact of Lorentz forces and temperature on the natural frequencies of a piezoresistive sensor composed of two microcantilevers with integrated U-shaped thin-film aluminum heaters are investigated. Two types of experiments were performed. In the first, the sensor was placed in a magnetic field so that the current flowing in the heater, in addition to raising the temperature, produced Lorentz forces, inducing normal stresses in the plane of one of the microcantilevers. In the second, which were conducted without magnetic fields, only the temperature variation of the natural frequency was left. In processing of the results, the thermal variations were subtracted from the variations due to both Lorentz forces and temperature in the natural frequency, resulting in the influence of the Lorentz forces only. Theoretical relations for the Lorentz frequency offsets were derived. An indirect method of estimating the natural frequency of one of the cantilevers, through a particular cusp point in the amplitude–frequency response of the sensor, was used in the investigations. The findings show that for thin microcantilevers with silicon masses on the order of 4 × 10−7 g and currents of 25 µA, thermal eigenfrequency variations are dominant. The results may have applications in the design of similar microsensors with vibrational action.
more »
« less
- Award ID(s):
- 2210471
- PAR ID:
- 10563009
- Publisher / Repository:
- MDPI
- Date Published:
- Journal Name:
- Micro
- Volume:
- 4
- Issue:
- 4
- ISSN:
- 2673-8023
- Page Range / eLocation ID:
- 572 to 584
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Non-invasive measurement of absolute temperature is important for proper characterization of various pathologies and for evaluation of thermal dose during interventional procedures. The proton (hydrogen nucleus) magnetic resonance (MR) frequency shift method can be used to map relative temperature changes. However, spatiotemporal variations in the main magnetic field and the lack of local internal frequency reference challenge the determination of absolute temperature. Here, we introduce a multinuclear method for absolute MR thermometry, based on the fact that the hydrogen and sodium nuclei exhibit a unique and distinct characteristic frequency dependence with temperature and with electrolyte concentration. A one-to-one mapping between the precession frequency difference of the two nuclei and absolute temperature is demonstrated. Proof-of-concept experiments were conducted in aqueous solutions with different NaCl concentrations, in agarose gel samples, and in freshly excised ex vivo mouse tissues. One-dimensional chemical shift imaging experiments also demonstrated excellent agreement with infrared measurements.more » « less
-
Summary The large-scale dynamics of convection-driven dynamos in a spherical shell, as relevant to the geodynamo, is analyzed with numerical simulation data and asymptotic theory. An attempt is made to determine the asymptotic size (with the small parameter being the Ekman number, Ek) of the forces, and the associated velocity and magnetic fields. In agreement with previous work, the leading order mean force balance is shown to be thermal wind (Coriolis, pressure gradient, buoyancy) in the meridional plane and Coriolis-Lorentz in the zonal direction. The Lorentz force is observed to be weaker than the mean buoyancy force across a range of Ek and thermal forcing; the relative difference in these forces appears to be O(Ek1/6) within the parameter space investigated. We find that the thermal wind balance requires that the mean zonal velocity scales as O(Ek−1/3), whereas the meridional circulation is asymptotically smaller by a factor of O(Ek1/6). The mean temperature equation shows a balance between thermal diffusion and the divergence of the convective heat flux, indicating the presence of a mean temperature length scale of size O(Ek1/6). Neither the mean nor the fluctuating magnetic field show a strong dependence on the Ekman number, though the simulation data shows evidence of a mean magnetic field length scale of size O(Ek1/6). A consequence of the asymptotic ordering of the forces is that Taylor’s constraint is satisfied to accuracy O(Ek1/6), despite the absence of a leading-order magnetostrophic balance. Further consequences of the force balance are discussed with respect to the large-scale flows thought to be important for the geodynamo.more » « less
-
This study examines the use of a Doppler radar occupancy sensor to assess thermal adaptation. Current heating, ventilation, and air-conditioning (HVAC) systems are important for the productivity of employees and the healing of patients; however, their control systems are typically limited to a narrow temperature range, which is usually not comfortable for most occupants. Occupant vital signs can be used to assess thermal comfort, due to the role cardiovascular regulation plays in heat dissipation. This research aims to correlate physiological and thermal adaptation with the goal of optimizing HVAC system operation. A Doppler radar occupancy sensor was used to measure the physiological parameters of ten human subjects under two temperature conditions, and thermal comfort surveys were used to record thermal sensation. The results demonstrate that the Doppler radar occupancy sensor could not only detect heart rate changes due to a significant environmental temperature difference but also detect subtle changes in heart rate during thermal adaptation that were not captured by the surveys.more » « less
-
Recent studies have established immersive virtual environments (IVEs) as promising tools for studying human thermal states and human–building interactions. One advantage of using immersive virtual environments is that experiments or data collection can be conducted at any time of the year. However, previous studies have confirmed the potential impact of outdoor temperature variations, such as seasonal variations on human thermal sensation. To the best of our knowledge, no study has looked into the potential impact of variations in outdoor temperatures on experiments using IVE. Thus, this study aimed to determine if different outdoor temperature conditions affected the thermal states in experiments using IVEs. Experiments were conducted using a head mounted display (HMD) in a climate chamber, and the data was analyzed under three temperature ranges. A total of seventy-two people participated in the experiments conducted in two contrasting outdoor temperature conditions, i.e., cold and warm outdoor conditions. The in situ experiments conducted in two cases, i.e., cooling in warm outdoor conditions and heating in cold outdoor conditions, were used as a baseline. The baseline in-situ experiments were then compared with the IVE experiments conducted in four cases, i.e., cooling in warm and cold outdoor conditions and heating in warm and cold outdoor conditions. The selection of cooling in cold outdoor conditions and heating in warm outdoor conditions for IVE experiments is particularly for studying the impact of outdoor temperature variations. Results showed that under the experimental and outdoor temperature conditions, outdoor temperature variations in most cases did not impact the results of IVE experiments, i.e., IVE experiments can replicate a temperature environment for participants compared to the ones in the in situ experiments. In addition, the participant’s thermal sensation vote was found to be a reliable indicator between IVE and in situ settings in all studied conditions. A few significantly different cases were related to thermal comfort, thermal acceptability, and overall skin temperature.more » « less
