An official website of the United States government
Convective boundary layer (CBL) depth can be estimated from dual-polarization WSR-88D radars using the product differential reflectivity ZDR because the CBL top is collocated with a local ZDR minimum produced by Bragg scatter at the interface of the CBL and the free troposphere. Quasi-vertical profiles (QVPs) of ZDR are produced for each radar volume scan and profiles from successive times are stitched together to form a time–height plot of ZDR from sunrise to sunset. QVPs of ZDR often show a low-ZDR channel that starts near the ground and rises during the morning and early afternoon, identifying the CBL top. Unfortunately, results show that this channel within the QVP can occasionally be misleading. This motivated creation of a new variable DVar, which combines ZDR with its azimuthal variance and is particularly helpful at identifying the CBL top during the morning hours. Two methods are developed to track the CBL top from QVPs of ZDR and DVar. Although each method has strengths and weaknesses, the best results are found when the two methods are combined using inverse variance weighting. The ability to detect CBL depth from routine WSR-88D radar scans rather than from rawinsondes or lidar instruments would vastly improve our understanding of CBL depth variations in the daytime by increasing the temporal and spatial frequencies of the observations. Significance Statement: The daytime convective boundary layer (CBL) can increase in depth from a few hundred to a few thousand meters between sunrise and sunset and is strongly connected to temperature changes at Earth’s surface. Unfortunately, current observations of CBL depth primarily consist of measurements from twice daily rawinsonde launches at 97 locations across the United States. As a result, CBL depth observations lack fine spatial and temporal resolution and miss the daily cycle of CBL growth. This study seeks to fill the gaps in CBL depth observations by developing an automated method to estimate CBL depth from dual-polarization WSR-88D radar observations with a temporal resolution as fine as 5–10 min. These observations will greatly enhance our ability to observe and monitor CBL depth in real time.
more »
« less
This content will become publicly available on December 1, 2025
An Investigation of Convective Boundary Layer Depth and Entrainment Zone Properties Using Dual-Polarization Radar and Balloon-Borne Observations
Previous work has shown that differential reflectivity ZDR observations from National Weather Service dual-polarization Doppler weather radars (WSR-88Ds) provide accurate estimates of convective boundary layer (CBL) depth when compared with depth estimates from 0000 UTC rawinsonde observations. We extend this work by launching small rawinsondes, called Windsonds, to study ZDR signals throughout the daytime hours. Results show that it can be difficult to identify CBL depth from ZDR alone when biological scatterers are absent. The exploration of other radar variables leads to the use of azimuthal ZDR variance to help in identifying CBL characteristics. A variable that combines both ZDR and azimuthal ZDR variance, called DVar, allows for improved signal identification using the quasi-vertical profile (QVP) method. Furthermore, the QVP channel width is found to be closely tied to the overall entrainment zone (EZ) structure. Results show that the centers and vertical extents of channels of reduced DVar in QVPs correlate well with sounding-observed CBL depth and EZ depth, respectively, across all stages of CBL development and in both clear and cloud-topped CBLs. The QVP approach tends to fail in identifying CBL and EZ depths when the vertical gradient in moisture above the CBL is small. Additionally, we compare the observed EZ depth to various EZ parameterizations and show that the parameterizations generally underestimate EZ depth. We conclude that the ability of WSR-88Ds to sample the CBL should be leveraged to increase our knowledge of CBL properties. Significance Statement: The boundary layer is the lowest layer of Earth’s atmosphere and influences many weather-related phenomena. During the day, sunlight warms the surface and the convective boundary layer (CBL) forms. Even though CBL characteristics are important for accurate weather forecasts, current methods of observing the CBL are severely lacking. This study investigates the potential of using dual-polarization weather radars to expand CBL observations. We also evaluate how well simplified CBL models predict certain CBL characteristics and how they could be improved in the future.
more »
« less
- Award ID(s):
- 2045504
- PAR ID:
- 10565165
- Publisher / Repository:
- American Meteorological Society
- Date Published:
- Journal Name:
- Journal of Atmospheric and Oceanic Technology
- Volume:
- 41
- Issue:
- 12
- ISSN:
- 0739-0572
- Page Range / eLocation ID:
- 1213 to 1228
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
The vertical distribution of wildfire smoke aerosols is important in determining its environmental impacts but existing observations of smoke heights generally do not possess the temporal resolution required to fully resolve the diurnal behavior of wildfire smoke injection. We use Weather Surveillance Radar‐1988 Doppler (WSR‐88D) dual polarization data to estimate injection heights of Biomass Burning Debris (BBD) generated by fires. We detect BBD as a surrogate for smoke aerosols, which are often collocated with BBD near the fire but are not within the size range detectable by these radars. Injection heights of BBD are derived for 2–10 August 2019, using WSR‐88D reflectivity (Z ≥ 10 dBZ) and dual polarization correlation coefficients (0.2 < C.C < 0.9) to study the Williams Flats fire. Results show the expected diurnal cycles with maximum injection heights present during the late afternoon period when the fire's intensity and convective mixing are maximized. WSR‐88D and airborne lidar injection height comparisons reveal that this method is sensitive to outliers and generally overpredicts maximum heights by 40%, though mean and median heights are better captured (<20% mean error). WSR‐88D heights between the 75th and 90th percentile seem to accurately represent the maximum heights, with the exception of heights estimated during the occurrence of a pyro‐cumulonimbus. Location specific mapping of WSR‐88D and lidar injection heights reveal that they diverge further away from the fire as expected due to BBD settling. Most importantly, WSR‐88D‐derived injection height estimates provide near continuous smoke height information, allowing for the study of diurnal variability of smoke injections.more » « less
-
Abstract Typical environmental conditions associated with horizontal convective rolls (HCRs) and cellular convection have been known for over 50 years. Yet our ability to predict whether HCRs, cellular convection, or no discernable organized (null) circulation will occur within a well-mixed convective boundary layer based upon easily observed environmental variables has been limited. Herein, a large database of 50 cases each of HCR, cellular convection, and null events is created that includes observations of mean boundary layer wind and wind shear, boundary layer depth; surface observations of wind, temperature, and relative humidity; and estimates of surface sensible heat flux. Results from a multiclass linear discriminant analysis applied to these data indicate that environmental conditions can be useful in predicting whether HCRs, cellular convection, or no circulation occurs, with the analysis identifying the correct circulation type on 72% of the case days. This result is slightly better than using a mean convective boundary layer (CBL) wind speed of 6 m s−1to discriminate between HCRs and cells. However, the mean CBL wind speed has no ability to further separate out cases with no CBL circulation. The key environmental variables suggested by the discriminant analysis are mean sensible heat flux, friction velocity, and the Obukhov length.more » « less
-
The U.S. network of WSR-88D dual-polarization weather radars adheres to design standards that are intended to ensure uniform radar measures from atmospheric phenomena. Although these radars have been designed to collect weather information, they also monitor atmospheric biota. In this communication, we demonstrate that radar patterns from airborne insects from co-located WSR-88Ds can differ significantly. We explain these discrepancies as a result of different phase shifts between transmitted polarized radar waves, and we argue that this phase is a critical radar parameter for the interpretation of radar variables from airborne insects.more » « less
-
null (Ed.)Abstract Under stably stratified conditions, the dissipation rate ε of turbulence kinetic energy (TKE) is related to the structure function parameter for temperature , through the buoyancy frequency and the so-called mixing efficiency. A similar relationship does not exist for convective turbulence. In this paper, we propose an analytical expression relating ε and in the convective boundary layer (CBL), by taking into account the effects of nonlocal heat transport under convective conditions using the Deardorff countergradient model. Measurements using unmanned aerial vehicles (UAVs) equipped with high-frequency response sensors to measure velocity and temperature fluctuations obtained during the two field campaigns conducted at Shigaraki MU observatory in June 2016 and 2017 are used to test this relationship between ε and in the CBL. The selection of CBL cases for analysis was aided by auxiliary measurements from additional sensors (mainly radars), and these are described. Comparison with earlier results in the literature suggests that the proposed relationship works, if the countergradient term γ D in the Deardorff model, which is proportional to the ratio of the variances of potential temperature θ and vertical velocity w , is evaluated from in situ (airplane and UAV) observational data, but fails if evaluated from large-eddy simulation (LES) results. This appears to be caused by the tendency of the variance of θ in the upper part of the CBL and at the bottom of the entrainment zone to be underestimated by LES relative to in situ measurements from UAVs and aircraft. We discuss this anomaly and explore reasons for it.more » « less
