skip to main content
US FlagAn official website of the United States government
dot gov icon
Official websites use .gov
A .gov website belongs to an official government organization in the United States.
https lock icon
Secure .gov websites use HTTPS
A lock ( lock ) or https:// means you've safely connected to the .gov website. Share sensitive information only on official, secure websites.

Explore Research Products in the PAR
It may take a few hours for recently added research products to appear in PAR search results.


Title: GaN Magic Angle Laser in a Merged Moiré Photonic Crystal
We demonstrate optically pumped blue lasing at room temperature in a merged moiré photonic crystal fabricated out of gallium nitride with embedded, fragmented quantum wells. Lasing occurs at two closely spaced wavelengths of 450 and 451 nm, matched to simulated flat bands induced by the moirésuperlattice. Both thresholds occur at 30 μJ/cm2. Light in−light out curves were taken at both room temperature and 77 K across different gain materials, including fragmented quantum wells, continuous quantum wells, and quantum dots. Lasing was observed only at room temperature in fragmented quantum well devices, suggesting the importance of gain material carrier dynamics in unconventional laser cavities like the moiré design explored. These insights and the experimental validation of moiré simulations in a previously unexplored III−V material indicate promise toward a new kind of efficient, tunable laser.  more » « less
Award ID(s):
2234513
PAR ID:
10573773
Author(s) / Creator(s):
; ; ; ;
Publisher / Repository:
American Chemical Society
Date Published:
Journal Name:
ACS Photonics
Volume:
10
Issue:
9
ISSN:
2330-4022
Page Range / eLocation ID:
3001 to 3007
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. ; ; ; ; ; ; ; ; (, Scientific Reports)
    Abstract Optically pumped lasing from highly Zn-doped GaAs nanowires lying on an Au film substrate and from Au-coated nanowires has been demonstrated up to room temperature. The conically shaped GaAs nanowires were first coated with a 5 nm thick Al 2 O 3 shell to suppress atmospheric oxidation and band-bending effects. Doping with a high Zn concentration increases both the radiative efficiency and the material gain and leads to lasing up to room temperature. A detailed analysis of the observed lasing behavior, using finite-difference time domain simulations, reveals that the lasing occurs from low loss hybrid modes with predominately photonic character combined with electric field enhancement effects. Achieving low loss lasing from NWs on an Au film and from Au coated nanowires opens new prospects for on-chip integration of nanolasers with new functionalities including electro-optical modulation, conductive shielding, and polarization control. 
    more » « less
  2. ; ; ; ; ; ; ; ; ; (, Advanced Optical Materials)
    Abstract Electrically pumped lasing from hybrid organic–inorganic metal‐halide perovskite semiconductors could lead to nonepitaxial diode lasers that are tunable throughout the visible and near‐infrared spectrum; however, a viable laser diode architecture has not been demonstrated to date. Here, an important step toward this goal is achieved by demonstrating two distinct distributed feedback light‐emitting diode architectures that achieve low threshold, optically pumped lasing. Bottom‐ and top‐emitting perovskite light‐emitting diodes are fabricated on glass and Si substrates, respectively, using a polydimethylsiloxane stamp in the latter case to nanoimprint a second‐order distributed feedback grating directly into the methylammonium lead iodide active layer. The devices exhibit room temperature thresholds as low as ≈6 µJ cm−2, a peak external quantum efficiency of ≈0.1%, and a maximum current density of ≈2 A cm−2that is presently limited by degradation associated with excessive leakage current. In this low current regime, electrical injection does not adversely affect the optical pump threshold, leading to a projected threshold current density of ≈2 kA cm−2. Operation at low temperature can significantly decrease this threshold, but must overcome extrinsic carrier freeze‐out in the doped organic transport layers to maintain a reasonable drive voltage. 
    more » « less
  3. ; ; (, Scientific Reports)
    Abstract Colloidal quantum wells, or nanoplatelets, show among the lowest thresholds for amplified spontaneous emission and lasing among solution-cast materials and among the highest modal gains of any known materials. Using solution measurements of colloidal quantum wells, this work shows that under photoexcitation, optical gain increases with pump fluence before rolling off due to broad photoinduced absorption at energies lower than the band gap. Despite the common occurrence of gain induced by an electron–hole plasma found in bulk materials and epitaxial quantum wells, under no measurement conditions was the excitonic absorption of the colloidal quantum wells extinguished and gain arising from a plasma observed. Instead, like gain, excitonic absorption reaches a minimum intensity near a photoinduced carrier sheet density of 2 × 10 13  cm −2 above which the absorption peak begins to recover. To understand the origins of these saturation and reversal effects, measurements were performed with different excitation energies, which deposit differing amounts of excess energy above the band gap. Across many samples, it was consistently observed that less energetic excitation results in stronger excitonic bleaching and gain for a given carrier density. Transient and static optical measurements at elevated temperatures, as well as transient X-ray diffraction of the samples, suggest that the origin of gain saturation and reversal is a heating and disordering of the colloidal quantum wells which produces sub-gap photoinduced absorption. 
    more » « less
  4. ; ; ; ; ; ; (, Advanced Materials)
    Abstract A plasmonic nanolaser architecture that can produce white‐light emission is reported. A laser device is designed based on a mixed dye solution used as gain material sandwiched between two aluminum nanoparticle (NP) square lattices of different periodicities. The (±1, 0) and (±1, ±1) band‐edge surface lattice resonance (SLR) modes of one NP lattice and the (±1, 0) band‐edge mode of the other NP lattice function as nanocavity modes for red, blue, and green lasing respectively. From a single aluminum NP lattice, simultaneous red and blue lasing is realized from a binary dye solution, and the relative intensities of the two colors are controlled by the volume ratio of the dyes. Also, a laser device is constructed by sandwiching dye solutions between two Al NP lattices with different periodicities, which enables red–green and blue–green lasing. With a combination of three dyes as liquid gain, red, green, and blue lasing for a white‐light emission profile is realized. 
    more » « less
  5. ; ; ; ; ; ; (, Nature Communications)
    null (Ed.)
    Abstract Topological insulator lasers (TILs) are a recently introduced family of lasing arrays in which phase locking is achieved through synthetic gauge fields. These single frequency light source arrays operate in the spatially extended edge modes of topologically non-trivial optical lattices. Because of the inherent robustness of topological modes against perturbations and defects, such topological insulator lasers tend to demonstrate higher slope efficiencies as compared to their topologically trivial counterparts. So far, magnetic and non-magnetic optically pumped topological laser arrays as well as electrically pumped TILs that are operating at cryogenic temperatures have been demonstrated. Here we present the first room temperature and electrically pumped topological insulator laser. This laser array, using a structure that mimics the quantum spin Hall effect for photons, generates light at telecom wavelengths and exhibits single frequency emission. Our work is expected to lead to further developments in laser science and technology, while opening up new possibilities in topological photonics. 
    more » « less
  • Citation Formats
  • MLA
  • APA
  • Chicago
  • BibTeX
  • Save / Share this Record
  • Send to Email