An official website of the United States government
Semiconductor particle suspension reactors hold promise as a possible low-cost strategy for solar water-splitting, but they face several challenges that have inhibited their solar-to hydrogen (STH) efficiencies. A tandem microparticle with a buried junction addresses some of these challenges and offers a pathway to high STH efficiency. As a slurry, the tandem microparticles need to be suspended and well dispersed with maximum light absorption for a minimal photoactive particle concentration. Herein, proof-of-concept Ni/np+-Si/FTO/TiO2 tandem microwire structures capable of unassisted solar water-splitting were investigated as a slurry using uplifting N2 carrier gas bubbles. Transmittance, reflectance, and absorptance of the slurry were characterized as a function of wavelength, bubble flowrate, and tandem microwire concentration using an integrating sphere. Notably, a slurry absorptance of 70−85% was achieved with only 1% of the solution volume filled with a photoactive material. Photochemical activity of the slurry was characterized with in situ monitoring of the photodegradation of methylene blue, including the effects of particle concentration, bubble flowrate, spectral mismatch, intermixed light scattering particles, and a back reflector.
more »
« less
Minimizing Product Back Reactions with Inert Carrier Gas Bubbling for Photoelectrochemical Water Splitting with H 2 /O 2 Coevolution
Single-particle-type suspension reactors and other membrane-free reactor designs for photoelectrochemical (PEC) water splitting, although promising for low-cost H2 production, suffer the drawback of H2 and O2 co-evolution leading to product losses through back reactions. These back reactions need to be minimized to increase the solar-to-hydrogen (STH) efficiency. H2/O2 co-evolution also raises safety considerations, and a large-scale facility should maintain the H2 concentration below the lower flammability limit with O2 to eliminate explosion hazards. Herein, inert gas bubbling through the electrolyte was investigated with a tandem semiconductor for light-driven PEC water splitting without applied electrical bias as a technique to mitigate back reactions and maintain the output H2 safely below the lower flammability limit during co-evolution. A planar structure of nanoparticulate-Pt/Ni/np+-Si/FTO/TiO2 was fabricated into both wired-electrode and fully integrated configurations capable of unassisted solar water splitting, though additional UV bias increased the current density and gas production rates. The device was characterized in aqueous electrolyte from alkaline to neutral conditions to balance water-splitting activity and durability against corrosion, displaying strong stability in a pH 11 buffer solution. Moreover, the H2 faradaic efficiency was increased from 59% without bubbling to > 98% using inert carrier gas to increase the mass transfer of products to the gas phase. Integrated tandem photoelectrode performance indicated a tradeoff in bubbling flow rate between decreased back reactions and decreased light absorption due to bubble reflectance.
more »
« less
- Award ID(s):
- 1943977
- PAR ID:
- 10578871
- Publisher / Repository:
- American Chemical Society
- Date Published:
- Journal Name:
- Energy & Fuels
- Volume:
- 39
- Issue:
- 5
- ISSN:
- 0887-0624
- Page Range / eLocation ID:
- 2721 to 2731
- Subject(s) / Keyword(s):
- Electrolysis photoelectrochemical solar water-splitting back reactions co-evolution
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Solid oxide electrolysis cell (SOEC) is an attractive renewable technology capable of producing synthesis gas (H2+CO) from H2O and CO2. An SOEC consists of a solid oxide electrolyte and two ceramic or metal-ceramic electrodes. H2O and CO2 are electrolyzed at the cathode producing H2 and CO, releasing O2− ions, which travel through the electrolyte to the anode side and recombine to produce pure oxygen gas as the byproduct. In the present study, a La0.7Sr0.2Ni0.2Fe0.8O3 cathode was used to co-electrolyze H2O and CO2 at three different op- erating temperatures- 700 °C, 750 °C and 800 °C. Synthesis gas was produced at all three operating temperatures with 100 % Faradaic efficiency. The composition of the syngas, however, was found to be a function of the operating temperature. In general, the H2/CO ratio in the syngas decreased with increased temperature. This was partially due to CO2 electrolysis becoming more favorable compared to H2O electrolysis at higher temperatures.more » « less
-
Abstract Aqueous photoelectrochemical (PEC) cells have long been considered a promising technology to convert solar energy into hydrogen. However, the solar‐to‐H 2 (STH) efficiency and cost‐effectiveness of PEC water splitting are significantly limited by sluggish oxygen evolution reaction (OER) kinetics and the low economic value of the produced O 2 , hindering the practical commercialization of PEC cells. Recently, organic upgrading PEC reactions, especially for alternative OERs, have received tremendous attention, which improves not only the STH efficiency but also the economic effectiveness of the overall reaction. In this review, PEC reaction fundamentals and reactant‐product cost analysis of organic upgrading reactions are briefly reviewed, recent advances made in organic upgrading reactions, which are categorized by their reactant substrates, such as methanol, ethanol, glycol, glycerol, and complex hydrocarbons, are then summarized and discussed. Finally, the current status, further outlooks, and challenges toward industrial applications are discussed.more » « less
-
Amongst many strategies for renewable energy conversion, light-driven water splitting to produce clean H2 represents a promising approach and has attracted increasing attention in recent years. Owing to the multi-electron/multi-proton transfer nature of water splitting, low-cost and competent catalysts are needed. Along the rapid development of metal–organic frameworks (MOFs) during the last two decades or so, MOFs have been recognized as an interesting group of catalysts or catalyst supports for photocatalytic water splitting. The modular synthesis, intrinsically high surface area, tunable porosity, and diverse metal nodes and organic struts of MOFs render them excellent catalyst candidates for photocatalytic water splitting. To date, the application of MOFs and their derivatives as photocatalysts for water splitting has become a burgeoning field. Herein, we showcase several representative MOF-based photocatalytic systems for both H2 and O2 evolution reactions (HER, OER). The design principle of each catalytic system is specifically discussed. The current challenges and opportunities of utilizing MOFs for photocatalytic water splitting are discussed in the end.more » « less
-
Photoelectrochemical (PEC) water splitting is a promising technology for green hydrogen production by harnessing solar energy. Traditionally, this sustainable approach is studied under light intensity of 100 mW/cm2mimicking the natural solar irradiation at the Earth’s surface. Sunlight can be easily concentrated using simple optical systems like Fresnel lens to enhance charge carrier generation and hydrogen production in PEC water splitting. Despite the great potentials, this strategy has not been extensively studied and faces challenges related to the stability of photoelectrodes. To prompt the investigations and applications, this work outlines the best practices and protocols for conducting PEC solar water splitting under concentrated sunlight illumination, incorporating our recent advancements and providing some experimental guidelines. The key factors such as light source calibration, photoelectrode preparation, PEC cell configuration, and long-term stability test are discussed to ensure reproducible and high performance. Additionally, the challenges of the expected photothermal effect and the heat energy utilization strategy are discussed.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript
- Journal Article:
- https://doi.org/10.1021/acs.energyfuels.4c04603
