An official website of the United States government
Semiconductor particle suspension reactors hold promise as a possible low-cost strategy for solar water-splitting, but they face several challenges that have inhibited their solar-to hydrogen (STH) efficiencies. A tandem microparticle with a buried junction addresses some of these challenges and offers a pathway to high STH efficiency. As a slurry, the tandem microparticles need to be suspended and well dispersed with maximum light absorption for a minimal photoactive particle concentration. Herein, proof-of-concept Ni/np+-Si/FTO/TiO2 tandem microwire structures capable of unassisted solar water-splitting were investigated as a slurry using uplifting N2 carrier gas bubbles. Transmittance, reflectance, and absorptance of the slurry were characterized as a function of wavelength, bubble flowrate, and tandem microwire concentration using an integrating sphere. Notably, a slurry absorptance of 70−85% was achieved with only 1% of the solution volume filled with a photoactive material. Photochemical activity of the slurry was characterized with in situ monitoring of the photodegradation of methylene blue, including the effects of particle concentration, bubble flowrate, spectral mismatch, intermixed light scattering particles, and a back reflector.
more »
« less
This content will become publicly available on February 6, 2026
Minimizing Product Back Reactions with Inert Carrier Gas Bubbling for Photoelectrochemical Water Splitting with H 2 /O 2 Coevolution
Single-particle-type suspension reactors and other membrane-free reactor designs for photoelectrochemical (PEC) water splitting, although promising for low-cost H2 production, suffer the drawback of H2 and O2 co-evolution leading to product losses through back reactions. These back reactions need to be minimized to increase the solar-to-hydrogen (STH) efficiency. H2/O2 co-evolution also raises safety considerations, and a large-scale facility should maintain the H2 concentration below the lower flammability limit with O2 to eliminate explosion hazards. Herein, inert gas bubbling through the electrolyte was investigated with a tandem semiconductor for light-driven PEC water splitting without applied electrical bias as a technique to mitigate back reactions and maintain the output H2 safely below the lower flammability limit during co-evolution. A planar structure of nanoparticulate-Pt/Ni/np+-Si/FTO/TiO2 was fabricated into both wired-electrode and fully integrated configurations capable of unassisted solar water splitting, though additional UV bias increased the current density and gas production rates. The device was characterized in aqueous electrolyte from alkaline to neutral conditions to balance water-splitting activity and durability against corrosion, displaying strong stability in a pH 11 buffer solution. Moreover, the H2 faradaic efficiency was increased from 59% without bubbling to > 98% using inert carrier gas to increase the mass transfer of products to the gas phase. Integrated tandem photoelectrode performance indicated a tradeoff in bubbling flow rate between decreased back reactions and decreased light absorption due to bubble reflectance.
more »
« less
- Award ID(s):
- 1943977
- PAR ID:
- 10578871
- Publisher / Repository:
- American Chemical Society
- Date Published:
- Journal Name:
- Energy & Fuels
- Volume:
- 39
- Issue:
- 5
- ISSN:
- 0887-0624
- Page Range / eLocation ID:
- 2721 to 2731
- Subject(s) / Keyword(s):
- Electrolysis photoelectrochemical solar water-splitting back reactions co-evolution
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Aqueous photoelectrochemical (PEC) cells have long been considered a promising technology to convert solar energy into hydrogen. However, the solar‐to‐H 2 (STH) efficiency and cost‐effectiveness of PEC water splitting are significantly limited by sluggish oxygen evolution reaction (OER) kinetics and the low economic value of the produced O 2 , hindering the practical commercialization of PEC cells. Recently, organic upgrading PEC reactions, especially for alternative OERs, have received tremendous attention, which improves not only the STH efficiency but also the economic effectiveness of the overall reaction. In this review, PEC reaction fundamentals and reactant‐product cost analysis of organic upgrading reactions are briefly reviewed, recent advances made in organic upgrading reactions, which are categorized by their reactant substrates, such as methanol, ethanol, glycol, glycerol, and complex hydrocarbons, are then summarized and discussed. Finally, the current status, further outlooks, and challenges toward industrial applications are discussed.more » « less
-
Photoelectrochemical (PEC) hydrogen generation is a promising solar energy harvesting technique to address the concerns about the ongoing energy crisis. Antimony selenide (Sb2Se3) with van der Waals‐bonded quasi‐1D (Q1D) nanoribbons, for instance, (Sb4Se6)n, has attracted considerable interest as a light absorber with Earth‐abundant elements, suitable bandgap, and a desired sunlight absorption coefficient. By tuning its anisotropic growth behavior, it is possible to achieve Sb2Se3films with nanostructured morphologies that can improve the light absorption and photogenerated charge carrier separation, eventually boosting the PEC water‐splitting performance. Herein, high‐quality Sb2Se3films with nanorod (NR) array surface morphologies are synthesized by a low‐cost, high‐yield, and scalable close‐spaced sublimation technique. By sputtering a nonprecious and scalable crystalline molybdenum sulfide (MoS2) film as a cocatalyst and a protective layer on Sb2Se3NR arrays, the fabricated core–shell structured MoS2/Sb2Se3NR PEC devices can achieve a photocurrent density as high as −10 mA cm−2at 0 VRHEin a buffered near‐neutral solution (pH 6.5) under a standard simulated air mass 1.5 solar illumination. The scalable manufacturing of nanostructured MoS2/Sb2Se3NR array thin‐film photocathode electrodes for efficient PEC water splitting to generate solar fuel is demonstrated.more » « less
-
Amongst many strategies for renewable energy conversion, light-driven water splitting to produce clean H2 represents a promising approach and has attracted increasing attention in recent years. Owing to the multi-electron/multi-proton transfer nature of water splitting, low-cost and competent catalysts are needed. Along the rapid development of metal–organic frameworks (MOFs) during the last two decades or so, MOFs have been recognized as an interesting group of catalysts or catalyst supports for photocatalytic water splitting. The modular synthesis, intrinsically high surface area, tunable porosity, and diverse metal nodes and organic struts of MOFs render them excellent catalyst candidates for photocatalytic water splitting. To date, the application of MOFs and their derivatives as photocatalysts for water splitting has become a burgeoning field. Herein, we showcase several representative MOF-based photocatalytic systems for both H2 and O2 evolution reactions (HER, OER). The design principle of each catalytic system is specifically discussed. The current challenges and opportunities of utilizing MOFs for photocatalytic water splitting are discussed in the end.more » « less
-
Abstract Slurries of semiconductor particles individually capable of unassisted light‐driven water‐splitting are modeled to have a promising path to low‐cost solar hydrogen generation, but they have had poor efficiencies. Tandem microparticle systems are a clear direction to pursue to increase efficiency. However, light absorption must be carefully managed in a tandem to prevent current mismatch in the subcells, which presents a possible challenge for tandem microwire particles suspended in a liquid. In this work, a Ni‐catalyzed Si/TiO2tandem microwire slurry is used as a stand‐in for an ideal bandgap combination to demonstrate proof‐of‐concept in situ alignment of unassisted water‐splitting microwires with an external magnetic field. The Ni hydrogen evolution catalyst is selectively photodeposited at the exposed Si microwire core to serve as the cathode site as well as a handle for magnetic orientation. The frequency distribution of the suspended microwire orientation angles is determined as a function of magnetic field strength under dispersion with and without uplifting microbubbles. After magnetizing the Ni bulb, tandem microwires can be highly aligned in water under a magnetic field despite active dispersion from bubbling or convection.more » « less
