An official website of the United States government
This study characterized and evaluated the use of reclaimed fly ash (RFA) and reclaimed ground bottom ash (GBA) as alternative sources of supplementary cementitious materials (SCMs) for the production of concrete mixtures. Conventional Class F fly ash (FA) was also evaluated for comparison. The effects of SCM content on fresh and hardened properties of concrete were investigated by replacing 10%, 20%, and 30% of cement by mass. Characterization results showed that all three ashes met ASTM C618 chemical requirements (i.e., sum of SiO 2 + Al 2 O 3 + Fe 2 O 3 , CaO, SO 3 , moisture content, and loss of ignition) and 7- and 28-days strength activity index (SAI) requirements for Class F FA. In addition, RFA exhibited slightly higher SAI at 28 days of curing, followed by GBA and FA. In relation to fresh concrete properties, FA increased the concrete slump compared with the control mixture, whereas RFA and GBA decreased the concrete slump. However, GBA produced more significant slump decrements than RFA, which was attributed to the irregular angular particles of GBA. Generally, all the coal ashes produced decrements in air content compared with the control mixture. Comparatively, among the three ashes, GBA exhibited the highest 28- and 90-days compressive strength and surface resistivity (SR) at all cement replacement levels. Furthermore, at 90 days of curing, RFA and GBA concrete mixtures outperformed the FA concrete mixtures in relation to compressive strength and SR. Consequently, both RFA and GBA are promising SCMs for concrete materials.
more »
« less
This content will become publicly available on December 1, 2025
Incorporating Limestone Powder and Ground Granulated Blast Furnace Slag in Ultra-high Performance Concrete to Enhance Sustainability
Abstract While ultra-high performance concrete (UHPC) offers numerous advantages, it also presents specific challenges, primarily due to its high cost and excessive cement content, which can pose sustainability concerns. To address this challenge, this study aims to develop cost-effective and sustainable UHPC mixtures by incorporating ground granulated blast furnace slag (GGBFS) and limestone powder (LP) as partial replacements for portland cement. Eight fiber-reinforced UHPC mixtures were investigated, with a water-to-cementitious materials (w/cm) ratio of 0.15. In four of the UHPC mixtures, 25% of the cement was replaced with GGBFS, and further, LP was added as a mineral filler, partially substituting up to 20% of the cement. In the remaining four mixtures, cement was replaced with only LP up to 20% (without GGBFS). The 28-day compressive strength of the UHPC mixture with 25% GGBFS and 20% LP was 149 MPa, 3.50% lower than the mixture without GGBFS. Its 28-day flexural strength decreased by 30%. Increasing LP replacement reduced drying and autogenous shrinkage, with a 29% shrinkage reduction at 20% LP replacement. Moreover, UHPC mixtures with GGBFS exhibited lower shrinkage compared to those without GGBFS for all LP replacements up to 20%. For evaluating the sustainability of UHPC mixtures, the cement composition index (CCI) and clinker to cement ratio (CCR) were determined. For 20% LP replacement with 25% GGBFS, CCI was 3.6 and the CCR was 0.5, 38% decrease from the global clinker to cement ratio. Overall, 20% LP replacement UHPC mixtures with and without GGBFS can produce UHPC class performance and reduce the environmental impact.
more »
« less
- Award ID(s):
- 2223980
- PAR ID:
- 10587233
- Publisher / Repository:
- Springer Open
- Date Published:
- Journal Name:
- International Journal of Concrete Structures and Materials
- Volume:
- 18
- Issue:
- 1
- ISSN:
- 2234-1315
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Researchers have made headway against challenges of increasing cement infrastructure and low plastic recycling rates by using waste plastic in cementitious materials. Past studies indicate that microbially induced calcium carbonate precipitation (MICP) to coat plastic in calcium carbonate may improve the strength. The objective of this study was to increase the amount of clean and contaminated waste plastic that can be added to mortar and to assess whether MICP treatment enhances the strength. The performance of plastic-filled mortar was investigated at 5%, 10%, and 20% volume replacement for cement. Untreated, clean plastics at a 20% cement replacement produced compressive strengths acceptable for several applications. However, a coating of MICP on clean waste plastic did not improve the strengths. At 10% replacement, both MICP treatment and washing of contaminated plastics recovered compressive strengths by approximately 28%, relative to mortar containing oil-coated plastics. By incorporating greater volumes of waste plastics into mortar, the sustainability of cementitious composites has the potential of being improved by the dual mechanisms of reduced cement production and repurposing plastic waste.more » « less
-
To promote the sustainable development of eco-efficient calcium sulfoaluminate (CSA) cements through the partial replacement of the CSA clinker with supplementary cementitious waste products, the effects of coal fly ashes on the early-age and mature-age properties of a calcium sulfoaluminate (CSA)-based cement paste were investigated. The impacts of both Class C and Class F fly ashes on the rheological properties, hydration kinetics, and compressive strength development of CSA cement paste were studied. Rheology-based workability parameters, representing the rate of loss of flowability, the rate of hardening, and the placement limit, were characterized for the pastes prepared with fixed water-to-cement (w/c) and fixed water-to-binder (w/b) ratios. The results indicate a slight improvement in the workability of the CSA paste by fly ash addition at a fixed w/b ratio. The isothermal calorimetry studies show a higher heat of hydration for the Class C fly ash-modified systems compared to the Class F-modified systems. The results show that fly ash accelerates the hydration of the calcium sulfoaluminate cement pastes, chiefly due to the filler effects, rather than the pozzolanic effects. In general, ettringite is stabilized more by the addition of Class F fly ash than Class C fly ash. Both fly ashes reduced the 1-day compressive strength, but increased the 28-day strength of the CSA cement paste; meanwhile, the Class C modified pastes show a higher strength than Class F, which is attributed to the higher degree of reaction and potentially more cohesive binding C-S-H-based gels formed in the Class C fly ash modified systems. The results provide insights that support that fly ash can be employed to improve the performance of calcium sulfoaluminate cement pastes, while also enhancing cost effectiveness and sustainability.more » « less
-
Amziane, S; Merta, I; Page, J. (Ed.)Portland cement is one of the most used materials on earth. Its annual production is responsible for approximately 7% of global carbon dioxide (CO2) emissions. These emissions are primarily associated with (1) the burning of fossil fuels to heat cement kilns and (2) the release of CO2 during limestone calcination. One proposed strategy for CO2 reduction includes the use of functional limestone fillers, which reduce the amount of portland cement in concrete without compromising strength. This study investigated the effect of using renewable, CO2-storing, biogenic CaCO3 produced by E. huxleyi as limestone filler in portland limestone cements (PLCs). Biogenic CaCO3 was used to synthesize PLCs with 0, 5, 15, and 35% limestone replacement of portland cement. The results substantiate that the particle sizes of the biogenic CaCO3 were significantly smaller and the surface areas significantly larger than that of reagent grade CaCO3. X-ray diffraction indicated no differences in mineralogy between reagent-grade and biogenic CaCO3. The use of biogenic CaCO3 as a limestone filler led to (i) increased water demand at the higher replacements, which was countered by using a superplasticizer, and (ii) enhanced nucleation during cement hydration, as measured by isothermal conduction calorimetry. The 7-day compressive strengths of the PLC pastes were measured using mechanical testing. Enhanced nucleation effects were observed for PLC samples containing biogenic CaCO3. 7-day compressive strength of the PLCs produced using biogenic CaCO3 were also enhanced compared to PLCs produced using reagent-grade CaCO3 due to the nucleation effect. This study illustrates an opportunity for using CO2-storing, biogenic CaCO3 to enhance mechanical properties and CO2 storage in PLCs containing biologically architected CaCO3.more » « less
-
Nitrogen and phosphorus contained in stormwater runoff contaminate both surface and groundwaters, causing problems for natural aquatic systems and human health. Pervious concrete specifically designed for pollutant removal, otherwise known as permeable reactive concrete (PRC), may be used as a novel component of existing infrastructure to remove nutrients from runoff. This research compares the removal and retention of dissolved, inorganic nitrate-nitrogen (NO3-N) and orthophosphate-phosphorus (PO4-P) for three PRC mixtures. The control PRC was ordinary portland cement (OPC) and was compared against other mixtures containing 25% replacement with Class C fly ash or with drinking water treatment residual waste (DWTR). Concrete specimens were jar-tested for 72 h in three different concentrations of nitrate or phosphate. The control mixture removed 60% of NO3-N and more than 80% PO4-P, and the fly ash mixture removed up to 39% of NO3-N and more than 91% PO4-P. The DWTR mixture leached NO3-N while removing more than 80% PO4-P. Linear isotherms were determined for the range of nutrient concentrations tested. Column leach tests were conducted on specimens after initial jar testing and used as an indication of removal permanence. Inorganic removal mechanisms were investigated, including crystallographic substitution, adsorption, and physical solute filtering in cement pore space. Results indicate PRC can be one of the leading methods to remove nitrate from surface waters and is as efficient as other methods for orthophosphate removal.more » « less
