An official website of the United States government
Recent field studies provide evidence of fault slip-rate variability over time periods of 10–100 k.y., yet researchers do not know how processes internal to the fault system (e.g., fault reorganization) impact records of fault slip rates. In this study, we directly observed fault-system evolution and measured slip-rate histories within a scaled physical experiment of a dextral strike-slip 15° restraining bend representative of a gentle crustal restraining bend. To assess the degree of slip-rate variability at particular sites along the experimental faults, such as would be revealed in a field study, we tracked fault slip rates at specific locations that advected throughout the experiment with accrued fault slip. Slip rates increased or decreased (5%–25% of the applied velocity) both during fault reorganization (e.g., fault growth and abandonment) and as sites migrated to new structural positions. Sites that advected into the restraining bend showed decreased slip rate. While we expect new fault growth to reduce slip rates along nearby fault segments, we document that the growth of new oblique-slip faults can increase strike-slip rates on nearby fault segments. New oblique-slip thrust faults within the experiment accommodated off-fault convergence and unclamped nearby strike-slip segments. The experimental results show that even under a constant loading rate, slip rates at sites located on stable fault segments can vary due to either reorganization elsewhere in the fault system or site advection.
more »
« less
This content will become publicly available on January 1, 2026
Impact of Material Strength on Releasing Bend Evolution [Earth, Geographic and Climate Sciences, University of Massachusetts Amherst, USA]
Releasing bends along active strike-slip faults display a range of fault patterns that may depend on crustal strength. Scaled physical experiments allow us to directly document the evolution of established releasing bend systems under differing strength conditions. Here, we use a split-box apparatus filled with wet clay of differing strengths to run and analyze releasing bend evolution. Precut vertical discontinuities within the clay slip with right-lateral displacement of the basal plate followed by the development of oblique-slip secondary faults. In contrast to the weaker clay experiment, which produces left-lateral cross faults that facilitate major reorganization of the primary slip pathway, the stronger clay experiment produces negligible cross faults and has a persistent primary slip pathway. Within both experiments, the dip of initially vertical faults shallows due to lateral flow at depth and left-lateral slip develops along normal fault segments that have highly oblique strike. The experiments show that fault systems within weaker strength materials produce greater delocalization of faulting, with both greater number of faults and greater off-fault deformation that can impact hazard. For example, the hot, thin and weak crust hosting the Brawley Seismic Zone accommodates slip along many distributed faults, which is in sharp contrast to the more localized fault network of the Southern Gar Basin in cooler, thicker and stronger crust. The fault patterns observed in the experiments match patterns of crustal examples and may guide future models of fault evolution within relatively strong and weak crust that have differing heat flux and thickness.
more »
« less
- Award ID(s):
- 2040570
- PAR ID:
- 10608810
- Publisher / Repository:
- Tektonika
- Date Published:
- Journal Name:
- Tektonika
- Volume:
- 3
- ISSN:
- 2976-548X
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Topography along strike‐slip fault restraining bends is theoretically self‐limited by erosion, block translation and the expected abandonment of fault bends. However, Denali (6,194 m) and Foraker (5,304 m) are located within a restraining bend of the dextral Denali Fault system. We reveal the role of bend evolution in mountain building with physical experiments scaled to simulate the Alaska Mount McKinley restraining bend (MMRB). Despite the natural complexity of the MMRB, first‐order patterns (of strike‐slip separation rates, uplift and lateral bend migration) from the geologic data align with patterns from scaled experiments. Thermochronology, seismicity, and slip rate data show that the persistence of a single Denali Fault strand through the ~6 Ma MMRB is facilitated by simultaneous advection of crust through the bend and migration of the eastern vertex of the bend.more » « less
-
The data set includes the Digital Image Correlation (DIC) results for four experiments of releasing bends along dextral strike-slip faults that were performed at the University of Massachusetts at Amherst (USA). Gabriel et al. (in prep.) used the DIC data sets to investigate how releasing bend fault systems evolve within different strength wet kaolin. Information on the experimental set up and methods can be found in the main text and supplement to Gabriel et al. (in prep.). The data here include the incremental displacement time series, strain animation and surface elevation data at the end of the two experiments with different clay strength, which are presented within Gabriel et al. (in prep). We also include in this data repository incremental displacement time series and strain animations from two experiments that repeat the conditions of the experiments featured in Gabriel et al. (2025).more » « less
-
Abstract The factors that control strain partitioning along plate boundaries and within continental interiors remains poorly resolved. Plate convergence may be accommodated via distributed crustal shortening or discrete crustal‐scale strike‐slip faulting, but what controls these differing modes of deformation is debated. Here we address this question by examining the actively deforming regions that surround the Tarim Basin in central Asia, where deformation is uniquely partitioned into predominately strike‐slip faults in the east and distributed fold‐thrust belts in the west to accommodate Cenozoic India‐Asia plate convergence. We present integrated geological and geophysical observations to elucidate patterns in crustal deformation and compositional structure in and around the Tarim Basin. The thrust‐dominated western Tarim Basin correlates with a strongly‐magnetic lower crust, whereas strike‐slip faulting along the eastern margins of the Tarim Basin lack such magnetic signals. We suggest that the lower crust of the western Tarim is more mafic and stronger than in the east, which impacts intra‐plate strain partitioning. A stronger lower crust results in vertical decoupling to drive mid‐crust horizontal detachments and facilitate thrust faulting, whereas a more homogenized crust favored vertical transcrustal strike‐slip faulting. These rheological differences likely originated from the impingement of the Permian Tarim plume focused in the west. A comparison with the Longmen Shan of eastern Tibetan Plateau reveals remarkably similar strain partitioning that correlates with variations in foreland rheology. Our results highlight how variations in lower‐crust viscosity impact strain partitioning in an intra‐plate setting and how plume processes exert a strong control on later continental tectonic processes.more » « less
-
null (Ed.)Existing models of intracontinental deformation have focused on plate-like rigid body motion v. viscous-flow-like distributed deformation. To elucidate how plate convergence is accommodated by intracontinental strike-slip faulting and block rotation within a fold–thrust belt, we examine the Cenozoic structural framework of the central Qilian Shan of northeastern Tibet, where the NW-striking, right-slip Elashan and Riyueshan faults terminate at the WNW-striking, left-slip Haiyuan and Kunlun faults. Field- and satellite-based observations of discrete right-slip fault segments, releasing bends, horsetail termination splays and off-fault normal faulting suggest that the right-slip faults accommodate block rotation and distributed west–east crustal stretching between the Haiyuan and Kunlun faults. Luminescence dating of offset terrace risers along the Riyueshan fault yields a Quaternary slip rate of c. 1.1 mm a −1 , which is similar to previous estimates. By integrating our results with regional deformation constraints, we propose that the pattern of Cenozoic deformation in northeastern Tibet is compatible with west–east crustal stretching/lateral displacement, non-rigid off-fault deformation and broad clockwise rotation and bookshelf faulting, which together accommodate NE–SW India–Asia convergence. In this model, the faults represent strain localization that approximates continuum deformation during regional clockwise lithospheric flow against the rigid Eurasian continent. Supplementary material: Luminescence dating procedures and protocols is available at https://doi.org/10.17605/OSF.IO/CR9MN Thematic collection: This article is part of the Fold-and-thrust belts and associated basins collection available at: https://www.lyellcollection.org/cc/fold-and-thrust-beltsmore » « less
