An official website of the United States government
Abstract While observations of many high-precision radio pulsars of order ≲1 μ s across the sky are needed for the detection and characterization of a stochastic background of low-frequency gravitational waves (GWs), sensitivity to single sources of GWs requires even higher timing precision. The Argentine Institute of Radio Astronomy (IAR; Instituto Argentino de Radioastronomía) has begun observations of the brightest known millisecond pulsar, J0437−4715. Even though the two antennas are smaller than other single-dish telescopes previously used for pulsar timing array (PTA) science, the IAR’s capability to monitor this pulsar daily, coupled with the pulsar’s brightness, allows for high-precision measurements of pulse-arrival time. While upgrades of the facility are currently underway, we show that modest improvements beyond current plans will provide IAR with unparalleled sensitivity to this pulsar. The most stringent upper limits on single GW sources come from the North American Nanohertz Observatory for Gravitational Waves (NANOGrav). Observations of PSR J0437−4715 will provide a significant sensitivity increase in NANOGrav’s “blind spot” in the sky where fewer pulsars are currently being observed. With state-of-the-art instrumentation installed, we estimate the array’s sensitivity will improve by a factor of ≈2–4 over 10 yr for 20% of the sky with the inclusion of this pulsar, as compared to a static version of the PTA used in NANOGrav’s most recent limits. More modest instrumentation results in factors of ≈1.4–3. We identify four other candidate pulsars as suitable for inclusion in PTA efforts. International PTA efforts will also benefit from inclusion of these data, given the potential achievable sensitivity.
more »
« less
The SKAO Pulsar Timing Array
Pulsar timing arrays (PTAs) are ensembles of millisecond pulsars observed for years to decades. The primary goal of PTAs is to study gravitational-wave astronomy at nanohertz frequencies, with secondary goals of undertaking other fundamental tests of physics and astronomy. Recently, compelling evidence has emerged in established PTA experiments for the presence of a gravitational-wave background. To accelerate a confident detection of such a signal and then study gravitational-wave emitting sources, it is necessary to observe a larger number of millisecond pulsars to greater timing precision. The SKA telescopes, which will be a factor of three to four greater in sensitivity compared to any other southern hemisphere facility, is poised to make such an impact. In this chapter, we motivate an SKAO pulsar timing array (SKAO PTA) experiment. We discuss the classes of gravitational waves present in PTA observations and how an SKAO PTA can detect and study them. We then describe the sources that can produce these signals. We discuss the astrophysical noise sources that must be mitigated to undertake the most sensitive searches. We then describe a realistic PTA experiment implemented with the SKA and place it in context alongside other PTA experiments likely ongoing in the 2030s. We describe the techniques necessary to search for gravitational waves in the SKAO PTA and motivate how very long baseline interferometry can improve the sensitivity of an SKAO PTA. The SKAO PTA will provide a view of the Universe complementary to those of the other large facilities of the 2030s.
more »
« less
- Award ID(s):
- 2414468
- PAR ID:
- 10656397
- Author(s) / Creator(s):
- ; ; ; ; ; ; ; ; ; ; ; ; ; ; ; ; ; ; ; more »
- Publisher / Repository:
- The Open Journal of Astrophysics,
- Date Published:
- Journal Name:
- The Open Journal of Astrophysics
- Volume:
- 8 Supplement
- Issue:
- 1
- ISSN:
- 2565-6120
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract As pulsar timing arrays (PTAs) transition into the detection era of the stochastic gravitational wave background (GWB), it is important for PTA collaborations to review and possibly revise their observing campaigns. The detection of a “single source” would be a boon for gravitational astrophysics, as such a source would emit gravitational waves for millions of years in the PTA frequency band. Here we present generic methods for studying the effects of various observational strategies, taking advantage of detector sensitivity curves, i.e., noise-averaged, frequency-domain detection statistics. The statistical basis for these methods is presented along with myriad examples of how to tune a detector towards single, deterministic signals or a stochastic background. We demonstrate that trading observations of the worst pulsars for high cadence campaigns on the best pulsars increases sensitivity to single sources at high frequencies while hedging losses in GWB and single source sensitivity at low frequencies. We also find that sky-targeted observing campaigns yield minimal sensitivity improvements compared with other PTA tuning options. Lastly, we show the importance of the uncorrelated half of the GWB, i.e. the pulsar-term, as an increasingly prominent sources of noise and show the impact of this emerging noise source on various PTA configurations.more » « less
-
Abstract Pulsar timing arrays (PTAs) are Galactic-scale gravitational wave (GW) detectors consisting of precisely timed pulsars distributed across the sky. Within the decade, PTAs are expected to detect nanohertz GWs emitted by close-separation supermassive black hole binaries (SMBHBs), thereby opening up the low-frequency end of the GW spectrum for science. Individual SMBHBs which power active galactic nuclei are also promising multi-messenger sources; they may be identified via theoretically predicted electromagnetic (EM) signatures and be followed up by PTAs for GW observations. In this work, we study the detection and parameter estimation prospects of a PTA which targets EM-selected SMBHBs. Adopting a simulated Galactic millisecond pulsar population, we envisage three different pulsar timing campaigns which observe three mock sources at different sky locations. We find that an all-sky PTA which times the best pulsars is an optimal and feasible approach to observe EM-selected SMBHBs and measure their source parameters to high precision (i.e., comparable to or better than conventional EM measurements). We discuss the implications of our findings in the context of future PTA experiments with the planned Deep Synoptic Array-2000 and the multi-messenger studies of SMBHBs such as the well-known binary candidate OJ 287.more » « less
-
Abstract Pulsar timing arrays (PTAs) are sensitive to low-frequency gravitational waves (GWs), which induce correlated changes in millisecond pulsars’ timing residuals. PTA collaborations around the world have recently announced evidence of a nanohertz gravitational wave background (GWB), which may be produced by a population of supermassive black hole binaries (SMBHBs). The GWB is often modeled as following a power-law power spectral density (PSD); however, a GWB produced by a cosmological population of SMBHBs is expected to have a more complex power spectrum due to the discrete nature of the sources. In this paper, we investigate using at-process PSD to model the GWB, which allows us to fit for both the underlying power-law amplitude and spectral index as well as deviations from that power law, which may be produced by individual nearby binaries. We create simulated data sets based on the properties of the NANOGrav 15 yr data set, and we demonstrate that thet-process PSD can accurately recover the PSD when deviations from a power law are present. With longer timed data sets and more pulsars, we expect the sensitivity of our PTAs to improve, which will allow us to precisely measure the PSD of the GWB and study the sources producing it.more » « less
-
ABSTRACT Pulsar timing arrays (PTAs) are searching for gravitational waves from supermassive black hole binaries (SMBHBs). Here we show how future PTAs could use a detection of gravitational waves from individually resolved SMBHB sources to produce a purely gravitational wave-based measurement of the Hubble constant. This is achieved by measuring two separate distances to the same source from the gravitational wave signal in the timing residual: the luminosity distance DL through frequency evolution effects, and the parallax distance Dpar through wavefront curvature (Fresnel) effects. We present a generalized timing residual model including these effects in an expanding universe. Of these two distances, Dpar is challenging to measure due to the pulsar distance wrapping problem, a degeneracy in the Earth-pulsar distance and gravitational wave source parameters that requires highly precise, sub-parsec level, pulsar distance measurements to overcome. However, in this paper we demonstrate that combining the knowledge of two SMBHB sources in the timing residual largely removes the wrapping cycle degeneracy. Two sources simultaneously calibrate the PTA by identifying the distances to the pulsars, which is useful in its own right, and allow recovery of the source luminosity and parallax distances which results in a measurement of the Hubble constant. We find that, with optimistic PTAs in the era of the Square Kilometre Array, two fortuitous SMBHB sources within a few hundred Mpc could be used to measure the Hubble constant with a relative uncertainty on the order of 10 per cent.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.33232/001c.154243
