Search for: All records

Dilute Mg alloys based upon earth-abundant elements, e.g., Al, Ca, and Zn have attractive combinations of strength, ductility, and workability. Even higher strength can be obtained in work-hardened material without the heat treatments required to induce Guinier-Preston zone strengthening of previously studied versions of these alloys. This stems from a slightly stronger crystallographic texture than is present after solutionizing, a high dislocation density, and to a lesser degree, a fine distribution of globular Zn-rich precipitates. The anisotropic plastic response of sheet material is described using an elasto-viscoplastic self-consistent (EVPSC) polycrystal model. Strain partitioning between grains during rolling-induced strain hardening is held responsible for the yield strength, ductility, and especially, strain hardening anisotropy. Texture-induced plastic anisotropy is well- known, but the effect of strong partitioning of strain between variously oriented grains is critical to explain what may be classified as a sort of strain path change (generalized Bauschinger) effect. 

Tensile samples of an Mg alloy ZK10 sheet were tested at a range of temperatures and strain rates designed to rather evenly probe a range of Zener Hollomon parameter values, from ln(Z) ≈ 15 (10–4 s−1 and 623 K) up to ln(Z) ≈ 50 (10–3 s−1 and 300 K). In contrast with more commonly examined Mg alloy AZ31B sheet material, ZK10 sheet material shows modest strain anisotropy (r-value) at low temperatures for both 45° (r45 ≈ 1.2) and TD (rTD ≈ 1.4) sample orientations, despite showing evidence of significant prismatic slip of dislocations, which often leads to high r-values at low temperatures. These low r-values become even lower (r45 ≈ 0.84 and rTD ≈ 0.89) at high temperatures. These behaviors are hypothesized to occur due to a distinct initial texture and deformation mechanism activity, which includes a modest level of tensile twinning and  slip at both room and elevated temperature. A version of the viscoplastic self-consistent (VPSC) code, which accounts for the kinematics of dislocation climb, is used to simulate the behavior of a textured Mg alloy ZK10 sheet reveals that both the glide of pyramidal  dislocations and the climb of basal < a > dislocations are required to describe the behavior at elevated temperatures. 

Textured Mg alloy sheet samples were tensile tested parallel to the transverse direction, at Zener–Hollomon parameter values ranging from Z ~ 50 at room temperature and 10−3 s−1 down to Z ~ 18 at 350 °C and 10−5 s−1. At high Z, the samples exhibit strong texture evolution indicative of significant prismatic slip of dislocations with  Burgers vectors. Correspondingly, the plastic anisotropy is high, r ~ 4. At low Z, the texture evolution is minimal and the response is nearly isotropic, r ~ 1. Previously, it has been asserted that the high ductility and low plastic anisotropy observed at low Z conditions is due to enhanced activity of non-basal slip modes, including prismatic slip of  dislocations and pyramidal slip of  and  dislocations. The present results call this understanding into question and suggest that the enhanced ductility is more closely associated with the climb of  dislocations.