An official website of the United States government
Leaf hydraulic networks play an important role not only in fluid transport but also in maintaining whole-plant water status through transient environmental changes in soil-based water supply or air humidity. Both water potential and hydraulic resistance vary spatially throughout the leaf transport network, consisting of xylem, stomata and water-storage cells, and portions of the leaf areas far from the leaf base can be disproportionately disadvantaged under water stress. Besides the suppression of transpiration and reduction of water loss caused by stomatal closure, the leaf capacitance of water storage, which can also vary locally, is thought to be crucial for the maintenance of leaf water status. In order to study the fluid dynamics in these networks, we develop a spatially explicit, capacitive model which is able to capture the local spatiotemporal changes of water potential and flow rate in monocotyledonous and dicotyledonous leaves. In electrical-circuit analogs described by Ohm's law, we implement linear capacitors imitating water storage, and we present both analytical calculations of a uniform one-dimensional model and numerical simulation methods for general spatially explicit network models, and their relation to conventional lumped-element models. Calculation and simulation results are shown for the uniform model, which mimics key properties of a monocotyledonous grass leaf. We illustrate water status of a well-watered leaf, and the lowering of water potential and transpiration rate caused by excised water source or reduced air humidity. We show that the time scales of these changes under water stress are hugely affected by leaf capacitance and resistances to capacitors, in addition to stomatal resistance. Through this modeling of a grass leaf, we confirm the presence of uneven water distribution over leaf area, and also discuss the importance of considering the spatial variation of leaf hydraulic traits in plant biology.
more »
« less
Enhanced Water Evaporation with Floating Synthetic Leaves
The evaporation of water exposed to a subsaturated environment is relevant for a variety of water harvesting and energy harvesting applications. Here, we show that the diffusive evaporation rate of water can be greatly modulated by floating a nanoporous synthetic leaf at the water’s free interface. The floating leaf was able to evaporate at least as much water as a free interface under equivalent conditions, which is remarkable considering that only about a third of the leaf’s interface is open to the ambient.We attribute the enhanced evaporation of the water menisci to their sharp curvature and three-dimensional surface area. At low humidities the water menisci cannot achieve a local equilibrium, due to the mismatch in water activity across the interface outcompeting the negative Laplace pressure. As a result, the mensici retreat partway into the leaf, which increases the local humidity directly above the menisci until equilibrium is reached. Using a ceramic disk with pore diameters of 160 nm, we find the surprising result that leaves exposed to an ambient relative humidity of 95% can evaporate water at the same rate as leaves exposed to only 50% humidity, due to the long and tortuous vapor pathway in the latter case.
more »
« less
- Award ID(s):
- 1653631
- PAR ID:
- 10088130
- Date Published:
- Journal Name:
- International Heat Transfer Conference
- Volume:
- IHTC16
- ISSN:
- 2377-424X
- Page Range / eLocation ID:
- 23736
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Air humidity is a vast, sustainable reservoir of energy that, unlike solar and wind, is continuously available. However, previously described technologies for harvesting energy from air humidity are either not continuous or require unique material synthesis or processing, which has stymied scalability and broad deployment. Here, a generic effect for continuous energy harvesting from air humidity is reported, which can be applied to a broad range of inorganic, organic, and biological materials. The common feature of these materials is that they are engineered with appropriate nanopores to allow air water to pass through and undergo dynamic adsorption–desorption exchange at the porous interface, resulting in surface charging. The top exposed interface experiences this dynamic interaction more than the bottom sealed interface in a thin‐film device structure, yielding a spontaneous and sustained charging gradient for continuous electric output. Analyses of material properties and electric outputs lead to a “leaky capacitor” model that can describe how electricity is harvested and predict current behaviors consistent with experiments. Predictions from the model guide the fabrication of devices made from heterogeneous junctions of different materials to further expand the device category. The work opens a wide door for the broad exploration of sustainable electricity from air.more » « less
-
Abstract Spartina alterniflorahas a distinct flood‐adapted morphology, and its physiological responses are likely to vary with differences in tidal submergence. To understand these responses, we examined the impacts of tidal inundation on the efficiency of Photosystem II (φPSII) photochemistry and leaf‐level photosynthesis at different canopy heights through a combination of in situ chlorophyll fluorescence (ChlF), incident photosynthetically active radiation, and tide levels. Our result showed small declines (7%–8.3%) in φPSII for air‐exposed leaves when the bottom canopies were tidally submerged. Submerged leaves produced large reductions (30.3%–41%) in φPSII. Our results suggest that when submerged, PSII reaction centers inS. alternifloraleaves are still active and able to transfer electrons, but only at ∼20% of the typical daily rate. We attribute this reduction in φPSII to the decrease in the fraction of “open” PSII reaction centers (10% of the total) and the stomatal conductance rate caused by the tidal submergence. To our knowledge, this flooding induced leaf‐level reduction of φPSII forS. alterniflorain field settings has not been reported before. Our findings suggest that canopy‐level φPSII is dependent on the proportion of submerged versus emerged leaves and highlight the complexities involved in estimating the photosynthetic efficiency of tidal marshes.more » « less
-
Drop condensation and evaporation as a result of the gradient in vapor concentration are important in both engineering and natural systems. One of the interesting natural examples is transpiration on plant leaves. Most of the water in the inner space of the leaves escapes through stomata, whose rate depends on the surface topography and a difference in vapor concentrations inside and just outside of the leaves. Previous research on the vapor flux on various surfaces has focused on numerically solving the vapor diffusion equation or using scaling arguments based on a simple solution with a flat surface. In this present work, we present and discuss simple analytical solutions on various 2D surface shapes (e.g., semicylinder, semiellipse, hair). The method of solving the diffusion equation is to use the complex potential theory, which provides analytical solutions for vapor concentration and flux. We find that a high mass flux of vapor is formed near the top of the microstructures while a low mass flux is developed near the stomata at the leaf surface. Such a low vapor flux near the stomata may affect transpiration in two ways. First, condensed droplets on the stomata will not grow due to a low mass flux of vapor, which will not inhibit the gas exchange through the stomatal opening. Second, the low mass flux from the atmosphere will facilitate the release of highly concentrated vapor from the substomatal space.more » « less
-
The evaporation of droplets on surfaces is a ubiquitous phenomenon essential in nature and industrial applications ranging from thermal management of electronics to self-assembly-based fabrication. In this study, water droplet evaporation on a thin quartz substrate is analyzed using an unsteady two-step arbitrary Lagrangian-Eulerian (ALE) moving mesh model, wherein the evaporation process is simulated during the constant contact radius (CCR) and contact angle (CCA) modes. The numerical model considers mass transfer in the gas domain, flow in the liquid and gas domains, and heat transfer in the solid, liquid, and gas domains. Besides, the model also accounts for interfacial force balance, including thermocapillary stresses, to obtain the instantaneous droplet shape. Experiments involving droplet evaporation on unheated quartz substrates agree with model predictions of contact radius, contact angle, and droplet volume. Model results indicating temperature and velocity distribution across an evaporating water droplet show that the lowest temperatures are at the liquid-gas interface, and a single vortex exists for the predominant duration of the droplet's lifetime. The temperature of the unheated substrate is also significantly reduced due to evaporative cooling. The interfacial evaporation flux distribution, which depends on heat transfer across the droplet and advection in the surrounding medium, shows the highest values near the three-phase contact line. In addition, the model also predicts evaporation dynamics when the substrate is heated and exposed to different advection conditions. Generally, higher evaporation rates result from higher substrate heating and advection rates. However, substrate heating and advection in the surrounding gas have minimal effects on the relative durations of CCR and CCA modes for a given receding contact angle. Specifically, in this case, a 40× increase in substrate heating rate or 7.5× increase in gas velocity can only change these relative durations by 3%. This study also highlights the importance of surface wettability, which affects evaporation dynamics for all the conditions explored by the numerical model.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Conference Paper:
- The DOI is not currently available.
