We report the growth of nanoscale hafnium dioxide (HfO2) and zirconium dioxide (ZrO2) thin films using remote plasma-enhanced atomic layer deposition (PE-ALD), and the fabrication of complementary metal-oxide semiconductor (CMOS) integrated circuits using the HfO2 and ZrO2 thin films as the gate oxide. Tetrakis (dimethylamino) hafnium (Hf[N(CH3)2]4) and tetrakis (dimethylamino) zirconium (IV) (Zr[N(CH3)2]4) were used as the precursors, while O2 gas was used as the reactive gas. The PE-ALD-grown HfO2 and ZrO2 thin films were analyzed using X-ray photoelectron spectroscopy (XPS), X-ray diffraction (XRD), and high-resolution transmission electron microscopy (HRTEM). The XPS measurements show that the ZrO2 film has the atomic concentrations of 34% Zr, 2% C, and 64% O while the HfO2 film has the atomic concentrations of 29% Hf, 11% C, and 60% O. The HRTEM and XRD measurements show both HfO2 and ZrO2 films have polycrystalline structures. n-channel and p-channel metal-oxide semiconductor field-effect transistors (nFETs and pFETs), CMOS inverters, and CMOS ring oscillators were fabricated to test the quality of the HfO2 and ZrO2 thin films as the gate oxide. Current-voltage (IV) curves, transfer characteristics, and oscillation waveforms were measured from the fabricated transistors, inverters, and oscillators, respectively. The experimental results measured from the HfO2 and ZrO2 thin films were compared.
more »
« less
Electrical and chemical characterizations of hafnium (IV) oxide films for biological lab-on-a-chip devices
Many biological lab-on-a-chip applications require electrical and optical manipulation as well as detection of cells and biomolecules. This provides an intriguing challenge to design robust microdevices that resist adverse electrochemical side reactions yet achieve optical transparency. Physical isolation of biological samples from microelectrodes can prevent contamination, electrode fouling, and electrochemical byproducts; thus this manuscript explores hafnium oxide (HfO2) films - originating from traditional transistor applications – for suitability in electrokinetic microfluidic devices for biological applications. HfO2 films with deposition times of 6.5, 13, and 20 min were sputter deposited onto silicon and glass substrates. The structural, optical, and electrical properties of the HfO2 films were investigated using atomic force microscopy (AFM), X-ray diffraction, energy dispersive X-ray spectroscopy, Fourier transform infrared spectroscopy, ellipsometry, and capacitance voltage. Electric potential simulations of the HfO2 films and a biocompatibility study provided additional insights. Film grain size after corrosive Piranha treatment was observed via AFM. The crystalline structure investigated via X-ray diffraction revealed all films exhibited the (111) characteristic peak with thicker films exhibiting multiple peaks indicative of anisotropic structures. Energy dispersive X-ray spectroscopy via field emission scanning electron microscopy and Fourier transform infrared spectroscopy both corroborated the atomic ratio of the films as HfO2. Ellipsometry data from Si yielded thicknesses of 58, 127, and 239 nm and confirmed refractive index and extinction coefficients within the normal range for HfO2; glass data yielded unreliable thickness verifications due to film and substrate transparency. Capacitance-voltage results produced an average dielectric constant of 20.32, and the simulations showed that HfO2 dielectric characteristics were sufficient to electrically passivate planar microelectrodes. HfO2 biocompatibility was determined with human red blood cells by quantifying the hemolytic potential of the HfO2 films. Overall results support hafnium oxide as a viable passivation material for biological lab-on-a-chip applications.
more »
« less
- Award ID(s):
- 1632678
- NSF-PAR ID:
- 10097227
- Date Published:
- Journal Name:
- Thin solid films
- Volume:
- 662
- ISSN:
- 0040-6090
- Page Range / eLocation ID:
- 60-69
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
The electrical properties of graphene on dielectric substrates, such as silicon carbide (SiC), have received much attention due to their interesting applications. This work presents a method to grow graphene on a 6H-SiC substrate at a pressure of 35 Torr by using the hot filament chemical vapor deposition (HFCVD) technique. The graphene deposition was conducted in an atmosphere of methane and hydrogen at a temperature of 950 °C. The graphene films were analyzed using Raman spectroscopy, scanning electron microscopy, atomic force microscopy, energy dispersive X-ray, and X-ray photoelectron spectroscopy. Raman mapping and AFM measurements indicated that few-layer and multilayer graphene were deposited from the external carbon source depending on the growth parameter conditions. The compositional analysis confirmed the presence of graphene deposition on SiC substrates and the absence of any metal involved in the growth process.more » « less
-
Self-aligned metal-oxide-semiconductor (MOS) capacitors are studied with several low-temperature, wet chemical silicon dioxide (SiO2) interlayers to understand their impact on electrical performance. Self-aligned MOS capacitors are fabricated with a bottom-up patterning technique that uses a poly(methyl methacrylate) brush and dopant-selective KOH etch combined with area-selective atomic layer deposition of hafnium dioxide (HfO2) and Pt. The wet chemical pretreatments used to form the SiO2 interlayer include hydrofluoric acid (HF) etch, 80 °C H2O, and SC-2. Capacitance-voltage measurements of these area-selective capacitors exhibit a HfO2 dielectric constant of ∼19, irrespective of pretreatment. After a forming gas anneal, the average interface state density decreased between 1.8 and 7.5 times. The minimum observed Dit is 1 × 1011 eV−1 cm−2 for the HF-last treatment. X-ray photoelectron spectroscopy shows an increase in stoichiometric SiO2 in the interfacial layer after the anneal. Additional carbon is also observed; however, comparison with capacitors fabricated in a nonselective process reveals minimal impact on performance.more » « less
-
The development of functional chalcogenide optical phase change materials holds significant promise for advancing optics and photonics applications. Our comprehensive investigation into the solution processing of Sb2Se3 thin films presents a systematic approach from solvent exploration to substrate coating through drop-casting methods and heat treatments. By employing characterization techniques such as scanning electron microscopy, dynamic light scattering, energy-dispersive X-ray spectroscopy, Raman spectroscopy, and X-ray diffraction, we reveal crucial insights into the structural, compositional, and morphological properties of the films as well as demonstrated techniques for control over these features to ensure requisite optical quality. Our findings, compared with currently reported deposition techniques, highlight the potential of solution deposition as a route for scalable Sb2Se3 film processing.more » « less
-
more » « less
Electrodeposited conductive copolymer films with predictable relative properties (quantities of functional groups for further modification and capacitance) are of interest in sensors, organic electronic materials and energy applications. Potentiodynamic copolymerization of films in aqueous solutions of two different thiophene derivatives, (2,3-dihydrothieno[3,4-b]dioxin-2-yl)methanol (
1 ) and 4-((2,3-dihydrothieno[3,4-b][1,4]dioxin-2-yl)-methoxy)-4-oxobutanoic acid (2 ), containing 0.02 M total monomer (0, 25, 34, 50, 66, 75, 100 mol%2) , 0.05 M sodium dodecyl sulfate, and 0.1 M LiClO4, on gold microelectrodes in an array was investigated. Decreasing monomer deposited (m) from 0 to 100 mol%2 is attributed to a decreasing pH that inhibits electropolymerization. Molar ratios of1 and2 in the films, determined by micro-attenuated total reflectance Fourier transform infrared spectroscopy and X-ray photoelectron spectroscopy, tracks closely with the ratio in the deposition solutions. Capacitances measured from cyclic voltammetry in aqueous buffer and electron transfer of ferrocyanide at the films are unaffected by copolymer composition, except for the 100 mol%2 case. Ratios of reverse-to-forward faradaic peak currents suggest that films with high content of1 expand in the anodic form and contract in the cathodic form and vice versa for films with high content of2 , where anions and cations dominate counterion transport from solution, respectively.
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/https://doi.org/10.1016/j.tsf.2018.07.024
