An official website of the United States government
Abstract The development of dual catalysts with high efficiency toward oxygen reduction and evolution reactions (ORR and OER) in acidic media is a significant challenge. Here an active and durable dual catalyst based upon cubic Pt39Ir10Pd11nanocages with an average edge length of 12.3 nm, porous walls as thin as 1.0 nm, and well‐defined {100} facets is reported. The trimetallic nanocages perform better than all the reported dual catalysts in acidic media, with a low ORR‐OER overpotential gap of only 704 mV at a Pt‐Ir‐Pd loading of 16.8 µgPt+Ir+Pdcm−2geo. For ORR at 0.9 V, when benchmarked against the commercial Pt/C and Pt‐Pd nanocages, the trimetallic nanocages exhibit an enhanced mass activity of 0.52 A mg−1Pt+Ir+Pd(about four and two times as high as those of the Pt/C and Pt‐Pd nanocages) and much improved durability. For OER, the trimetallic nanocages show a remarkable mass activity of 0.20 A mg−1Pt+Irat 1.53 V, which is 16.7 and 4.3 fold relative to those of the Pt/C and Pt‐Pd nanocages, respectively. These improvements can be ascribed to the highly open structure of the nanocages, and the possible electronic coupling between Ir and Pt atoms in the lattice.
more »
« less
Programmable Exposure of Pt Active Facets for Efficient Oxygen Reduction
Abstract To produce efficient ORR catalysts with low Pt content, PtNi porous films (PFs) with sufficiently exposed Pt active sites were designed by an approach combining electrochemical bottom‐up (electrodeposition) and top‐down (anodization) processes. The dynamic oxygen‐bubble template (DOBT) programmably controlled by a square‐wave potential was used to tune the catalyst morphology and expose Pt active facets in PtNi PFs. Surface‐bounded species, such as hydroxyl (OH*, *=surface site) on the exposed PtNi PFs surfaces were adjusted by the applied anodic voltage, further affecting the dynamic oxygen (O2) bubbles adsorption on Pt. As a result, PtNi PF with enriched Pt(111) facets (denoted as Pt3.5 %Ni PF) was obtained, showing prominent ORR activity with an onset potential of 0.92 V (vs. RHE) at an ultra‐low Pt loading (0.015 mg cm−2).
more »
« less
- Award ID(s):
- 1851674
- PAR ID:
- 10115274
- Publisher / Repository:
- Wiley Blackwell (John Wiley & Sons)
- Date Published:
- Journal Name:
- Angewandte Chemie International Edition
- Volume:
- 58
- Issue:
- 44
- ISSN:
- 1433-7851
- Page Range / eLocation ID:
- p. 15848-15854
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract We present a one‐pot colloidal synthesis method for producing monodisperse multi‐metal (Co, Mn, and Fe) spinel nanocrystals (NCs), including nanocubes, nano‐octahedra, and concave nanocubes. This study explores the mechanism of morphology control, showcasing the pivotal roles of metal precursors and capping ligands in determining the exposed crystal planes on the NC surface. The cubic spinel NCs, terminated with exclusive {100}‐facets, demonstrate superior electrocatalytic activity for the oxygen reduction reaction (ORR) in alkaline media compared to their octahedral and concave cubic counterparts. Specifically, at 0.85 V, (CoMn)Fe2O4spinel oxide nanocubes achieve a high mass activity of 23.9 A/g and exhibit excellent stability, highlighting the promising ORR performance associated with {100}‐facets of multi‐metal spinel oxides over other low‐index and high‐index facets. Motivated by exploring the correlation between ORR performance and surface atom arrangement (active sites), surface element composition, as well as other factors, this study introduces a prospective approach for shape‐controlled synthesis of advanced spinel oxide NCs. It underscores the significance of catalyst shape control and suggests potential applications as nonprecious metal ORR electrocatalysts.more » « less
-
Abstract The design of high‐entropy single‐atom catalysts (HESAC) with 5.2 times higher entropy compared to single‐atom catalysts (SAC) is proposed, by using four different metals (FeCoNiRu‐HESAC) for oxygen reduction reaction (ORR). Fe active sites with intermetallic distances of 6.1 Å exhibit a low ORR overpotential of 0.44 V, which originates from weakening the adsorption of OH intermediates. Based on density functional theory (DFT) findings, the FeCoNiRu‐HESAC with a nitrogen‐doped sample were synthesized. The atomic structures are confirmed with X‐ray photoelectron spectroscopy (XPS), X‐ray absorption (XAS), and scanning transmission electron microscopy (STEM). The predicted high catalytic activity is experimentally verified, finding that FeCoNiRu‐HESAC has overpotentials of 0.41 and 0.37 V with Tafel slopes of 101 and 210 mVdec−1at the current density of 1 mA cm−2and the kinetic current densities of 8.2 and 5.3 mA cm−2, respectively, in acidic and alkaline electrolytes. These results are comparable with Pt/C. The FeCoNiRu‐HESAC is used for Zinc–air battery applications with an open circuit potential of 1.39 V and power density of 0.16 W cm−2. Therefore, a strategy guided by DFT is provided for the rational design of HESAC which can be replaced with high‐cost Pt catalysts toward ORR and beyond.more » « less
-
Abstract Vertically aligned carbon nanofibers (VACNFs) are promising supports for oxygen reduction reaction (ORR) electrocatalysts in fuel cells. Although experimentally these catalytic systems have shown great potential, there is lack of molecular understanding of the catalytic sites and reaction mechanisms. This work investigated the origin of the ORR reactivities of the platinum catalysts on multi‐edged VACNFs (Pt/VACNF) using a multiscale modeling approach combining Density Functional Theory (DFT) and classical Molecular Dynamics (MD) simulations. Based on the ReaxFF potential, all nanoscale Pt particles (Pt55, P100, and Pt147) are stabilized by the open edges located axially along the VACNF walls. The calculated first‐shell coordination numbers,, of surface Pt atoms are 6.63, 7.27, and 7.85, respectively, suggesting that the percentage of low coordination sites increases as the particle size decreases. The adsorption energies of OOH, O, and OH on Pt55were systematically probed using DFT calculations. These adsorption energies retain a linear correlation against the generalized coordination numbers (). For Pt nanoparticles supported on VACNF, we found that the OOH and OH bind stronger than on Pt (111) by 0.14 and 0.17 eV, respectively, which can hinder the ORR activity with lower limiting potential than Pt (111). Our theoretical prediction is in good agreement with the linear sweeping voltammetry that revealed a left shift of the half‐wave potential.more » « less
-
Surface‐Engineered Pt‐Ni(111) Nanocatalysts for Boosting Their ORR Performance via Thermal TreatmentAbstract The electrochemical oxygen reduction reaction (ORR) is critical for fuel cell application, and modifying surface structures of electrocatalysts has proven effective in improving their catalytic performances. In this study, we investigated surface‐engineered Pt−Ni nano‐octahedra subjected to annealing in various atmospheres. All octahedral nanocrystals retained their Pt−Ni {111} facets at an elevated temperature following the annealing treatments. Air annealing led to the formation of nickel‐rich shells on the Pt−Ni surface. In contrast, hydrogen (H₂) as a reducing gas facilitated the reduction of surface Ni species, incorporating them into the Pt−Ni bulk alloy, which resulted in superior mass activity and specific activity for ORR‐approximately 2.4 and 2.3 times as high as those from the unmodified counterpart, respectively. After 20,000 potential cycles, the H₂/Ar‐annealed Pt−Ni nano‐octahedra maintained a mass activity of 3.92 A/ , surpassing the initial mass activity of the unannealed counterparts (2.95 A/ ). These findings demonstrate a viable approach for tailoring catalyst surfaces to enhance performance in various energy storage and conversion applications.more » « less
