This paper proposes a control scheme to force homogeneity for heterogenous network of the grid-forming (GFM) inverters in power electronics dominated grid (PEDG) to enable their aggregation and coherent dynamic interaction. Increased penetration of the renewable energy in distributed generation (DG) fashion is moving traditional power system to a highly disperse and complex heterogenous system i.e., PEDG with fleet of grid-forming and grid-following inverters. Optimal coordination, stability assessment, and situational awareness of PEDG is challenging due to numerous heterogenous inverters operating at the grid-edge that is outside the traditional utility centric power generation boundaries. Aggregation of these inverters will not be insightful due to their heterogenous characteristics. The proposed control scheme to force enclaved homogeneity (FEH) enables an insightful aggregation of GFM that can fully mimic the given physical system dynamics. The proposed FEH scheme enables coherent and homogenized dynamic interaction of GFM inverters that enhances the PEDG resiliency. Moreover, different cluster of GFM can be merged into single cluster with minimal synchronization time and frequency fluctuations. Accurate reference models can be achieved that enables effective dynamic assessment and optimal coordination which results in resilient PEDG. Several case studies provided to validate the effectiveness of proposed FEH in network of GFM. Then, GFMs aggregation and developed reference model for the PEDG system is validated via multiple comparative case studies.
more »
« less
Optimal Distribution System Restoration with Microgrids and Distributed Generators
Increasing emphasis on reliability and resiliency call for advanced distribution system restoration (DSR). The integration of grid sensors, remote controls, and distributed generators (DG) brings about exciting opportunities in DSR. In this context, this work considers the task of single-step restoration of a single-phase power distribution system. Different from existing works, the devised restoration scheme achieves optimal formation of islands without heuristically pre-identifying reference buses. It further facilitates multiple DGs running within the same island, and establishes a coordination hierarchy in terms of their PV/PQ operation modes. Generators without black-start capability are guaranteed to remain connected to a black-start DG or a substation. The proposed scheme models remotely-controlled voltage regulators exactly, and integrates them in the restoration process. Numerical tests on a modified IEEE 37-bus feeder demonstrate that the proposed mixed-integer linear program (MILP) takes less than four seconds to handle random outages of 1-5 lines. The scalability of this novel MILP formulation can be attributed to the unique use of cycles and paths on the grid infrastructure graph; the McCormick linearization technique; and an approximate power flow model.
more »
« less
- Award ID(s):
- 1751085
- NSF-PAR ID:
- 10143341
- Date Published:
- Journal Name:
- IEEE Power & Energy Society General Meeting
- Page Range / eLocation ID:
- 1 to 5
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
The concept of Energy Hub has been proposed to facilitate the synergies among different forms of energy carriers. Under the new electricity market environment, it is of great significance to build a win-win situation for prosumers and Hub manager (HM) at the level of community without bringing extra burden to the utility grid. This paper proposes a cooperative trading mode for a community-level energy system (CES), which consists of Energy Hub (EH) and PV prosumers with the automatic demand response (DR) capability. In the cooperative trading framework, a real-time rolling horizon energy management model is proposed based on cooperative game theory considering the stochastic characteristics of PV prosumers and the conditional value at risk (CVaR). The validity of the proposed model is analyzed through the optimality proof of the grand coalition. A contribution-based profit distribution scheme and its stability proof are also provided. Moreover, in order to solve the optimization model, it is further transformed into a more easily resolved mixed integer linear programming (MILP) model by adding auxiliary variables. Finally, via a practical example, the effectiveness of the model is verified in terms of promoting local consumption of PV energy, increasing HM's profits, and reducing prosumers' costs, etc.more » « less
-
null (Ed.)This paper proposes a finite-time event-triggered secondary frequency and voltage control for islanded AC microgrids (MGs) in a distributed fashion. The proposed control strategy can effectively perform frequency restoration and voltage regulations, while sharing the active and reactive power among the distributed generators (DGs) based on their power ratings. The finite-time control enables a system to reach consensus in a finite period of time enhanced from the asymptotic convergence. The event-triggered communication is utilized to reduce the communication burden among the DG controllers by transmitting data among DGs if an event-triggering condition is satisfied. The performance of the proposed finite-time event-triggered frequency control is verified utilizing a hardware-in-the-loop experimental testbed which simulates an AC MG in Opal-RT.more » « less
-
more » « less
Abstract This paper presents the genetic algorithm (GA) and particle swarm optimization (PSO) based frequency regulation for a wind‐based microgrid (MG) using reactive power balance loop. MG, operating from squirrel cage induction generator (SCIG), is employed for exporting the electrical power from wind turbines, and it needs reactive power which may be imported from the grid. Additional reactive power is also required from the grid for the load, directly coupled with such a distributed generator (DG) plant. However, guidelines issued by electric authorities encourage MGs to arrange their own reactive power because such reactive power procurement is defined as a local area problem for power system studies. Despite the higher cost of compensation, static synchronous compensator (STATCOM) is a fast‐acting FACTs device for attending to these reactive power mismatches. Reactive power control can be achieved by controlling reactive current through the STATCOM. This can be achieved with modification in current controller scheme of STATCOM. STATCOM current controller is designed with reactive power load balance for the proposed microgrid in this paper. Further, gain values of the PI controller, required in the STATCOM model, are selected first with classical methods. In this classical method, iterative procedures which are based on integral square error (ISE), integral absolute error (IAE), and integral square of time error (ISTE) criteria are developed using MATLAB programs. System performances are further investigated with GA and PSO based control techniques and their acceptability over classical methods is diagnosed. Results in terms of converter frequency deviation show how the frequency remains under the operating boundaries as allowed by IEEE standards 1159:1995 and 1250:2011 for integrating renewable‐based microgrid with grid. Real and reactive power management and load current total harmonic distortions verify the STATCOM performance in MG. The results are further validated with the help of recent papers in which frequency regulation is investigated for almost similar power system models. The compendium for this work is as following: (i) modelling of wind generator‐based microgrid using MATLAB simulink library, (ii) designing of STATCOM current controller with PI controller, (iii) gain constants estimation using classical, GA and PSO algorithm through a developed m codes and their interfacing with proposed simulink model, (v) dynamic frequency responses for proposed grid connected microgrid during starting and load perturbations, (vi) verification of system performance with the help of obtained real and reactive power management between STATCOM and grid, and (vii) validation of results with available literature.
-
Larger penetration of Distributed Generations (DG) in the power system brings new flexibility and opportunity as well as new challenges due to the generally intermittent nature of DG. When these DG are installed in the medium voltage distribution systems as components of the smart grid, further support is required to ensure a smooth and controllable operation. To complement the uncontrollable output power of these resources, energy storage devices need to be incorporated to absorb excessive power and provide power shortage in time of need. They also can provide reactive power to dynamically help the voltage profile. Energy Storage Systems (ESS) can be expensive and limited number of them can practically be installed in distribution systems. In addition to frequency regulation and energy time shifting, ESS can support voltage and angle stability in the power network. This paper applies a Jacobian matrix-based sensitivity analysis to determine the most appropriate node in a grid to collectively improve the voltage magnitude and angle of all the nodes by active/reactive power injection. IEEE 14, 24, and 123-bus distribution system are selected to demonstrate the performance of the proposed method. As opposed to most previous studies, this method does not require an iteration loop with a convergence problem nor a network-related complicated objective function.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Conference Paper:
- https://doi.org/10.1109/PESGM40551.2019.8973841
