skip to main content


Title: Energy transport in glasses
The temperature dependence of the thermal conductivity is linked to the nature of the energy transport at a frequency ω , which is quantified by thermal diffusivity d ( ω ). Here we study d ( ω ) for a poorly annealed glass and a highly stable glass prepared using the swap Monte Carlo algorithm. To calculate d ( ω ), we excite wave packets and find that the energy moves diffusively for high frequencies up to a maximum frequency, beyond which the energy stays localized. At intermediate frequencies, we find a linear increase of the square of the width of the wave packet with time, which allows for a robust calculation of d ( ω ), but the wave packet is no longer well described by a Gaussian as for high frequencies. In this intermediate regime, there is a transition from a nearly frequency independent thermal diffusivity at high frequencies to d ( ω ) ∼ ω −4 at low frequencies. For low frequencies the sound waves are responsible for energy transport and the energy moves ballistically. The low frequency behavior can be predicted using sound attenuation coefficients.  more » « less
Award ID(s):
1800282
NSF-PAR ID:
10176498
Author(s) / Creator(s):
; ;
Date Published:
Journal Name:
Soft Matter
Volume:
16
Issue:
3
ISSN:
1744-683X
Page Range / eLocation ID:
775 to 783
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. Abstract

    Vertical energy transports due to dissipating gravity waves in the mesopause region (85–100 km) are analyzed using over 400 h of observational data obtained from a narrow‐band sodium wind‐temperature lidar located at Andes Lidar Observatory (ALO), Cerro Pachón (30.25°S, 70.73°W), Chile. Sensible heat flux is directly estimated using measured temperature and vertical wind; energy flux is estimated from the vertical wavenumber and frequency spectra of temperature perturbations; and enthalpy flux is derived based on its relationship with sensible heat and energy fluxes. Sensible heat flux is mostly downward throughout the region. Enthalpy flux exhibits an annual oscillation with maximum downward transport in July above 90 km. The dominant feature of energy flux is the exponential decrease from 10−2to 10−4 W m−2with the altitude increases from 85 to 100 km and is larger during austral winter. The annual mean thermal diffusivity inferred from enthalpy flux decreases from 303 m2s−1at 85 km to minimum 221 m2s−1at 90 km then increases to 350 m2s−1at 99 km. Results also show that shorter period gravity waves tend to dissipate at higher altitudes and generate more heat transport. The averaged vertical group velocities for high, medium, and low frequency waves are 4.15 m s−1, 1.15 m s−1, and 0.70 m s−1, respectively. Gravity wave heat transport brings significant cooling in the mesopause region at an average cooling rate of 6.7 ± 1.1 K per day.

     
    more » « less
  2. SUMMARY

    We have simulated 0–5 Hz deterministic wave propagation for a suite of 17 models of the 2014 Mw 5.1 La Habra, CA, earthquake with the Southern California Earthquake Center Community Velocity Model Version S4.26-M01 using a finite-fault source. Strong motion data at 259 sites within a 148 km × 140 km area are used to validate our simulations. Our simulations quantify the effects of statistical distributions of small-scale crustal heterogeneities (SSHs), frequency-dependent attenuation Q(f), surface topography and near-surface low-velocity material (via a 1-D approximation) on the resulting ground motion synthetics. The shear wave quality factor QS(f) is parametrized as QS, 0 and QS, 0fγ for frequencies less than and higher than 1 Hz, respectively. We find the most favourable fit to data for models using ratios of QS, 0 to shear wave velocity VS of 0.075–1.0 and γ values less than 0.6, with the best-fitting amplitude drop-off for the higher frequencies obtained for γ values of 0.2–0.4. Models including topography and a realistic near-surface weathering layer tend to increase peak velocities at mountain peaks and ridges, with a corresponding decrease behind the peaks and ridges in the direction of wave propagation. We find a clear negative correlation between the effects on peak ground velocity amplification and duration lengthening, suggesting that topography redistributes seismic energy from the large-amplitude first arrivals to the adjacent coda waves. A weathering layer with realistic near-surface low velocities is found to enhance the amplification at mountain peaks and ridges, and may partly explain the underprediction of the effects of topography on ground motions found in models. Our models including topography tend to improve the fit to data, as compared to models with a flat free surface, while our distributions of SSHs with constraints from borehole data fail to significantly improve the fit. Accuracy of the velocity model, particularly the near-surface low velocities, as well as the source description, controls the resolution with which the anelastic attenuation can be determined. Our results demonstrate that it is feasible to use fully deterministic physics-based simulations to estimate ground motions for seismic hazard analysis up to 5 Hz. Here, the effects of, and trade-offs with, near-surface low-velocity material, topography, SSHs and Q(f) become increasingly important as frequencies increase towards 5 Hz, and should be included in the calculations. Future improvement in community velocity models, wider access to computational resources, more efficient numerical codes and guidance from this study are bound to further constrain the ground motion models, leading to more accurate seismic hazard analysis.

     
    more » « less
  3. Abstract Cosmic-ray transport on galactic scales depends on the detailed properties of the magnetized, multiphase interstellar medium (ISM). In this work, we postprocess a high-resolution TIGRESS magnetohydrodynamic simulation modeling a local galactic disk patch with a two-moment fluid algorithm for cosmic-ray transport. We consider a variety of prescriptions for the cosmic rays, from a simple, purely diffusive formalism with constant scattering coefficient, to a physically motivated model in which the scattering coefficient is set by the critical balance between streaming-driven Alfvén wave excitation and damping mediated by local gas properties. We separately focus on cosmic rays with kinetic energies of ∼1 GeV (high-energy) and ∼30 MeV (low energy), respectively important for ISM dynamics and chemistry. We find that simultaneously accounting for advection, streaming, and diffusion of cosmic rays is crucial for properly modeling their transport. Advection dominates in the high-velocity, low-density hot phase, while diffusion and streaming are more important in higher-density, cooler phases. Our physically motivated model shows that there is no single diffusivity for cosmic-ray transport: the scattering coefficient varies by four or more orders of magnitude, maximal at density n H ∼ 0.01 cm −3 . The ion-neutral damping of Alfvén waves results in strong diffusion and nearly uniform cosmic-ray pressure within most of the mass of the ISM. However, cosmic rays are trapped near the disk midplane by the higher scattering rate in the surrounding lower-density, higher-ionization gas. The transport of high-energy cosmic rays differs from that of low-energy cosmic rays, with less effective diffusion and greater energy losses for the latter. 
    more » « less
  4. Abstract

    Linear spreading of a wave packet or a Gaussian beam is a fundamental effect known in evolution of quantum state and propagation of optical/acoustic beams. The rate of spreading is determined by the diffraction coefficientDwhich is proportional to the curvature of the isofrequency surface. Here, we analyzed dispersion of sound in a solid-fluid layered structure and found a flex point on the isofrequency curve whereDvanishes for given direction of propagation and frequency. Nonspreading propagation is experimentally observed in a water steel lattice of 75 periods (~1 meter long) and occurs in the regime of anomalous dispersion and strong acoustic anisotropy when the effective mass along periodicity is close to zero. Under these conditions the incoming beam experiences negative refraction of phase velocity leading to backward wave propagation. The observed effect is explained using a complete set of dynamical equations and our effective medium theory.

     
    more » « less
  5. Abstract

    We investigate the role of small‐scale, high‐frequency motions on lateral transport in the ocean, by using velocity fields and particle trajectories from an ocean general circulation model (MITgcm‐llc4320) that permits submesoscale flows, inertia‐gravity waves, and tides. Temporal averaging/filtering removes most of the submesoscale turbulence, inertia‐gravity waves, and tides, resulting in a largely geostrophic flow, with a rapid drop‐off in energy at scales smaller than the mesoscales. We advect two types of Lagrangian particles: (a) 2‐D particles (surface restricted) and (b) 3‐D particles (advected in full three dimensions) with the filtered and unfiltered velocities and calculate Lagrangian diagnostics. At large length/time scales, Lagrangian diffusivity is comparable for filtered and unfiltered velocities, while at short scales, unfiltered velocities disperse particles much faster. We also calculate diagnostics of Lagrangian coherent structures:rotationally coherent Lagrangian vortices detected from closed contours of the Lagrangian‐averaged vorticity deviation and material transport barriers formed by ridges of maximum finite‐time Lyapunov exponent. For temporally filtered velocities, we observe strong material coherence, which breaks down when the level of temporal filtering is reduced/removed, due to vigorous small‐scale mixing. In addition, for the lowest temporal resolution, the 3‐D particles experience very little vertical motion, suggesting that degrading temporal resolution greatly reduces vertical advection by high‐frequency motions. Our study suggests that Lagrangian diagnostics based on satellite‐derived surface geostrophic velocity fields, even with higher spatial resolutions as in the upcoming Surface Water and Ocean Topography mission, may overestimate the presence of mesoscale coherent structures and underestimate dispersion.

     
    more » « less