SUMMARY Stagnant-lid convection, where subduction and surface plate motion is absent, is common among the rocky planets and moons in our solar system, and likely among rocky exoplanets as well. How stagnant-lid planets thermally evolve is an important issue, dictating not just their interior evolution but also the evolution of their atmospheres via volcanic degassing. On stagnant-lid planets, the crust is not recycled by subduction and can potentially grow thick enough to significantly impact convection beneath the stagnant lid. We perform numerical models of stagnant-lid convection to determine new scaling laws for convective heat flux that specifically account for the presence of a buoyant crustal layer. We systematically vary the crustal layer thickness, crustal layer density, Rayleigh number and Frank–Kamenetskii parameter for viscosity to map out system behaviour and determine the new scaling laws. We find two end-member regimes of behaviour: a ‘thin crust limit’, where convection is largely unaffected by the presence of the crust, and the thickness of the lithosphere is approximately the same as it would be if the crust were absent; and a ‘thick crust limit’, where the crustal thickness itself determines the lithospheric thickness and heat flux. Scaling laws for both limits are developed and fit the numerical model results well. Applying these scaling laws to rocky stagnant-lid planets, we find that the crustal thickness needed for convection to enter the thick crust limit decreases with increasing mantle temperature and decreasing mantle reference viscosity. Moreover, if crustal thickness is limited by the formation of dense eclogite, and foundering of this dense lower crust, then smaller planets are more likely to enter the thick crust limit because their crusts can grow thicker before reaching the pressure where eclogite forms. When convection is in the thick crust limit, mantle heat flux is suppressed. As a result, mantle temperatures can be elevated by 100 s of degrees K for up to a few Gyr in comparison to a planet with a thin crust. Whether convection enters the thick crust limit during a planet’s thermal evolution also depends on the initial mantle temperature, so a thick, buoyant crust additionally acts to preserve the influence of initial conditions on stagnant-lid planets for far longer than previous thermal evolution models, which ignore the effects of a thick crust, have found.
more »
« less
On formulations of compressible mantle convection
SUMMARY Mantle convection and long-term lithosphere dynamics in the Earth and other planets can be treated as the slow deformation of a highly viscous fluid, and as such can be described using the compressible Navier–Stokes equations. Since on Earth-sized planets the influence of compressibility is not a dominant effect, density deviations from a reference profile are at most on the order of a few percent and using the full governing equations poses numerical challenges, most modelling studies have simplified the governing equations. Common approximations assume a temporally constant, but depth-dependent reference profile for the density (the anelastic liquid approximation), or drop compressibility altogether and use a constant reference density (the Boussinesq approximation). In most previous studies of mantle convection and crustal dynamics, one can assume that the error introduced by these approximations was small compared to the errors that resulted from poorly constrained material behaviour and limited numerical accuracy. However, as model parametrizations have become more realistic, and model resolution has improved, this may no longer be the case and the error due to using simplified conservation equations might no longer be negligible: while such approximations may be reasonable for models of mantle plumes or slabs traversing the whole mantle, they may be unsatisfactory for layered materials experiencing phase transitions or materials undergoing significant heating or cooling. For example, at boundary layers or close to dynamically changing density gradients, the error arising from the use of the aforementioned compressibility approximations can be the dominant error source, and common approximations may fail to capture the physical behaviour of interest. In this paper, we discuss new formulations of the continuity equation that include dynamic density variations due to temperature, pressure and composition without using a reference profile for the density. We quantify the improvement in accuracy relative to existing formulations in a number of benchmark models and evaluate for which practical applications these effects are important. Finally, we consider numerical aspects of the new formulations. We implement and test these formulations in the freely available community software aspect, and use this code for our numerical experiments.
more »
« less
- NSF-PAR ID:
- 10185552
- Date Published:
- Journal Name:
- Geophysical Journal International
- Volume:
- 221
- Issue:
- 2
- ISSN:
- 0956-540X
- Page Range / eLocation ID:
- 1264 to 1280
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
more » « less
SUMMARY Tsunami generation by offshore earthquakes is a problem of scientific interest and practical relevance, and one that requires numerical modelling for data interpretation and hazard assessment. Most numerical models utilize two-step methods with one-way coupling between separate earthquake and tsunami models, based on approximations that might limit the applicability and accuracy of the resulting solution. In particular, standard methods focus exclusively on tsunami wave modelling, neglecting larger amplitude ocean acoustic and seismic waves that are superimposed on tsunami waves in the source region. In this study, we compare four earthquake-tsunami modelling methods. We identify dimensionless parameters to quantitatively approximate dominant wave modes in the earthquake-tsunami source region, highlighting how the method assumptions affect the results and discuss which methods are appropriate for various applications such as interpretation of data from offshore instruments in the source region. Most methods couple a 3-D solid earth model, which provides the seismic wavefield or at least the static elastic displacements, with a 2-D depth-averaged shallow water tsunami model. Assuming the ocean is incompressible and tsunami propagation is negligible over the earthquake duration leads to the instantaneous source method, which equates the static earthquake seafloor uplift with the initial tsunami sea surface height. For longer duration earthquakes, it is appropriate to follow the time-dependent source method, which uses time-dependent earthquake seafloor velocity as a forcing term in the tsunami mass balance. Neither method captures ocean acoustic or seismic waves, motivating more advanced methods that capture the full wavefield. The superposition method of Saito et al. solves the 3-D elastic and acoustic equations to model the seismic wavefield and response of a compressible ocean without gravity. Then, changes in sea surface height from the zero-gravity solution are used as a forcing term in a separate tsunami simulation, typically run with a shallow water solver. A superposition of the earthquake and tsunami solutions provides an approximation to the complete wavefield. This method is algorithmically a two-step method. The complete wavefield is captured in the fully coupled method, which utilizes a coupled solid Earth and compressible ocean model with gravity. The fully coupled method, recently incorporated into the 3-D open-source code SeisSol, simultaneously solves earthquake rupture, seismic waves and ocean response (including gravity). We show that the superposition method emerges as an approximation to the fully coupled method subject to often well-justified assumptions. Furthermore, using the fully coupled method, we examine how the source spectrum and ocean depth influence the expression of oceanic Rayleigh waves. Understanding the range of validity of each method, as well as its computational expense, facilitates the selection of modelling methods for the accurate assessment of earthquake and tsunami hazards and the interpretation of data from offshore instruments.
-
more » « less
SUMMARY Phase transitions play an important role for the style of mantle convection. While observations and theory agree that a substantial fraction of subducted slabs and rising plumes can move through the whole mantle at present day conditions, this behaviour may have been different throughout Earth’s history. Higher temperatures, such as in the early Earth, cause different phase transitions to be dominant, and also reduce mantle viscosity, favouring a more layered style of convection induced by phase transitions. A period of layered mantle convection in Earth’s past would have significant implications for the secular evolution of the mantle temperature and the mixing of mantle heterogeneities. The transition from layered to whole mantle convection could lead to a period of mantle avalanches associated with a dramatic increase in magmatic activity. Consequently, it is important to accurately model the influence of phase transitions on mantle convection. However, existing numerical methods generally preclude modelling phase transitions that are only present in a particular range of pressures, temperatures or compositions, and they impose an artificial lower limit on the thickness of phase transitions. To overcome these limitations, we have developed a new numerical method that solves the energy equation for entropy instead of temperature. This technique allows for robust coupling between thermodynamic and geodynamic models and makes it possible to model realistically sharp phase transitions with a wide range of properties and dynamic effects on mantle processes. We demonstrate the utility of our method by applying it in regional and global convection models, investigating the effect of individual phase transitions in the Earth’s mantle with regard to their potential for layering flow. We find that the thickness of the phase transition has a bigger influence on the style of convection than previously thought: with all other parameters being the same, a thin phase transition can induce fully layered convection where a broad phase transition would lead to whole-mantle convection. Our application of the method to convection in the early Earth illustrates that endothermic phase transitions may have induced layering for higher mantle temperatures in the Earth’s past.
-
more » « less
Abstract This study investigates the emergence of hurricane‐like vortices in idealized simulations of rotating moist convection. A Boussinesq atmosphere with simplified thermodynamics for phase transitions is forced by prescribing the temperature and humidity at the upper and lower boundaries. The governing equations are solved numerically using a variable‐density incompressible Navier‐Stokes solver with adaptive mesh refinement to explore the behavior of moist convection under a broad range of conditions. In the absence of rotation, convection aggregates into active patches separated by large unsaturated regions. Rotation modulates this statistical equilibrium state so that the self‐aggregated convection organizes hurricane‐like vortices. The warm and saturated air converges to the center of the vortices, and the latent heat released through the upwelling, forms the warm core structure. These hurricane‐like vortices share characteristics similar to tropical cyclones in the earth's atmosphere. The hurricane‐like vortices occur under conditionally unstable conditions where the potential energy given at the boundaries is large enough, corresponding to a moderate rate of rotation. This regime shares many similar characteristics to the tropical atmosphere indicating that the formation of intense meso‐scale vortices is a general characteristic of rotating moist convection. The model used here does not include any interactions with radiation, wind‐evaporation feedback, or cloud microphysics, indicating that, while these processes may be relevant for tropical cyclogenesis in the Earth atmosphere, they are not its primary cause. Instead, our results confirm that the formation and maintenance of hurricane‐like vortices involve a combination of atmospheric dynamics under the presence of rotation and of phase transitions.
-
more » « less
Abstract Rocky planets with high levels of internal heat production experience high rates of melting and extensive volcanic resurfacing in the heat pipe mode of planetary heat transport. On Earth, this took place prior to the onset of plate tectonics during the first billion or more years. The extraction of melt from a planetary mantle affects the mantle dynamics, the temperature structure of the interior, the viscosity of mantle material, and the timescales of thermal equilibration in the mantle, and therefore, developing a quantitative parameterization for heat transport by volcanism is necessary to calculate the thermal histories of terrestrial planets efficiently. In this work, we develop a quantitative parameterization of heat transport in planetary mantles including the effect of melting. The heat flux due to melting, the internal temperature of the mantle, the temperature of the lid base, the lid thickness, and the heat flux due to conduction were calculated using the parameterization for different cases of solidus gradient and surface melting temperatures, and the values were compared with the results of numerical simulations for validation. The good fit achieved (<15% relative error) over a large range of melt fluxes with no additional parameters indicates that the parameterization usefully and accurately models the process of mantle convection including melting.
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1093/gji/ggaa078
