An official website of the United States government
Abstract An unusual self‐assembly pattern is observed for highly ordered 1500‐nm‐thick films of monodisperse 13‐nm‐sized colloidal PbSe quantum dots, originating from their faceted truncated cube‐like shape. Specifically, self‐assembled PbSe dots exhibited attachment to the substrate by <001> planes followed by an interconnection through the {001} facets in plan‐view and {110}/{111} facets in cross‐sectional‐view, thus forming a cubic superlattice. The thermoelectric properties of the PbSe superlattice thin films are investigated by means of frequency domain thermoreflectance, scanning thermal probe microscopy, and four‐probe measurements, and augmented by computational efforts. Thermal conductivity of the superlattice films is measured as low as 0.7 W m−1 K−1at room temperature due to the developed nanostructure. The low values of electrical conductivity are attributed to the presence of insulating oleate capping ligands at the dots’ surface and the small contact area between the PbSe dots within the superlattice. Experimental efforts aiming at the removal of the oleate ligands are conducted by annealing or molten‐salt treatment, and in the latter case, yielded a promising improvement by two orders of magnitude in thermoelectric performance. The result indicates that the straightforward molten‐salt treatment is an interesting approach to derive thermoelectric dot superlattice thin films over a centimeter‐sized area.
more »
« less
Precursors for PbTe, PbSe, SnTe, and SnSe synthesized using diphenyl dichalcogenides
We create precursors for PbTe, PbSe, SnTe, and SnSe by reacting Pb or Sn with diphenyl dichalcogenides in a variety of different solvents. We then deposit PbSe x Te 1−x thin films using these precursors and measure their thermoelectric properties. Introducing Na-dopants into the films allows the thermoelectric properties to be varied.
more »
« less
- Award ID(s):
- 1506829
- PAR ID:
- 10188019
- Date Published:
- Journal Name:
- Chemical Communications
- Volume:
- 54
- Issue:
- 65
- ISSN:
- 1359-7345
- Page Range / eLocation ID:
- 9055 to 9058
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
There has been a growing interest in solution-phase routes to thermoelectric materials due to the decreased costs and novel device architectures that these methods enable. Many excellent thermoelectric materials are metal chalcogenide semiconductors and the ability to create soluble metal chalcogenide semiconductor precursors using thiol–amine solvent mixtures was recently demonstrated by others. In this paper, we report the first thermoelectric property measurements on metal chalcogenide thin films made in this manner. We create Cu 2−x Se y S 1−y and Ag-doped Cu 2−x Se y S 1−y thin films and study the interrelationship between their composition and room temperature thermoelectric properties. We find that the precursor annealing temperature affects the metal : chalcogen ratio, and leads to charge carrier concentration changes that affect the Seebeck coefficient and electrical conductivity. Increasing the Se : S ratio increases electrical conductivity and decreases the Seebeck coefficient. We also find that incorporating Ag into the Cu 2−x Se y S 1−y film leads to appreciable improvements in thermoelectric performance by increasing the Seebeck coefficient and decreasing thermal conductivity. Overall, we find that the room temperature thermoelectric properties of these solution-processed materials are comparable to measurements on Cu 2−x Se alloys made via conventional thermoelectric material processing methods. Achieving parity between solution-phase processing and conventional processing is an important milestone and demonstrates the promise of this binary solvent approach as a solution-phase route to thermoelectric materials.more » « less
-
We investigate the beneficial effects of rapid thermal annealing on structure and photoluminescence of PbSe thin films on GaAs (001) grown below 150 °C, with a goal of low temperature integration for infrared optoelectronics. Thin films of PbSe deposited on GaAs by molecular beam epitaxy are epitaxial at these reduced growth temperatures, yet the films are highly defective with a mosaic grain structure with low angle and dendritic boundaries following coalescence. Remarkably, we find that rapid thermal annealing for as short as 180 s at temperatures between 300 and 425 °C in nitrogen ambient leads to extensive re-crystallization and transformation of these grain boundaries. The annealing at the same time dramatically improves the band edge luminescence at 3.7 μm from previously undetectable levels to nearly half as intense as our best conventionally grown PbSe films at 300 °C. We show using an analysis of laser pump-power dependent photoluminescence measurements that this dramatic improvement in the photoluminescence intensity is due to a reduction in the trap-assisted recombination. However, we find it much less correlated with improved structural parameters determined by x-ray diffraction rocking curves, thereby pointing to the importance of eliminating point defects over extended defects. Overall, the success of rapid thermal annealing in improving the luminescent properties of low growth temperature PbSe is a step toward the integration of PbSe infrared optoelectronics in low thermal budget, back end of line compatible fabrication processes.more » « less
-
Abstract We report the synthesis of a soluble precursor that transforms into crystalline SnSe at 200 °C. This transformation temperature is significantly lower than the 270–350 °C range of previously reported tin selenide precursors. This precursor is synthesized by reacting tin with dimethyl diselenide and we identify the precursor as tin(IV) methylselenolate using a combination of mass spectrometry, Raman spectroscopy, and nuclear magnetic resonance spectroscopy. We then chemically treat PbSe colloidal nanocrystals with this precursor and subject them to mild annealing. We characterize the chemical and structural changes during this processing using infrared spectroscopy, aberration‐corrected scanning transmission electron microscopy, and X‐ray photoelectron spectroscopy. These characterization studies indicate the successful formation of a SnSe‐like material that fills the interstitial space between the PbSe nanocrystal cores. We find that the electrical conductivity of these nanocrystal films is comparable to other excellent treatments used to improve charge transport. This excellent charge transport demonstrates the utility of tin(IV) methylselenolate as a conductive “glue” between nanocrystals.more » « less
-
PbSe is a narrow bandgap IV–VI compound semiconductor with application in mid-wave infrared optoelectronics, thermoelectrics, and quantum devices. Alkaline-earth or rare-earth elements such as Sr and Eu can substitute Pb to widen the bandgap of PbSe in heterostructure devices, but they come with challenges such as deteriorating optical and electronic properties, even in dilute concentrations due to their dissimilar atomic nature. We substitute Pb instead with column IV Ge and assess the potential of rocksalt phase PbGeSe as a wider bandgap semiconductor in thin films grown by molecular beam epitaxy on GaAs substrates. Low sticking of GeSe adatoms requires synthesis temperatures below 260 °C to incorporate Ge, but this yields poor structural and compositional uniformity as determined by x-ray diffraction. Consequently, as-grown films in the range Pb0.94Ge0.06Se–Pb0.83Ge0.17Se (6%–17% Ge) show much less bandgap widening in photoluminescence than prior work on bulk crystals using absorption. We observe that post-growth rapid thermal annealing at temperatures of 375–450 °C improves the crystal quality and recovers bandgap widening. Rapid interdiffusion of Ge during annealing, however, remains a challenge in harnessing such PbGeSe materials for compositionally sharp heterostructures. Annealed 17% Ge films emit light at 3–3.1 μm with a minimal shift in wavelength vs temperature. These samples are wider in bandgap than PbSe films by 55 meV at room temperature, and the widening increases to 160 meV at 80 K, thanks to sharply different dependence of bandgap on temperature in PbSe vs PbGeSe.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1039/c8cc03869d
