Fast diffusing Li isotopes provide important insights into the “recent” transient events or processes for both modern and ancient times, but questions remain concerning the large Li isotopic variations of mantle peridotites, which greatly hampers their usage as a geochemical tracer. This study investigates in situ Li content and isotopic profiles of the constituent minerals of abyssal peridotites from the Gakkel Ridge and Southwest Indian Ridge. The complicated and large variations of Li isotopic profiles in Clinopyroxene (Cpx) and Orthopyroxene (Opx) indicate Li isotopic disequilibrium at millimeter scale. The negative correlations of a wide range of Li contents (0.5 to 6.5 ppm) and δ7Li values (−10 to +20‰) of olivine, Opx and Cpx grains/relicts, trace element zoning of Cpx, the occurrence of plagioclase, olivine serpentinization along cracks, together with numerical modeling demonstrate the observed Li characteristics to be a manifestation of high‐temperature mineral‐melt Li diffusion during melt impregnation overprinted by low‐temperature mineral‐fluid Li diffusion during dissolution and serpentinization. The preservation of the Li isotopic diffusion profiles requires rapid cooling of 0.3–5°C/year after final‐stage melt impregnation at the Moho boundary, which is consistent with the low temperature at very slow spreadin g ridges caused by conductive cooling. Compared with the well‐studied melt‐rock interaction process, our study indicates that low‐temperature fluid‐rock interaction can induce Li diffusion even in the visibly unaltered mineral relicts of partially altered rocks.
- NSF-PAR ID:
- 10192866
- Date Published:
- Journal Name:
- The American mineralogist
- ISSN:
- 0003-004X
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
more » « less
Abstract -
more » « less
Abstract Amphibole is a common hydrous mineral in mantle rocks. To better understand processes leading to the formation of amphibole‐bearing peridotites and pyroxenites in the lithospheric mantle, we conducted experiments by juxtaposing a lherzolite against hydrous basaltic melts in Au‐Pd capsules. Two melts were examined, a basaltic andesite and a basalt, each containing 4 wt% of water. The experiments were run at 1200°C and 1 GPa for 3 or 12 h, and then cooled to 880°C and 0.8 GPa over 49 h. The reaction at 1200°C produced a melt‐bearing orthopyroxenite‐dunite sequence. Crystallization of the partially reacted melts during cooling lead to the formation of an amphibole‐bearing gabbronorite‐orthopyroxenite‐peridotite sequence. Orthopyroxene in the peridotite and orthopyroxenite has a poikilitic texture enclosing olivines and spinels. Amphibole in the peridotite occurs interstitial to olivine, orthopyroxene, clinopyroxene, and spinel. Comparisons of texture and mineral compositions in the experimental products with those from field observations allow a better understanding of hydrous melt‐rock reaction in the lithospheric mantle. Amphibole‐bearing pyroxenite veins (or dikes) can be formed in the lithospheric mantle or at the crust‐mantle boundary by interaction between hydrous melt and peridotite and subsequent crystallization. Hornblendite or amphibole gabbronorite can be formed in the veins when the flux of hydrous melt is high. Differences in reacting melt and peridotite compositions are responsible for the variation in amphibole composition in mantle xenoliths from different tectonic settings. The extent of melt‐rock reaction is a factor that control amphibole composition across the amphibole‐bearing vein and the host peridotite.
-
more » « less
Abstract Many lines of evidence from high P–T experiments, thermodynamic models, and natural observations suggest that slab-derived aqueous fluids, which flux mantle wedges contain variable amounts of dissolved carbon. However, constraints on the effects of H2O–CO2 fluids on mantle melting, particularly at mantle wedge P–T conditions, are limited. Here, we present new piston cylinder experiments on fertile and depleted peridotite compositions with 3.5 wt.% H2O and XCO2 [= molar CO2 / (CO2 + H2O)] of 0.04–0.17. Experiments were performed at 2–3 GPa and 1350°C to assess how temperature, peridotite fertility, and XCO2 of slab-derived fluid affects partial melting in mantle wedges. All experiments produce olivine + orthopyroxene +7 to 41 wt.% partial melt. Our new data, along with previous lower temperature data, show that as mantle wedge temperature increases, primary melts become richer in SiO2, FeO*, and MgO and poorer CaO, Al2O3, and alkalis when influenced by H2O–CO2 fluids. At constant P–T and bulk H2O content, the extent of melting in the mantle wedge is largely controlled by peridotite fertility and XCO2 of slab-fluid. High XCO2 depleted compositions generate ~7 wt.% melt, whereas, at identical P–T, low XCO2 fertile compositions generate ~30 to 40 wt.% melt. Additionally, peridotite fertility and XCO2 have significant effects on peridotite partial melt compositions. At a constant P–T–XCO2, fertile peridotites generate melts richer in CaO and Al2O3 and poorer in SiO2, MgO + FeO, and alkalis. Similar to previous experimental studies, at a constant P–T fertility condition, as XCO2 increases, SiO2 and CaO of melts systematically decrease and increase, respectively. Such distinctive effects of oxidized form of dissolved carbon on peridotite partial melt compositions are not observed if the carbon-bearing fluid is reduced, such as CH4-bearing. Considering the large effect of XCO2 on melt SiO2 and CaO concentrations and the relatively oxidized nature of arc magmas, we compare the SiO2/CaO of our experimental melts and melts from previous peridotite + H2O ± CO2 studies to the SiO2/CaO systematics of primitive arc basalts and ultra-calcic, silica-undersaturated arc melt inclusions. From this comparison, we demonstrate that across most P–T–fertility conditions predicted for mantle wedges, partial melts from bulk compositions with XCO2 ≥ 0.11 have lower SiO2/CaO than all primitive arc melts found globally, even when correcting for olivine fractionation, whereas partial melts from bulk compositions with XCO2 = 0.04 overlap the lower end of the SiO2/CaO field defined by natural data. These results suggest that the upper XCO2 limit of slab-fluids influencing primary arc magma formation is 0.04 < XCO2 < 0.11, and this upper limit is likely to apply globally. Lastly, we show that the anomalous SiO2/CaO and CaO/Al2O3 signatures observed in ultra-calcic arc melt inclusions can be reproduced by partial melting of either CO2-bearing hydrous fertile and depleted peridotites with 0 < XCO2 < 0.11 at 2–3 GPa, or from nominally CO2-free hydrous fertile peridotites at P > 3 GPa.
-
more » « less
Abstract Trace element concentrations in abyssal peridotite olivine provide insights into the formation and evolution of the oceanic lithosphere. We present olivine trace element compositions (Al, Ca, Ti, V, Cr, Mn, Co, Ni, Zn, Y, Yb) from abyssal peridotites to investigate partial melting, melt–rock interaction, and subsolidus cooling at mid-ocean ridges and intra-oceanic forearcs. We targeted 44 peridotites from fast (Hess Deep, East Pacific Rise) and ultraslow (Gakkel and Southwest Indian Ridges) spreading ridges and the Tonga trench, including 5 peridotites that contain melt veins. We found that the abundances of Ti, Mn, Co, and Zn increase, while Ni decreases in melt-veined samples relative to unveined samples, suggesting that these elements are useful tracers of melt infiltration. The abundances of Al, Ca, Cr, and V in olivine are temperature sensitive. Thermometers utilizing Al and Ca in olivine indicate temperatures of 650–1000 °C, with variations corresponding to the contrasting cooling rates the peridotites experienced in different tectonic environments. Finally, we demonstrate with a two-stage model that olivine Y and Yb abundances reflect both partial melting and subsolidus re-equilibration. Samples that record lower Al- and Ca-in-olivine temperatures experienced higher extents of diffusive Y and Yb loss during cooling. Altogether, we demonstrate that olivine trace elements document both high-temperature melting and melt–rock interaction events, as well as subsolidus cooling related to their exhumation and emplacement onto the seafloor. This makes them useful tools to study processes associated with seafloor spreading and mid-ocean ridge tectonics.
-
more » « less
Abstract We present phase‐equilibria experiments of a K‐bearing, depleted peridotite (Mg# 92) fluxed with a mixed CO2‐H2O fluid (0.5 wt.% CO2and 0.94 wt.% H2O in the bulk) to gain insight into the stability of volatile‐bearing partial melts versus volatile‐bearing mineral phases in a depleted peridotite system. Experiments were performed at 850–1150 °C and 2–4 GPa using a piston‐cylinder and a multianvil apparatus. Olivine, orthopyroxene, clinopyroxene, and spinel/garnet are present at all experimental conditions. Textural confirmation of partial melt is made at temperatures as low as 1000 °C at 2 GPa, 950 °C at 3 GPa, and 1000 °C at 4 GPa marking the onset of melting at 900–1000 °C at 2 GPa, 850–950 °C at 3 GPa, and 950–1000 °C at 3 GPa. Phlogopite and magnesite breakdown at 900–1000 °C at 2 GPa, 950–1000 °C at 3 GPa, and 1000–1050 °C at 4 GPa. Comparison with previously published experiments in depleted peridotite system with identical CO2‐H2O content introduced via a silicic melt show that introduction of CO2‐H2O as fluid lowers the temperature of phlogopite breakdown by 150–200 °C at 2–4 GPa and stabilizes partial melts at lower temperatures. Our study thus, shows that the volatile‐bearing phase present in the cratonic mantle is controlled by bulk composition and is affected by the process of volatile addition during craton formation in a subduction zone. In addition, volatile introduction via melt versus aqueous fluid, leads to different proportion of anhydrous phases such as olivine and orthopyroxene. Considering the agent of metasomatism is thus critical to evaluate how the bulk composition of depleted peridotite is modified, leading to potential stability of volatile‐bearing phases as the cause of anomalously low shear wave velocity in mantle domains such as mid lithospheric discontinuities beneath continents.
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.2138/am-2020-7435
